Investigation of surface structure and composition of in situ annealed Fe–Mn binary alloy samples using RHEED and electron spectroscopy

The formation of oxides at the surface of Fe–1.5%Mn and Fe–0.6%Mn binary alloys was investigated as a function of the conditions of the heat treatments. Both the influence of temperature and the atmosphere under which the experiments were performed were studied. The range of annealing temperatures was adjusted to 800°C. The atmosphere consisted of a mixture of N₂–5%H₂ and traces of water vapour, with different fixed dew points ranging from −10°C to −30°C. The state of the annealed surfaces was determined using in situ analytical devices attached to the annealing reactor in order to avoid surface contamination or the formation of native oxides after the experiments due to contact with air. The structure and composition of the surfaces were determined by reflection high-energy electron diffraction (RHEED) and electron spectroscopy (XPS, AES). Copyright © 2002 John Wiley & Sons, Ltd.     

Synthesis,characterization and a thermogravimetric study of copper,cobalt and tin mono- and bis-adducts with ethyleneurea,ethylenethiourea and propyleneurea

This paper describes the synthesis, characterization and a thermogravimetric (t.g.) study of 11 adducts of general formula MCl₂·nL (M = Cu, Co and Sn; n = 1 and 2 for Sn, and 2 for Cu and Co; L = ethyleneurea eu, ethylenethiourea etu, and propyleneurea pu). The i.r. results shows that the eu and pu adducts are coordinated through oxygen, whereas for etu nitrogen is the coordination site. The (C=O) or (C=S) trend is: Cu > Co > Sn. The t.g. curves show that the adducts release ligand molecules in a single mass loss step. As regards considering adducts with the same stoichiometry, the observed thermal stability trend is: etu > pu > eu.     

LC–MS Determination of Sterols in Olive Oil

Sterols in olive oils have been analyzed by liquid chromatography coupled to mass spectrometry with atmospheric-pressure chemical ionization in positive-ion mode. A simple procedure based on saponification and extraction of the compounds from olive oils was studied. Validation of the method included calibration and determination of recovery and repeatability was carried out. Good linearity was obtained up to 100 mg kg^?1 for all the sterols studied except β-sitosterol, for which linearity was obtained up to 2,000 mg kg^?1. Recovery ranged from 88 to 110%, detection limits from 0.9 to 3.1 mg kg^?1, and precision was good. The method has been successfully used for analysis of sterols in different types of oil. The predominant sterol was β-sitosterol; other minor components, for example sitostanol and cholesterol, were also detected. Total sterol content depended on the type of oil, and ranged from 687 to 2,479 mg kg^?1. Stigmasterol and the amount of erythrodiol plus uvaol can be used to distinguish between olive oil and seed oil.     

Comparison of the acidity of residual silanol groups in several liquid chromatography columns

The silanol acidity of Waters Resolve C18, Waters Resolve silica, Waters Symmetry C18, Waters Symmetry silica, Waters XTerra MS C18 and underivatized XTerra columns has been measured from the retention of LiNO3 with a methanol/water (60:40) mobile phase buffered to different pH values. The Li+ cation is retained by cationic exchange with the background cation of the mobile phase (Na+) through the ionized silanols. The number of active silanols increases in the order: XTerra MS C18 < Symmetry C18 < underivatized XTerra < Resolve C18 < Resolve silica approximately equal to Symmetry silica. XTerra MS C18 does not present any residual silanol acidity up to s(s)pH 10.0 (pH in 60% methanol) as measured by LiNO3. The underivatized XTerra packing and Symmetry C18 present active silanols only at s(s)pH values higher than 7.0. For the other three columns, two different types of silanols with different acidity (s(s)pKa values about 3.5-4.6 and 6.2-6.8, respectively) have been observed. Symmetry C18 shows evidence of the presence of active basic sites that retain NO3- by anionic exchange.     

Changes in the reactivity of the fluorescent reagents carbazole-9-carbonyl chloride and 9-carbazolylacetic acid in the presence of cyclodextrins

Carbazole-9-carbonyl chloride (C9CC) and 9-carbazolylacetic acid (9CAA) were selected as model fluorescent reagents. The effect of different chemically modified cyclodextrins (CDs) added to the aqueous solutions of these reagents was studied in water and in buffered aqueous solutions at pH 4.5 and 8.8. The CDs employed were 2-hydroxypropyl-β-cyclodextrin (HP-βCD), 2,3-di-O-methyl-β-cyclodextrin (DM-βCD) and 2,3,6-tri-O-methyl-β-cyclodextrin (TM-βCD). The inclusion of these reagents inside the cavities of the CDs was verified and this process can affect the derivatization reaction because CDs can modify the reactivity of the guest molecules. The basic conditions necessary for the derivatization reaction between C9CC and amines lead to the formation of carbazole anion through hydrolysis followed by decarboxylation. In the presence of CDs, the hydrolysis-decarboxylation of carbazole-9-carbonyl chloride is faster than in buffered aqueous homogeneous solutions. The behaviour observed for these reagents in aqueous solutions of CDs was compared to the one observed in basic ethanolic solutions. These changes are particularly noticeable in the case of 2,3-di-O-methyl-β-CD and 2-hydroxypropyl-β-CD. The characteristics of the fluorescent reagents are compared to carbazole and 9-methylcarbazole as model compounds. This paper was presented at XIIIth International Cyclodextrin Symposium. Torino, Italy, May 14–17, 2006.     

Monitoring multi-class pesticide residues in fresh fruits and vegetables by liquid chromatography with tandem mass spectrometry

A new analytical method was developed using liquid chromatography with tandem mass spectrometry for the routine analysis of 31 multi-class pesticide residues and applied to approximately 50 fresh fruit and vegetable samples (green bean, cucumber, pepper, tomato, eggplant, watermelon, melon and zucchini). Extraction of the pesticides with ethyl acetate was carried out. The optimal ionisation conditions were selected for each pesticide in the same run. The procedure was validated and the values of some merit figures, such as recovery, precision, linear range, detection limit and quantification limit for each pesticide were calculated together with its calculated expanded uncertainty (U). The average recoveries in cucumber obtained for each pesticide ranged between 74 and 105% at two different fortification levels (n = 10 each) that ranged between 9 and 250 ng g(-1) (depending on the pesticide). The uncertainty associated to the analytical method was lower than 23% for all compounds tested. The calculated limits of detection and quantitation were typically <1 ng g(-1) that were much lower than the maximum residue levels established by European legislation.     

Theoretical modeling of enzyme catalytic power: analysis of "cratic" and electrostatic factors in catechol O-methyltransferase

A comparative theoretical study of a bimolecular reaction in aqueous solution and catalyzed by the enzyme catechol O-methyltransferase (COMT) has been carried out by a combination of two hybrid QM/MM techniques: statistical simulation methods and internal energy minimizations. In contrast to previous studies by other workers, we have located and characterized transition structures for the reaction in the enzyme active site, in water and in a vacuum, and our potential of mean force calculations are based upon reaction coordinates obtained from features of the potential energy surfaces in the condensed media, not from the gas phase. The AM1/CHARMM calculated free energy of activation for the reaction of S-adenosyl methionine (SAM) with catecholate catalyzed by COMT is 15 kcal mol(-1) lower the AM1/TIP3P free-energy barrier for the reaction of the trimethylsulfonium cation with the catecholate anion in water at 300 K, in agreement with previous estimates. The thermodynamically preferred form of the reactants in the uncatalyzed model reaction in water is a solvent-separated ion pair (SSIP). Conversion of the SSIP into a contact ion pair, with a structure resembling that of the Michaelis complex (MC) for the reaction in the COMT active site, is unfavorable by 7 kcal mol(-1), largely due to reorganization of the solvent. We have considered alternative ways to estimate the so-called "cratic" free energy for bringing the reactant species together in the correct orientation for reaction but conclude that direct evaluation of the free energy of association by means of molecular dynamics simulation with a simple standard-state correction is probably the best approach. The latter correction allows for the fact that the size of the unit cell employed with the periodic boundary simulations does not correspond to the standard state concentration of 1 M. Consideration of MC-like species allows a helpful decomposition of the catalytic effect into preorganization and reorganization phases. In the preorganization phase, the substrates are brought together into the MC-like species, either in water or in the enzyme active site. In the reorganization phase, the roles of the enzymic and aqueous environments may be compared directly because reorganization of the substrate is about the same in both cases. Analysis of the electric field along the reaction coordinate demonstrates that in water the TS is destabilized with respect to the MC-like species because the polarity of the solute diminishes and consequently the reaction field is also decreased. In the enzyme, the electric field is mainly a permanent field and consequently there is only a small reorganization of the environment. Therefore, destabilization of the TS is lower than in solution, and the activation barrier is smaller.     

Limited flexibility of lactose detected from residual dipolar couplings using molecular dynamics simulations and steric alignment methods

The conformational flexibility of lactose in solution has been investigated by residual dipolar couplings (RDCs). One-bond carbon-proton and proton-proton coupling constants have been measured in two oriented media and interpreted in combination with molecular dynamics simulations (MD). Two different approaches, known as PALES (Zweckstetter et al., J. Am. Chem. Soc. 2000, 122, 3791-3792) and TRAMITE (Azurmendi et al., J. Am. Chem. Soc. 2002, 124, 2426-2427), have been used to determine the alignment tensor from a shape-induced alignment model with the oriented medium. The steric alignment of the structures from several MD trajectories has provided ensemble averaged RDCs that have been compared with the experimental ones. The obtained results reveal the almost exclusive presence of a major low energy region defined as syn-phi/syn-psi (> 97%), for which sampling occurs in a dynamic manner. This result satisfactorily agrees with that determined by standard NOE-based methods.     

Iron(III)-catalyzed Prins-type cyclization using homopropargylic alcohol: a method for the synthesis of 2-alkyl-4-halo-5,6-dihydro-2H-pyrans

[reaction: see text] A new Prins-type cyclization between homopropargylic alcohol and aldehydes in the presence of FeX(3) to obtain 2-alkyl-4-halo-5,6-dihydro-2H-pyrans in good yield is described. Osmium-catalyzed cis dihydroxylation provided direct access to trans-2-alkyl-3-hydroxy-tetrahydro-pyran-4-ones. Anhydrous ferric halides are also shown to be excellent catalysts for the standard Prins cyclization using homoallylic alcohol. Isolation of an intermediate acetal provides substantiation of a proposed mechanism.     

Temperature Dependence of the Solubility of Acetaminophen in Propylene Glycol + Ethanol Mixtures

The thermodynamic functions Gibbs energy, enthalpy and entropy of solution, mixing and solvation of acetaminophen in propylene glycol (PG) + ethanol (EtOH) cosolvent mixtures were evaluated from solubility data measured at several temperatures, using the van't Hoff and Gibbs equations. The solubility was greater at 50% m/m of PG at 20.0^C, while it was greater at 80% of PG at 40.0 ^C where m/m refers to mass percent. The solvation of this drug is appreciably greater in the mixtures than in the pure solvents. By means of an enthalpy–entropy compensation analysis, complex behavior was found for the solution. From 0 up to 20% of PG and from 60 up to 100% of PG the solution process is enthalpy driven, whereas from 20 up to 60% of PG it is entropy driven. These facts can be explained in terms of a decrease in the energy required for cavity formation in the solvent for mixtures containing 20–60% of PG.