Ozonolysis of a Series of Methylated Alkenes: Reaction Rate Coefficients and Gas‐Phase Products

The gas‐phase ozonolysis of three methylated alkenes, i.e., trans‐2,2‐dimethyl‐3‐hexene (22dM3H), trans‐2,5‐dimethyl‐3‐hexene (25dM3H), and 4‐methyl‐1‐pentene (4M1P), has been investigated in the presence of sufficient hydroxyl radical scavenger in a laminar flow reactor at ambient temperature (296 ± 2 K) and P = 1 atm of dry air (RH ≤ 5%). Ozone levels in the reactor were monitored by an automatic analyzer. Alkene and gas‐phase product concentrations were determined via online sampling either on three‐bed adsorbent cartridges followed by thermodesorption and GC/FID‐MS analysis or on 2,4‐dinitrophenylhydrazine (DNPH) cartridges for subsequent HPLC/UV analysis. Reaction rate coefficients of (3.38 ± 0.12) × 10^?17 for 22dM3H and (2.71 ± 0.26) × 10^?17 for 25dM3H, both in cm³ molecule^?1 s^?1 units, have been obtained under pseudo–first‐order conditions. Primary carbonyl products have been identified for the three investigated alkenes, and branching ratios are reported. In the case of 4M1P ozonolysis, the yield of a Criegee intermediate was indirectly determined. Kinetics and product study results are compared to those of literature when available. This work represents the first investigation of reaction products in the ozonolysis of 22dM3H, 25dM3H, and 4M1P in a flow reactor.     

DFT mechanistic study of the H2‐assisted chain transfer copolymerization of propylene and p‐methylstyrene catalyzed by zirconocene complex

DFT computations have been performed to investigate the mechanism of H₂‐assisted chain transfer strategy to functionalize polypropylene via Zr‐catalyzed copolymerization of propylene and p‐methylstyrene (pMS). The study unveils the following: (i) propylene prefers 1,2‐insertion over 2,1‐insertion both kinetically and thermodynamically, explaining the observed 1,2‐insertion regioselectivity for propylene insertion. (ii) The 2,1‐inserion of pMS is kinetically less favorable but thermodynamically more favorable than 1,2‐insertion. The observation of 2,1‐insertion pMS at the end of polymer chain is due to thermodynamic control and that the barrier difference between the two insertion modes become smaller as the chain length becomes longer. (iii) The pMS insertion results in much higher barriers for subsequent either propylene or pMS insertion, which causes deactivation of the catalytic system. (iv) Small H₂ can react with the deactivated [Zr]?pMS?PP_n facilely, which displace functionalized pMS?PP_n chain and regenerate [Zr]? H active catalyst to continue copolymerization. The effects of counterions are also discussed. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 576–585     

The Influence of Silicon Dioxide on the Stability of the Phase Composition and Mechanical Properties of Alumina-Toughened Zirconia-Based Ceramics

Technical Physics - The influence of SiO2 impurity (with a concentration varying from 0 to 10 mol %) on the stability of tetragonal ZrO2 (t-ZrO2) and on a set of micro- and macromechanical...     

Conformal Mappings of Riemannian Spaces onto Ricci Symmetric Spaces

Mathematical Notes -