Pseudorapidity distributions of charged particles from Au + Au collisions at the maximum RHIC energy,square root[s(NN)] = 200 GeV

We present charged-particle multiplicities as a function of pseudorapidity and collision centrality for the 197Au+197Au reaction at square root[s(NN)] = 200 GeV. For the 5% most central events we obtain dN(ch)/deta/(eta = 0) = 625+/-55 and N(ch)/(-4.7< or =eta < or =4.7) = 4630 +/- 370, i.e., 14% and 21% increases, respectively, relative to square root[s(NN)] = 130 GeV collisions. Charged-particle production per pair of participant nucleons is found to increase from peripheral to central collisions around midrapidity. These results constrain current models of particle production at the highest RHIC energy.     

Observation of columnar microstructure in step-graded Si1-xGex/Si films using high-resolution X-ray microdiffraction

Columnar microstructure in step-graded Si(1-x)Ge(x)/Si(001) structures with low threading dislocation densities has been determined using high angular resolution (approximately 0.005 degrees ) x-ray microdiffraction. X-ray rocking curves of a 3-microm-thick strain-relaxed Si(0.83)Ge(0.17) film show many sharp peaks and can be simulated with a model having a set of Gaussians having narrow angular widths (0.013 degrees -0.02 degrees ) and local ranges of tilt angles varying from 0.05 degrees to 0.2 degrees. These peaks correspond to individual tilted rectangular columnar micrograins having similar (001) lattice spacings and average areas of 0.8 to 2.0 microm(2).     

Interference of circularly polarized light: contrast and application in fabrication of three-dimensional periodic microstructures

The contrast of interference pattern formed by two circularly polarized waves and by a linearly polarized wave and a circularly polarized one is discussed. The results are compared with that by two linear beams. It shows that the use of circular light in holographic fabrication of three-dimensional periodic microstructures may remove the necessity of beam ratio and polarization optimization needed in the interference of three linear noncoplanar beams and improve the uniform contrast of resultant pattern simultaneously.     

CsI(Tl)晶体中反冲Cs和I核Quenching?Factor的测量

许多实验对用CsI(Tl)闪烁晶体作为探测器来寻找和探测暗物质的可行性进行了研究.本工作利用8MeV单能中子轰击CsI(Tl)晶体探测器来研究Cs核和I核的QuenchingFactor.在数据处理中,运用脉冲形状甄别(PSD)方法来分辨反冲核信号和本底信号.实验结果表明,在7keV到132keV的能区中,Quench ingFactor随着反冲核能量的减少而增加.在探测暗物质的实验中,这一性质对于CsI(Tl)晶体探测器获得较低的能量阈值是很有利的.     

硅桥红外辐射单元温度的显微拉曼测定

本文采用显微拉曼光谱实验的方法对红外目标模拟器中的重掺杂Si电阻微桥单元进行了绝对温度的测量 ,并根据斯托克斯与反斯托克斯强度与温度关系以及Raman峰位移动与温度依赖关系两种方法确定温度 ,保证了所测温度的可靠性。针对Si桥建立相应的Raman模型 ,选择合适的物理参数 ,最终得到了反映Si桥工作特性的电流 -温度关系。此外 ,通过对Si桥的空间分辨的测量实验 ,得到了Si桥上的温度分布状况 ,对了解其电阻、热导及氧化等特性十分有用。所有结果表明该方法是器件优化的有效途径。     

Creation of a donor-acceptor pair for studying intraprotein electron transfer with the participation of amino-acid derivatives of fullerene C60

Efficient quenching of eosin phosphorescence by amino-acid derivatives of fullerene (AADFs) such as C₆₀-alanine and C₆₀-glycine in aqueous solutions indicates the possibility of transferring electrons from eosin to fullerene upon collisions or in the exciplex state. To investigate electron transfer in the protein structure, we studied the process of incorporation of C₆₀-alanine and C₆₀-glycine into the heme pocket of myoglobin by controlling Förster quenching. The dissociation constant for the protein-AADF complex was estimated.     

The “Average” Work Function and Emission Area in the Fowler-Nordheim Equation

Derivation of the elementary Fowler-Nordheim equation is based on several strong physical assumptions (e.g. smooth flat surface and uniform work function across emitting surface, constant emission area and a uniform distribution of the applied field over it). A real emitter, however, definitely does not fulfill these assumptions. In spite of it the total emission current follows the FN equation and is frequently used for an estimation of the "average" work-function. The physical basis of this procedure and of the terms "average" work function and "emission area" are analyzed from the experimentalist's point of view. Thus some of the older - more or less intuitive - conclusions are substantiated.     

AFM study of gold nanowire array electrodeposited within anodic aluminum oxide template

Uniform gold nanowires were synthesized by electrodepositing the gold under a very low ac frequency in the pores of an anodic aluminum oxide (AAO) template. The surface of the Au/AAO composite is very even and appeared purplish red. Atomic force microscopy observation indicates that the template membranes we obtained have hexagonally close-packed nanochannels. The gold nanowire array is very orderly arranged after partially dissolving the aluminum oxide membrane. Gold nanowires were also characterized by transmission electron microscopy and the phase structure of the Au/AAO composite was proved by X-ray diffraction. Received: 19 April 2001 / Accepted: 28 April 2001 / Published online: 27 June 2001     

Fabrication of bamboo-shaped GaN nanorods

Bamboo-shaped GaN nanorods were formed through a simple sublimation method. They were characterized by means of X-ray powder diffraction (XRD), transmission electron microscopy (TEM), high-resolution transmission electron microscopy (HRTEM) and selected-area electron diffraction (SAED). The TEM image showed that the nanorods were bamboo-like. XRD, HRTEM and SAED patterns indicated that the nanorods were single-crystal wurtzite GaN. Received: 8 January 2001 / Accepted: 28 April 2001 / Published online: 20 December 2001     

Formation of hydrogenated amorphous carbon films from polymer pyrolysis

Free-standing and supported hydrogenated amorphous carbon films (a:C–H) were prepared upon pyrolysis of the polymer formed by ethanolamine (EA) and citric acid (CA), under an ambient atmosphere at 300 °C. EA facilitates the formation of the macroscopic films, while CA is essential for obtaining the a:C–H microstructure, which comprises a mixture of sp² and sp³ carbon. Received: 29 May 2001 / Accepted: 17 August 2001 / Published online: 20 December 2001