On the dynamic electromechanical loading of dielectric elastomer membranes

Dielectric elastomer actuators (DEAs) have received considerable attention recently due to large voltage-induced strains, which can be over 100%. Previously, a large deformation quasi-static model that describes the out-of-plane deformations of clamped diaphragms was derived. The numerical model results compare well with quasi-static experimental results for the same configuration. With relevance to dynamic applications, the time-varying response of initially planar dielectric elastomer membranes configured for out-of-plane deformations has not been reported until now. In this paper, an experimental investigation and analysis of the dynamic response of a dielectric elastomer membrane is reported. The experiments were conducted with prestretched DEAs fabricated from 0.5 mm thick polyacrylate films and carbon grease electrodes. The experiments covered the electromechanical spectrum by investigating membrane response due to (i) a time-varying voltage input and (ii) a time-varying pressure input, resulting in a combined electromechanical loading state in both cases. For the time-varying voltage experiments, the membrane had a prestretch of three and was passively inflated to various predetermined states, and then actuated. The pole strains incurred during the inflation were as high as 25.6%, corresponding to slightly less than a hemispherical state. On actuation, the membrane would inflate further, causing a maximum additional strain of 9.5%. For the time-varying pressure experiments, the prestretched membrane was inflated and deflated mechanically while a constant voltage was applied. The membrane was cycled between various predetermined inflation states, the largest of which was nearly hemispherical, which with an applied constant voltage of 3 kV corresponded to a maximum polar strain of 28%. The results from these experiments reveal that the response of the membrane is a departure from the classical dynamic response of continuum membrane structures. The dynamic response of the membrane is that of a damped system with specific deformation shapes reminiscent of the classical membrane mode shapes but without same-phase oscillation, that is to say all parts of the system do not pass through the equilibrium configuration at the same time. Of particular interest is the ability to excite these deformations through a varying electrical load at constant mechanical pressure.     

An Experimental Investigation into the Acoustic Characteristics of Fluid-filled Porous Structures—A Simplified Model of the Human Skull Cancellous Structure

In nature, shape and structure evolve from the struggle for better performance. Often, biological structures combine multiple beneficial properties, making research into mimicking them very complex. Presented here is a summary of observations from a series of experiments performed on a material that closely resembles the human skull bone’s cancellous structure under acoustic loads. Transmission loss through flat and curved open-cell polyurethane foam samples is observed using air and water as the two interstitial fluids. Reduction in strength and stiffness caused by porosity can be recovered partially by filling the interstitial pores with a fluid. The test findings demonstrate the influence of the interstitial fluid on the mechanical characteristics of a porous structure in a quantitative manner. It is also demonstrated that the transmission loss does not depend only on the mass per unit area of the structure as predicted by acoustic mass law. Current tests also demonstrate that the transmission loss is more sensitive to the interstitial fluid than the shape and support conditions of the structures. Test observations thus support the concepts of “moisture-sensitivity of biological design” and the “law of hierarchy in natural design”.     

Growth of Sb-Bi gradient single crystals

The growth conditions and structural quality of Sb-Bi gradient single crystals with Bi content from 2 to 18 at %, grown by the Czochralski method with solid phase feed, are investigated. Bi distribution in the crystals along their pulling direction are studied by electron probe microanalysis and the change in the interplanar spacing is analyzed by double-crystal X-ray diffraction. It is established that the pulling rate and feed mass affect the Bi distribution in Sb-Bi single crystals.     

Symmetry specified enumeration of substituted derivatives: an easy solution to the complex problem

Several sophisticated methods to solution of symmetry specified enumeration problems are available in the modern literature. In this paper we propose a simple technique that allows one to manually compute the exact numbers of fixed-symmetry derivatives for a given structure either with inclusion or ignoring the substitution patterns. The basic idea of the method suggested consists in the derivation of Pólya-like cycle indices for the automorphism groups of specially constructed orbit partition graphs; the expansion of these indices and subsequent simple calculations result in the desired numbers of substituted derivatives with achiral substituents. Limitations of the new technique (and a method suggested earlier) depend on the relevance of the orbit partitions for particular subgroups of the point symmetry group. For illustration purposes, the results obtained for the prismane (D _3h ) and adamantane (T _d ) structures are discussed. In the former case the numbers of substituted derivatives can be found for all subgroups of the D _3h group, whereas in the latter case these numbers can be determined for eight out of eleven subgroups of the T _d point symmetry group. This work is based on the text of the lecture presented by the authors at the 5th All-Russia Conference on Molecular Modeling (Moscow, April 2007). The paper deals with the methodology and detailed treatment of applied aspects related to solution of enumeration problems for substituted derivatives with prescribed symmetry groups. Unlike the known methods of symmetry specified enumeration, the technique suggested is simple enough and may be regarded as generalization of the Pólya methodology, which is widely used by chemists. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 2, pp. 227–245, February, 2008.     

Rearrangements during nitrosodecarboxylation of isomeric dibromohydroxybenzoic acids

The reaction of 3,5-dibromo-4-hydroxybenzoic acid, its sodium salt, and also sodium 3,5-dibromo-2-hydroxybenzoate with NaNO₂ in a glacial acetic acid at room temperature led to the formation of a mixture of dibromonitrophenol resulting from nitrosodecarboxylation accompanied by a rearrangement processes and followed by oxidation of the arising nitrosophenols.     

Similar quartz crystallographic textures in rocks of continental earth’s crust (by neutron diffraction data): II. Quartz textures in monophase rocks

The types of quartz textures found in a large collection of multiphase rocks from different regions of the earth are analyzed. Crystallographic textures of granulite, amphibolite, slate, and gneiss samples are measured, classified, and compared with the similar textures of monomineral rocks.     

New sources of “active” halogen bis(dialkylamide)hydrogen dibromobromates, efficient reagents for destruction of ecotoxicants

Bis(dialkylamide)hydrogen dibromobromates were synthesized and their reactivity was investigated in decomposition of diethylphosphonic, diethylphosphoric, and 4-toluenesulfonic acids 4-nitrophenyl esters. The nucleophilic reactivity of a typical α-nucleophile, hypobromite ion, is independent of the source of the active bromine. The cetyltrimethylammonium dibromobromate is a unique reagent for destruction of ecotoxicants. In weakly alkaline media the half-life of 4-nitrophenyl diethylphosphonate did not exceed 6 s at [BrO^?] 0.02 mol l^?1, and the apparent reaction rate compared to water increased ～40-fold. The main factor governing the micellar effects of surfactants is concentrating the substrate in the micellar pseudophase.     

Rare-earth metal 8-hydroxyquinolinate complexes as materials for organic light-emitting diodes

Rare-earth metal 8-hydroxyquinolinates (q) were studied as emission layers for organic light-emitting diodes. Compounds Dyq₃, Tbq₃, and Smq₃ possess weak electroluminescence due to the emission of the ligand, and the electroluminescence of Hoq₃, Tmq₃, and Ybq₃ is due to electronic transitions of the lanthanide ion. The best electroluminescence characteristics were demonstrated by Scq₃ and Yq₃. The power efficiency of the organic light emitter based on ITO/TPD/Scq₃/Yb (ITO is tin-alloyed indium oxide, TPD is N,N′-bis(3-methylphenyl)-N,N′-diphenylbenzidine) is 2.6 lm W⁻¹ at a luminance of the device of 300 cd m⁻².