The isotopes259106,260106, and261106

In irradiations of²⁰⁷Pb and²⁰⁸Pb, respectively, with⁵⁴Cr theα-decay of the isotopes²⁵⁹106,²⁶⁰106, and²⁶¹106 could be observed for the first time. For²⁶⁰106 a spontaneous fission branch of (50 _?20 ⁺³⁰ )% was observed. The isotopes were identified by genetic relationships of α-decay after separation in-flight with the velocity filter SHIP and implantation into a position-sensitive silicon surface-barrier detector. The measured partial fission halflife of the doubly even isotope²⁶⁰106 of (7.2 _?2.7 ^+4.8 )ms exceeds the predicted values by at least a factor of 40. This result could be explained by the high shell corrections of the ground state mass, derived from the measured α-decay energies. The experimental results show evidence for an island of purely shell stabilized nuclei in the region of deformed isotopes beyond the actinides.     

Atomic short-range order in CuMn alloys

The establishment of atomic short-range order (SRO) has been investigated in CuMn alloys (5, 8,13,16,20 at. % Mn) by measurement of the electrical resistivity during isochronal and isothermal annealing. An increasing degree of SRO is accompanied by a reduction of resistivity; this effect increases with Mn concentration. For 8,13 and 16 at. % Mn SRO kinetics turn out to deviate significantly from single exponential behavior with a maximum at 13 at. % Mn, whereas at 5 and 20 at. % Mn SRO is adjusted in a single exponential process. For data analysis three methods are used: a sum of two and three exponentials as well as a log-normal spectrum of relaxation times. The strong interaction between second-nearest-neighbor atoms in CuMn seems to be essential for SRO kinetics but of minor importance for the value of SRO-induced resistivity change.     

The effect of elastic forces on interface delocalization transitions

Elastic interaction prevents complete wetting and surface induced disordering and leads to a first order phase transition. The discontinuity is small for magnets and large for segregating binary alloys.     

The contribution of fundamental frequency, amplitude envelope, and voicing duration cues to speechreading in normal-hearing subjects

The ability to combine speechreading (i.e., lipreading) with prosodic information extracted from the low-frequency regions of speech was evaluated with three normally hearing subjects. The subjects were tested in a connected discourse tracking procedure which measures the rate at which spoken text can be repeated back without any errors. Receptive conditions included speechreading alone (SA), speechreading plus amplitude envelope cues (AM), speechreading plus fundamental frequency cues (FM), and speechreading plus intensity-modulated fundamental frequency cues (AM + FM). In a second experiment, one subject was further tested in a speechreading plus voicing duration cue condition (DUR). Speechreading performance was best in the AM + FM condition (83.6 words per minute,) and worst in the SA condition (41.1 words per minute). Tracking levels in the AM, FM, and DUR conditions were 73.7, 73.6, and 65.4 words per minute, respectively. The average tracking rate obtained when subjects were allowed to listen to the talker's normal (unfiltered) speech (NS condition) was 108.3 words per minute. These results demonstrate that speechreaders can use information related to the rhythm, stress, and intonation patterns of speech to improve their speechreading performance.     

Experimental investigation of mode coupling in a multimode graded-index fiber caused by periodic microbends using computer-generated spatial filters

The results are described of an experimental investigation of mode coupling in a multimode graded-index fiber as a function of the periodic microbend amplitude. Computer-generated holograms were used as mode selecting spatial filters for measurements of the modal power distribution. The experimental data are in a good qualitative agreement with theoretical predictions. The results obtained may be helpful in the development of amplitude-type graded-index fiber sensors with high sensitivity.     

Ionic conductivity of the perovskites NaMgF3, KMgF3, KMgK3 and KZnF3 at high temperatures

We have carried out a study of the ionic conductivity of NaMgF₃, KMgF₃ and KZnF₃ up to temperatures close to the melting point. Our results, in contrast to previous reports in the literature, show no abnormal ionic conductivity at high temperatures. Care in interpretation of results is required because of surface electronic conduction.     

First integrals versus configurational invariants and a weak form of complete integrability

A confusion over the concept of first integrals, which has been created in a recent paper by Hall [13] is clarified. The clear distinction between first integrals and functions which are first integrals only on a specific, fixed hypersurface is discussed. Hall's terminology of configurational invariants is adopted for the latter case. The possible relevance of knowing configurational invariants for a Hamiltonian system is illustrated by results concerning a weak form of the theory on complete integrability.     

Structural behaviour of fibre metal laminates subjected to a low velocity impact

Structural impact tests were first presented to cover typical fibre metal laminates (FMLs) subjected a low velocity projectile impact,which produced the corresponding load-displacement traces and deformation/failure modes for the validation of numerical models.Finite element (FE) models were then developed to simulate the impact behaviour of FMLs tested.The aluminium (alloy grade 2024-0) layer was modelled as an isotropic elasto-plastic material up to the on-set of post failure stage,followed by shear failu...