High-spin particle states in 151Sm studied with the (α, 3He) reaction

High-spin states have been located in ¹⁵¹Sm by means of the (α, ³He) reaction with 40 MeV α-particles. The scattered particles were momentum analyzed in a QMG/2 magnetic spectrometer and recorded in a position sensitive detector. Several high-spin states were observed in the energy range below 1.7 MeV excitation. The previously unknown strongly populated levels at 867 and 1480 keV can most likely be interpreted as $\text{13}\text{2}{}^{\mathrm{+}}$ states. Both the deduced nuclear structure factors and the energy location of these levels are in excellent agreement with a simple Coriolis coupling calculation.     

Variable range hopping in doped crystalline semiconductors

The computer simulation is made to determine the temperature dependence of the hopping conductivity in the variable range hopping regime. It is found to obey the equation (1) rather than the Mott law. A simple analytical procedure is proposed which fits well the results of simulation.     

Studies of single neutron holes in the transitional nuclei N = 83–89:: The 150, 148Nd(d,t) and 150, 148, 146Nd(3He, α) pick-up reactions

The level structures of the ^{145, 147, 149}Nd nuclei up to about 5 MeV excitation energy have been investigated with the (³He, α) reaction at 24 MeV. Additional 17 MeV (d, t) data have been obtained for ^{147, 149}Nd. The angular distributions have been analyzed with standard DWBA calculations, and spectroscopic factors have been deduced. Two groups of states carrying h_{$\text{11}\text{2}$} single-particle strength may be associated with the $\text{9}\text{2}$^? [514] and $\text{11}\text{2}$^? [505] Nilsson orbitals. A considerable amount of high-l single-particle strength may be found in the continuum observed in the (³He, α) spectra above 3 MeV in all the nuclei.     

Enhanced stabilization and deposition of Pt nanocrystals on carbon by dumbbell-like polyethyleniminated poly(oxypropylene)diamine

Pseudo-dendritic polyethyleniminated poly(oxypropylene)diamine (D400(EI)(20)) was used as a stabilizer and promoter to prepare Pt nanoparticles in aqueous solution, which was then deposited on carbon surface followed by calcination. After being deposited on carbon surface, no Pt(0) could be detected in the solution phase. In all steps, the increasing molar ratio of the amino groups of D400(EI)(20) to H(2)PtCl(6) ([N]/[Pt]) drastically reduced the size and the polydispersity and kept a constant low value after [N]/[Pt] = 20. Under a [N]/[Pt] ratio of 20, the particle sizes obtained from transmission electron microscopy (TEM) were very small in solution (2.7-2.4 nm) and remained the same after being deposited on carbon surface (2.7-2.4 nm), and were only slightly increased to 3.6-3.0 nm after calcination. The stabilizing ability of D400(EI)(20) to Pt on carbon surface before and after calcination can be interpreted by the existence of binding energy between Pt and amine nitrogen. The X-ray diffraction (XRD) pattern together with the TEM image reveals that the obtained Pt nanoparticles exist in single-crystal form. The results of photoelectron spectroscopy (XPS) evidence that the metallic Pt(0) rather than the oxidized Pt is the predominant species in the Pt/C catalysts. The electrochemical active surface (EAS) area of the Pt/C catalyst is only slightly higher than that of the E-TEK Pt/C catalyst, but the utilization factor (93.4%) is remarkably higher than the latter (62.8%). The increasing time of thermal treatment increases the crystallinity of Pt(0) on carbon, accompanied by the increasing EAS areas, which corresponds to its enhanced electrocatalytic performance to methanol oxidation.     

On σ(·, W)-Holomorphic Functions and Theorems of Vitali-Type

The aim of this paper is to give some criterions for holomorphy of F-valued σ(F, W)-holomorphic functions which are bounded on bounded sets in a domain D of Fréchet spaces E (resp. ${\mathbb{C}^n}$ ) where ${W \subset F'}$ defines the topology of Fréchet space F. Base on these results we consider the problem on holomorphic extension of F-valued σ(F, W)-holomorphic functions from non-rare subsets of D and from subsets of D which determines uniform convergence in H(D). As an application of the above, some theorems of Vitali-type for a locally bounded sequence ${\{f_i\}_{i \in \mathbb{N}}}$ of Fréchet-valued holomorphic functions are also proved.     

Infrared Absorption Study of Some Cyclic Ureas,Cyclic Thioureas and Their N,N′-Dialkyl Derivatives

Abstract

In his communication on the detection limits for thermal emission spectroscopy of metallic species in flame media, Fassel (¹) attacks our previous statement that detection limits for Al, Be and Mo were available only for turbulent oxygen-supported hydrogen or acetylene flames. It should be borne in mind that he was referring to a preliminary communication (²) which naturally does not carry an extensive bibliography. It should also be noted that we were concerned, in context, with a comparison of the separated flame with conventional flames, not with highly unconventional flames such as those to which he refers. Whilst the point with which he takes issue was a very minor one, incorporated in our preliminary communication mainly as an “aside”, we firmly disagree with his observation. The flame he refers to (³) (⁴) is, in fact, a diluted oxy-acetylene flame which is supported by venting some air (and therefore nitrogen) to dilute the fuel-oxygen mixture. Fassel's communication (¹) erroneously refers to this as a 'premixed oxy-acetylene flame', whereas elsewhere (⁵) it is described more correctly as an oxygen-nitrogen-acetylene flame. The burner he long-pathlength carbonaceous flames (¹⁰). They also allow more sensitive molecular emission spectroscopy of sulphur in an air-hydrogen flame (¹¹), etc. We hope that this unfortunate correspondence will not distract attention from the main issue of our previous or previous preliminary communication on the separated nitrous oxide-acetylene flime.     

Water and oil signal assignment in low-moisture mozzarella as determined by time-domain NMR T2 relaxometry

A time-domain ¹H nuclear magnetic resonance relaxometry method was elaborated for the rapid microstructural characterization of mozzarella cheese. For this purpose, there is a strong need to know how the experimentally determined T₂ relaxation time distribution can be related to specific constituents in mozzarella. In this study, a detailed investigation is offered for fresh and aged low-moisture mozzarella cheese, often applied as a pizza cheese, by application of both a conventional Carr–Purcell–Meiboom–Gill (CPMG) sequence and a free-induction decay CPMG (FID-CPMG) sequence. The relaxation behavior was further elucidated by addition of deuterium oxide and by mild heat treatment of samples. The relaxation times of water protons in mozzarella were found to range from a few microseconds to some tens of milliseconds (in aged mozzarella) or to about hundred milliseconds (in fresh mozzarella). The upper limit of the T₂ distribution can even be extended to the seconds range upon releasing water protons from the mozzarella matrix using a mild heat treatment or upon addition of deuterated water. Both stimuli also provided evidence for the absorption of water into the cheese matrix. The potential release and uptake of water demonstrated that mozzarella acts as a very dynamic system during production and storage. The detected differences in the behavior of the water fraction between fresh and aged low-moisture mozzarella might be utilized to study the influence of either production and/or storage conditions on the cheese ripening process.     

Analysis of polycyclic aromatic hydrocarbons by liquid chromatography/tandem mass spectrometry using atmospheric pressure chemical ionization or electrospray ionization with tropylium post-column derivatization

Polycyclic aromatic hydrocarbons (PAHs) with four to six rings are potent carcinogens. This study analyzed ten of the sixteen US EPA priority PAHs using reversed-phase liquid chromatography/tandem mass spectrometry (LC/MS/MS) in selected reaction monitoring mode with two ionization sources: positive atmospheric pressure chemical ionization (APCI+) or positive elecrtrospray ionization (ESI+) with tropylium post-column derivatization. Several factors were investigated, including mobile phases, stationary phases of columns and chromatographic temperature, to determine how optimal separation and sensitivity might be achieved. Methanol used as an organic mobile phase provided better sensitivities for most PAHs than acetonitrile, although some PAHs co-eluted. Acidic buffers did not increase analyte signals. Use of Restek Pinnacle II PAH columns (250 x 4.6 mm or 250 x 2.1 mm, 5 microm) with water/acetonitrile gradient at 27 degrees C made possible a good separation of the ten analytes. [M]+. were the best precursor ions in both APCI and ESI, although fluoranthene could not be detected in ESI mode when tropylium post-column derivatization was performed. [M-28]+ and [M-52]+ were the major product ions of PAHs after collision-induced dissociation, a result of neutral losses of C(2)H(4) and (C(2)H(2))(2), respectively. Chromatographic separation for PAH isomers was crucial because the mass spectra were so similar that even MS/MS could not distinguish them from each other. The recoveries of sample preparations of PAHs spiked onto air-sampling filters ranged between 77.5 and 106% with relative standard deviations between 1.1 and 15.9%. This method was validated by analyzing NIST SRM 1649a (urban dust), producing results comparable with the certified PAH concentrations. The detection limits using APCI and ESI interfaces, defined as three times the noise levels, ranged between 0.23 and 0.83 ng and between 0.16 and 0.84 ng of on-column injection, respectively.