Using micelles for a new approach to fluorescent sensors for metal cations

A new approach based on self-assembly inside micelles has been individuated to prepare a system behaving as a water-operating selective fluorescent sensor for Cu2+ and Ni2+.     

"Oscillating" metallocene catalysts: what stops the oscillation?

The 150 MHz (13)C NMR microstructural analysis of polypropylene samples produced with two representative "oscillating" metallocene catalysts of largely different steric hindrance, namely [(2-(3,5-di-tert-butyl-4-methoxyphenyl)indenyl)(2)ZrP](+) and [(2-phenylindenyl)(2)ZrP](+) (P = polymeryl), and the implications on the origin of the stereocontrol are presented and discussed in detail. The original mechanistic proposal of an "oscillation" between a rac-like (isotactic-selective) and a meso-like (nonstereoselective) conformation cannot explain the observed polymer configuration. The isotactic-stereoblock nature of the polymers obtained with the former catalyst proves unambiguously that the active cation "oscillates" between the two enantiomorphous rac-like conformations at an average frequency that, even at high propene concentration, is only slightly lower than that of monomer insertion. The less-hindered [(2-phenylindenyl)(2)ZrP](+) gives instead a largely stereoirregular polypropylene, which is the logical consequence of a faster ligand rotation; however, depending on the use conditions (in particular, on the nature of the cocatalyst and the polarity of the solvent), the polymerization products may also contain appreciable amounts of a fairly isotactic fraction. The peculiar microstructure of this fraction, with isotactic blocks of the same relative configuration spanned by very short atactic ones, rules out the possibility that the latter are due to an active species in meso-like conformation and points rather to a conformationally "locked" rac-like species with restricted ring mobility. The hypothesis of a stereorigidity induced by the proximity to a counteranion, which would play the role of the interannular bridge in the rac-bis(indenyl) ansa-metallocenes, was tested by computer modeling on a [rac-(2-phenylindenyl)(2)ZrMe(C(3)H(6))][B(C(6)F(5))(4)] ion couple and found viable.     

Nucleophilic trifluoromethylation of organic substrates using (trifluoromethyl)trimethylsilane in the presence of a fluoride anion II. A convenient route to aryltrifluoromethyl-sulfides, -sulfoxides and -sulfones

Aryltrifluoromethyl-sulfides, -sulfoxides and -sulfones can be prepared by trifluoromethylation of the corresponding arylsulfenyl, -sulfinyl and -sulfonyl halides using (trifluoromethyl)trimethylsilane in the presence of fluoride sources, such as TASF [tris(dimethylamino)sulfonium difluorotrimethylsilicate].     

Novel deletion of the E3A ubiquitin protein ligase gene detected by multiplex ligation-dependent probe amplification in a patient with Angelman syndrome

Angelman syndrome (AS) is a severe neurobehavioural disorder caused by failure of expression of the maternal copy of the imprinted domain located on 15q11-q13. There are different mechanisms leading to AS: maternal microdeletion, uniparental disomy, defects in a putative imprinting centre, mutations of the E3 ubiquitin protein ligase (UBE3A) gene. However, some of suspected cases of AS are still scored negative to all the latter mutations. Recently, it has been shown that a proportion of negative cases bear large deletions overlapping one or more exons of the UBE3A gene. These deletions are difficult to detect by conventional gene-scanning methods due to the masking effect by the non-deleted allele. In this study, we have used for the first time multiplex ligation-dependent probe amplification (MLPA) and comparative multiplex dosage analysis (CMDA) to search for large deletions affecting the UBE3A gene. Using this approach, we identified a novel causative deletion involving exon 8 in an affected sibling. Based on our results, we propose the use of MLPA as a fast, accurate and inexpensive test to detect large deletions in the UBE3A gene in a small but significant percentage of AS patients.     

Development and validation of a high-performance liquid chromatography-tandem mass spectrometry method for the determination of the novel inhibitor of angiogenesis E-3810 in human plasma and its application in a clinical pharmacokinetic study

E-3810, 6-[[7-[(1-aminocyclopropyl)methoxy]-6-methoxy-4-quinolyl]oxy]-N-methyl-naphthalene-1-carboxamide, is a novel, potent, dual inhibitor of vascular endothelial growth factor and fibroblast growth factor receptors with antiangiogenic properties, now under early clinical evaluation as an anticancer agent. To investigate its clinical pharmacokinetics, a high-performance liquid chromatography-tandem mass spectrometry method was developed and validated to measure the drug in human plasma on the basis of simple protein precipitation with methanol after addition of deuterated E-3810 as internal standard. The method requires a small volume of sample (100 μl) and is rapid and selective, allowing good resolution of peaks in 5 min. It is sensitive, precise, and accurate, with overall precision, expressed as CV%, always ≤7.1%, accuracy in the range 92.7%-104.4%, and high recovery, close to 100%. The limit of detection is 0.01 ng/ml, and the lower limit of quantitation is 2.0 ng/ml. The assay was validated in the range from the lower limit of quantitation up to 500.0 ng/ml. This is the first method developed and validated for analyzing E-3810 in human plasma. The method has been successfully applied to study E-3810 pharmacokinetics in cancer patients with solid tumors who are receiving daily oral doses of the drug during the phase I trial.     

Microwave-assisted oxidation of silibinin: a simple and preparative method for the synthesis of improved radical scavengers

A new and preparative oxidation of silibinin has been developed to give access to two different silibinin derivatives known for their enhanced antioxidant properties. Conventional heating methods were compared with results obtained from microwave (MW) heating. The base-catalysed oxidation of silibinin under MW heating is a very efficient method for the preparation of 2,3-dehydrosilybin and a related silybin rearrangement product. This latter compound shows enhanced radical scavenging properties. Optimised conditions were used to prepare 2,3-dehydrosilybins A and B from optically pure silybins A and B. An efficient, preparative purification method was also developed to enable isolation of different products in high purity.     

Catalysis of the beta-elimination of HF from isomeric 2-fluoroethylpyridines and 1-methyl-2-fluoroethylpyridinium salts. Proton-activating factors and methyl-activating factors as a mechanistic test to distinguish between concerted E2 and E1cb irreversible mechanisms

Second-order rate constants, k(OH)(N), M(-)(1) s(-)(1), for the beta-elimination reactions of HF with 2-(2-fluoroethyl)pyridine (2), 3-(2-fluoroethyl)pyridine (3), and 4-(2-fluoroethyl)pyridine (4) in OH(-)/H(2)O, at 50 degrees C and mu = 1 M KCl, are = 0.646 x 10(-)(4) M(-)(1) s(-)(1), = 2.97 x 10(-)(6) M(-)(1) s(-)(1), and = 5.28 x 10(-)(4) M(-)(1) s(-)(1), respectively. When compared with the second-order rate constants for the same processes with the nitrogen-methylated substrates 1-methyl-2-(2-fluoroethyl)pyridinium iodide (5), 1-methyl-3-(2-fluoroethyl)pyridinium iodide (6), and 1-methyl-4-(2-fluoroethyl)pyridinium iodide (7), the methyl-activating factor (MethylAF) can be calculated from the ratio k(OH)(NCH)3/, and a value of 8.7 x 10(5) is obtained with substrates 5/2, a value of 1.6 x 10(3) with 6/3, and a value of 2.1 x 10(4) with 7/4. The high values of MethylAF are in agreement with an irreversible E1cb mechanism (A(N)D(E) + D(N)) for substrates 5 and 7 and with the high stability of the intermediate carbanion related to its enamine-type structure. In acetohydroxamate/acetohydroxamic acid buffers (pH 8.45-9.42) and acetate/acetic acid buffers (pH 4.13-5.13), the beta-elimination reactions of HF, with substrates 2 and 4, occur at NH(+), the substrates protonated at the nitrogen atom of the pyridine ring, even when the [NH(+)] is much lower than the [N], the unprotonated substrate, due to the high proton-activating factor (PAF) value observed: 3.6 x 10(5) for 2 and 6.5 x 10(4) for 4 with acetohydroxamate base. These high PAF values are indicative of an irreversible E1cb mechanism rather than a concerted E2 (A(N)D(E)D(N)) mechanism. Finally, the rate constant for carbanion formation from NH(+) with 2 is k(B)(NH)+ = 0.35 M(-)(1) s(-)(1), which is lower than when chlorine is the leaving group ( = 1.05 M(-)(1) s(-)(1); Alunni, S.; Busti, A. J. Chem. Soc., Perkin Trans. 2 2001, 778). This is direct experimental evidence that some lengthening of the carbon-leaving group bond can occur in the intermediate carbanion. This is a point of interest for interpreting a heavy-atom isotope effect.     

Aminolysis of glycal-derived allyl epoxides and activated aziridines. Effects of the absence of coordination processes on the regio- and stereoselectivity

The addition of primary and secondary aliphatic amines to glycal-derived allyl epoxides is completely 1,2-regio- and anti-stereoselective, whereas mixtures of the corresponding anti-1,2- [3-N-(substituted-amino) glycals] and anti-1,4-addition products (N-glycosyl amines) are obtained with N-(mesyl)-aziridines. In this way, structural moieties, otherwise difficult to synthesize, are obtained by means of a very simple protocol. The regio- and stereoselectivity observed with epoxides is the consequence of an isomerization process, whereas the result obtained with aziridines is explained by the absence of an effective substrate-nucleophile (amine) coordination.     

Development and validation of a capillary electrophoresis method for determination of enantiomeric purity and related substances of esomeprazole in raw material and pellets

A capillary electrophoresis method using CDs for quality control of esomeprazole (ESO) in terms of enantiomeric purity and related substances in raw material and pellets was developed. ESO is the S‐enantiomer of omeprazole (OMZ). Several parameters were evaluated, including type and concentration of buffer and CD, concentration of additives and electrolyte pH. Resolution between the enantiomers of OMZ obtained for each parameter tested was calculated and the presence of the main related substance such as OMZ sulfone was carefully monitored. The optimized system consisted of 100 mM Tris‐phosphate buffer pH 2.5 with 20 mM 2‐hydroxypropyl‐β‐CD, 1 mM sodium dithionite, temperature at 15°C, voltage at 28 kV, and UV detection at 301 nm. Once optimized, the electrophoretic system was validated according to ICH guidelines. The limits of detection and quantification for R‐OMZ were 0.6 μg/mL (0.06% w/w of ESO) and 2.0 μg/mL (0.2% w/w of ESO), respectively. A mean concentration of R‐OMZ <0.2% limit established by the United States Pharmacopeia (USP) was found in the raw material and six‐pellet samples of ESO. No other impurities were found in the samples under these conditions. Therefore, the developed method was found to be appropriate not only for enantiomeric quality control of ESO but also for the analysis of ESO and the main related substance in raw material and pharmaceutical formulations as well as for stability indicating studies.