Copper(I)-catalyzed S-arylation of thiols with activated aryl chlorides on water

Copper chloride-catalyzed S-arylation of arenethiols is effected with activated aryl chlorides in neat water by using ethylenediamine as the pair ligand/base. This convenient, environmentally more friendly procedure for the coupling of aryl chlorides allows the arylation between sterically demanding coupling partners.     

Design and synthesis of aromatic inhibitors of anthranilate synthase

Aromatic analogues of chorismate were synthesised as potential inhibitors of anthranilate synthase. Molecular modelling using GOLD2.1 showed that these analogues docked into the active site of Serratia marcescens anthranilate synthase in the same conformation as chorismate. Most compounds were found to be micromolar inhibitors of S. marcescens anthranilate synthase. The most potent analogue, 3-(1-carboxy-ethoxy)-4-hydroxybenzoate (K(I) 3 microM), included a lactyl ether side chain. This appears to be a good replacement for the enol-pyruvyl side chain of chorismate.     

Hydride generation atomic fluorescence spectrometric determination of As, Bi, Sb, Se(IV) and Te(IV) in aqua regia extracts from atmospheric particulate matter using multivariate optimization

A highly sensitive and simple method, based on hydride generation and atomic fluorescence detection, has been developed for the determination of As, Bi, Sb, Se(IV) and Te(IV) in aqua regia extracts from atmospheric particulate matter samples. Atmospheric particulates matter was collected on glass fiber filters using a medium volume sampler (PM1 particulate matter). Two-level factorial designs have been used to optimise the hydride generation atomic fluorescence spectrometry (HG-AFS) procedure. The effects of several parameters affecting the hydride generation efficiency (hydrochloric acid, sodium tetrahydroborate and potassium iodide concentrations and flow rates) have been evaluated using a Plackett-Burman experimental design. In addition, parameters affecting the hydride measurement (delay, analysis and memory times) have been also investigated. The significant parameters obtained (sodium tetrahydroborate concentration, sodium tetrahydroborate flow rate and analysis time for As; hydrochloric acid concentration and sodium tetrahydroborate flow rate for Se(IV); and sodium tetrahydroborate concentration and sodium tetrahydroborate flow rate for Te(IV)) have been optimized by using 2ⁿ + star central composite design. Hydrochloric acid concentration and sodium tetrahydroborate flow rate were the significant parameters obtained for Sb and Bi determination, respectively. Using a univariate approach these parameters were optimized. The accuracy of methods have been verified by using several certified reference materials: SRM 1648 (urban particulate matter) and SRM 1649a (urban dust). Detection limits in the range of 6 × 10⁻³ to 0.2 ng m⁻³ have been achieved. The developed methods were applied to several atmospheric particulate matter samples corresponding to A Coruña city (NW Spain).     

Influence of organic ligands on the stabilization of palladium nanoparticles

The synthesis of palladium nanoparticles is performed by hydrogenation of a precursor, Pd₂(dba)₃ (1) or [Pd(C₃H₅)Cl]₂ (2) in the presence of either a weakly coordinating ligand (hexadecylamine, HDA) or good ligands (polyphosphines). It is shown in the case of 1 that good ligands lead to stable spherical nanoparticles of small size (near 2 nm) whereas the protective effect of HDA depends on the amount of ligand added as a result of equilibria present at the surface of the particles as monitored by solution NMR spectroscopy. The decomposition of 2 being very fast, the particle growth cannot be controlled except in the case of the use of a large excess of HDA which leads to spongelike particles resulting from the agglomeration of initially obtained nanocrystallites.     

Multiresidue analysis of sulfonamides in meat by supramolecular solvent microextraction,liquid chromatography and fluorescence detection and method validation according to the 2002/657/EC decision

A multiresidue method was described for determining eight sulfonamides, SAs (sulfadiazine, sulfamerazine, sulfamethoxypyridazine, sulfachloropyridazine, sulfadoxine, sulfamethoxazole, sulfadimethoxine and sulfaquinoxaline) in animal muscle tissues (pork, chicken, turkey, lamb and beef) at concentrations below the maximum residue limit (100 μg kg⁻¹) set by the European Commission. The method was based on the microextraction of SAs in 300-mg muscle samples with 1 mL of a supramolecular solvent made up of reverse micelles of decanoic acid (DeA) and posterior determination of SAs in the extract by LC/fluorescence detection, after in situ derivatization with fluorescamine. Recoveries were quantitative (98–109%) and matrix-independent, no concentration of the extracts was required, the microextraction took about 30 min and several samples could be simultaneously treated. Formation of multiple hydrogen bonds between the carboxylic groups of the solvent and the target SAs (hydrogen donor and acceptor sum between 9 and 11) were considered as the major forces driving microextraction. The method was validated according to the European Union regulation 2002/657/EC. Analytical performance in terms of linearity, selectivity, trueness, precision, stability of SAs, decision limit and detection capability were determined. Quantitation limits for the different SAs ranged between 12 μg kg⁻¹ and 44 μg kg⁻¹, they being nearly independent of matrix composition. Repeatability and reproducibility, expressed as relative standard deviation, were in the ranges 1.8–3.6% and 3.3–6.1%. The results of the validation process proved that the method is suitable for determining sulfonamide residues in surveillance programs.     

Analysis of whole congener mixtures of polybromodiphenyl ethers by gas chromatography–mass spectrometry in both environmental and biological samples at femtogram levels

A sensitive and selective method for the determination of the whole congener distribution of polybromodiphenyl ethers in environmental and biological samples in one single instrumental run is described. The method is based on gas chromatography coupled to low-resolution mass spectrometry in negative ion chemical ionization mode. It allows determination of these compounds at concentration levels lower than 10⁻¹⁴ g. A programmed temperature vaporization injector has been used to ensure maximum compound transfer to the chromatographic column while maintaining low thermal degradation levels of the more brominated congeners. Selectivity was increased by modification of the MS source parameters for optimization of the abundance of the high mass fragment ions. Under optimized condition, good repeatability (1.7–9.1%) and reproducibility (4.1–20%), and low detection limits, ranging between 1.5 and 15 pg ml⁻¹, were obtained. These features afforded reliable quantification of these compounds in snow and human samples at the concentrations in which these compounds are found.     

Determination of penicillins in milk using LC‐UV,LC‐MS and LC‐MS/MS

The aim of this work is to establish a method for the simultaneous determination of eight penicillins in milk samples by LC‐UV, LC‐MS and LC‐MS/MS. The procedure involves a step for clean‐up and to preconcentrate the analytes by SPE and a subsequent chromatographic analysis. LC‐UV, LC‐MS and LC‐MS/MS have been used for the simultaneous quantification of penicillins in milk. The proposed methods have been validated according to the EU guideline and present LOQ below the maximum limits of residues (MRLs) established by the European Union for penicillins in milk. The developed methods were applied to different milk samples obtained from cows medicated with penicillins.     

Stir bar sorptive extraction for the analysis of short‐chain chlorinated paraffins in water

An optimised method using stir bar sorptive extraction (SBSE) and a thermal desorption‐GC‐electron capture detector (GC‐ECD) for the determination of short‐chain chlorinated paraffins from water samples was developed. Recoveries near to 100% were obtained by using 20 mm×0.5 mm (length×film thickness) PDMS commercial stir bars from 200 mL spiked water samples and 20% methanol addition with an extraction period of 24 h. Method sensitivity, linearity and precision were evaluated for surface water and wastewater spiked samples. A LOD of 0.03 and 0.04 μg/L was calculated for surface and wastewater, respectively. The precision of the method given as an RSD was below 20% for both matrices. The developed method was applied for the analysis of two real samples from a contaminated river and a wastewater treatment plant. Results were in accordance with those obtained using a previously developed method based on solid phase microextraction (SPME).     

Chemistry of the oxophosphinidene ligand. 2. Reactivity of the anionic complexes [MCp{P(O)R*}(CO)(2)](-) (M = Mo, W; R* = 2,4,6-C(6)H(2)(t)Bu(3)) toward electrophiles based on elements different from carbon

The anionic oxophosphinidene complexes (H-DBU)[MCp{P(O)R*}(CO)(2)] (M = Mo, W; R* = 2,4,6-C(6)H(2)(t)Bu(3); Cp = η(5)-C(5)H(5), DBU = 1,8-diazabicyclo [5.4.0] undec-7-ene) displayed multisite reactivity when faced with different electrophilic reagents. The reactions with the group 14 organochloride compounds ER(4-x)Cl(x) (E = Si, Ge, Sn, Pb) led to either phosphide-like, oxophosphinidene-bridged derivatives [MCp{P(OE')R*}(CO)(2)] (E' = SiMe(3), SiPh(3), GePh(3), GeMe(2)Cl) or to terminal oxophosphinidene complexes [MCp{P(O)R*}(CO)(2)(E')] (E' = SnPh(3), SnPh(2)Cl, PbPh(3); Mo-Pb = 2.8845(4) ? for the MoPb compound). A particular situation was found in the reaction with SnMe(3)Cl, this giving a product existing in both tautomeric forms, with the phosphide-like complex [MCp{P(OSnMe(3))R*}(CO)(2)] prevailing at room temperature and the tautomer [MCp{P(O)R*}(CO)(2)(SnMe(3))] being the unique species present below 203 K in dichloromethane solution. The title anions also showed a multisite behavior when reacting with transition-metal based electrophiles. Thus, the reactions with the complexes [M'Cp(2)Cl(2)] (M' = Ti, Zr) gave phosphide-like derivatives [MCp{P(OM')R*}(CO)(2)] (M = Mo, M' = TiCp(2)Cl, ZrCp(2)Cl; M = W, M' = ZrCp(2)Cl), displaying a bridging κ(1),κ(1)-P,O- oxophosphinidene ligand connecting MCp(CO)(2) and M'Cp(2)Cl metal fragments (W-P = 2.233(1) ?, O-Zr = 2.016(4) ? for the WZr compound]. In contrast, the reactions with the complex [AuCl{P(p-tol)(3)}] gave the metal-metal bonded derivatives trans-[MCp{P(O)R*}(CO)(2){AuP(p-tol)(3)}] (M = Mo, W; Mo-Au = 2.7071(7) ?). From all the above results it was concluded that the terminal oxophosphinidene complexes are preferentially formed under conditions of orbital control, while charge-controlled reactions tend to give derivatives with the electrophilic fragment bound to the oxygen atom of the oxophosphinidene ligand (phosphide-like, oxophosphinidene-bridged derivatives).