Photograft Copolymerization of Methyl Methacrylate on Wool Using Ce4+ -Oxalic Acid Redox Initiator in a Limited Aqueous System

Abstract

Photograft copolymerization of methyl methacrylate on reduced wool (reduction done by treatment with thioglycollic acid, TGA) was studied at nearly 30°C using a Ce⁴⁺ -oxalic acid redox initiator system in a limited aqueous system (2.7 mL water for 0.15 g wool). Reduction of wool for 16 h with 15% TGA solution produced optimum grafting effects. Percent grafting and grafting efficiency under different sets of conditions were studied and compared, and the mechanism of grafting discussed. Generation of grafting sites (radical centers) on reduced wool was more effective in the presence of light than in the dark. Percent grafting of 250–350% and grafting efficiency of 65-80% over a conversion range of 60–90% in 3–5 h were easily obtained.     

Green Enzymatic Synthesis of L-Ascorbyl Fatty Acid Ester: An Antioxidant

In green chemistry, biocatalysis using microwaves is a very attractive tool for various regioselective syntheses. L-Ascorbyl fatty acid esters were synthesized by an immobilized lipase from Bulkholderia multivorans using microwaves, with a dynamically enhanced rate of reaction and appreciable yield of around 80%. Microwave radiation had no effect on enzymic inactivation, however, synergism between microwaves and biocatalyst was observed.     

Sequential 1,3-Dipolar Cycloadditions in the Synthesis of Novel Tri-spiro Cyclohexanones and Piperidin-4-ones

The sequential 1,3-dipolar cycloadditions of azomethine ylide and nitrile oxide to a series of 2,6-bis[(E)-arylmethylidene]cyclohexanones and 1-methyl-3,5-bis[(E)-arylmethylidene]tetrahydro-4(1H)-pyridinones afforded novel tri-spiro heterocycles comprising isoxazoline, pyrrolidine and acenaphthylen-1(2H)-one rings in good yields and stereoselectivity.     

Paramagnetic ruthenium(III) cyclometallated complex. Synthesis, spectroscopic studies and electron-transfer properties

The reaction of Ru^II(PPh₃)₃X₂ (X = Cl, Br) with o-(OH)C₆H₄C(H)=N-CH₂C₆H₅ (HL) under aerobic conditions affords Ru^II(L)₂(PPh₃)₂, 1, in which both the ligands (L) are bound to the metal center at the phenolic oxygen (deprotonated) and azomethine nitrogen and Ru^III(L¹)(L²)(PPh₃), 2, in which one L is in bidentate N,O form like in complex 1 and the other ligand is in tridentate C,N,O mode where cyclometallation takes place from the ortho carbon atom (deprotonated) of the benzyl amine fragment. The complex 1 is unstable in solution, and undergoes spontaneous oxidative internal transformation to complex 2. In solid state upon heating, 1 initially converts to 2 quantitatively and further heating causes the rearrangement of complex 2 to the stable RuL₃ complex. The presence of symmetry in the diamagnetic, electrically neutral complex 1 is confirmed by ¹H and ³¹P NMR spectroscopy. It exhibits an Ru^II → L, MLCT transition at 460 nm and a ligand based transition at 340 nm. The complex 1 undergoes quasi-reversible ruthenium(II)—ruthenium(III) oxidation at 1.27V vs. SCE. The one-electron paramagnetic cyclometallated ruthenium(III) complex 2 displays an L → Ru^III, LMCT transition at 658 nm. The ligand based transition is observed to take place at 343 nm. The complex 2 shows reversible ruthenium(III)—ruthenium(IV) oxidation at 0.875V and irreversible ruthenium(III)—ruthenium(II) reduction at −0.68V vs. SCE. It exhibits a rhombic EPR spectrum, that has been analysed to furnish values of axial (6560 cm⁻¹) and rhombic (5630 cm⁻¹) distortion parameters as well as the energies of the two expected ligand field transitions (3877 cm⁻¹ and 9540 cm⁻¹) within the t₂ shell. One of the transitions has been experimentally observed in the predicted region (9090 cm⁻¹). The first order rate constants at different temperatures and the activation parameter ΔH^#/ΔS^# values of the conversion process of 1 → 2 have been determined spectrophotometrically in chloroform solution.     

Quinalizarin anchored on Amberlite XAD-2. A new matrix for solid-phase extraction of metal ions for flame atomic absorption spectrometric determination

Amberlite XAD-2 has been functionalized by coupling it to quinalizarin [1,2,5,8-tetrahydroxyanthraquinone] by means of an -N = N- spacer. Elemental analysis, thermogravimetric analysis, and infrared spectra were used to characterize the resulting new polymer matrix. The matrix has been used to preconcentrate Cu(II), Cd(II), Co(II), Pb(II), Zn(II), and Mn(II) before their determination by flame atomic absorption spectrometry (FAAS). UO2(II) has been preconcentrated for fluorimetric determination. The optimum pH values for maximum adsorption of the metals are between 5.0 and 7.0. All these metal ions are desorbed (recovery 91-99%) with 4 mol L(-1) HNO3. The adsorptive capacity of the resin was found to be in the range 0.94-5.28 mg metal g(-1) resin and loading half-life (t1/2) between 5.3 and 15.0 min. The effects of NaF, NaCl, NaNO3, Na2SO4, Na3PO4, Ca(II), and Mg(II) on the adsorption of these metal ions (0.2 microg mL(-1)) are reported. The lower limits of detection for these metal ions are between 1 and 15.0 microg L(-1). After enrichment on this matrix flame AAS has been used to determine these metal ions (except the uranyl ion) in river water samples (RSD < or = 6.5%); fluorimetry was used to determine uranyl ion in well water samples (RSD < or = 6.3%). Cobalt from pharmaceutical vitamin tablets was preconcentrated by use of this chelating resin and estimated by FAAS (RSD approximately 4%).     

Preparation and electrical conductivity of organoheterobimetallic-maleonitriledithiolates

The new complexes [PhHg]₂[M(mnt)₂] [M = Ni^II, Cu^II, Zn^II or Pd^II; mnt^2– = 1,2-dicyano-1,2-ethylenedithiolate (maleonitriledithiolate)] have been characterized spectroscopically and magnetically and their solid phase conductivity measured. All compounds exhibit solid phase _rt in the 1.29 × 10^–12–5.68 × 10^–10 S cm^–1 range and semiconduct in the 313–383 K range.     

Triphenylene based copper ensemble for the detection of cyanide ions

The binding behavior of triphenylene based copper ensemble prepared in situ has been investigated toward various anions (F(-), Cl(-), Br(-), I(-), CH(3)COO(-), H(2)PO(4)(-), NO(3)(-), OH(-), ClO(4)(-), CN(-), CO(3)(-) and SO(4)(-)) by UV-vis and fluorescence spectroscopy. Among various anions tested, 1-Cu(2+) ensemble shows selective and sensitive response towards cyanide ions and responds to CN(-) ions even in the presence of bovine serum albumin and in blood serum milieu. Further, as practical application of compound 1, we utilized the TLC strips coated with THF solution of 1 for the solid state detection of copper and cyanide ions.     

Visual chiral recognition of mandelic acid and α-amino acid derivatives by enantioselective gel formation and precipitation

Novel chiral receptors based on l-phenylalanine and l-valine have been synthesized and their chiral recognition properties toward mandelic acid and N-tosyl α-amino acids are studied. The phenylalanine-based receptor undergoes enantioselective gel formation with R-mandelic acid and N-tosyl-d-valine, whereas the valine-linked receptor in their presence results in the formation of precipitates.     

InCl3‐Driven Regioselective Synthesis of Functionalized/Annulated Quinolines: Scope and Limitations

The efficient, regioselective synthesis of functionalized/annulated quinolines was achieved by the coupling of 2‐aminoaryl ketones with alkynes/active methylenes/α‐oxoketene dithioacetals promoted by InCl₃ in refluxing acetonitrile as well as under solvent‐free conditions in excellent yields. This transformation presumably proceeded through the hydroamination–hydroarylation of alkynes, and the Friedländer annulation of active methylene compounds and α‐oxoketene dithioacetals with 2‐aminoarylketones. In addition, simple reductive and oxidative cyclization of 2‐nitrobenzaldehyde and 2‐aminobenzylalcohol, respectively, afforded substituted quinolines. Systematic optimization of the reaction parameters allowed us to identify two‐component coupling (2CC) conditions that were tolerant of a wide range of functional groups, thereby providing densely functionalized/annulated quinolines. This approach tolerates the synthesis of various bioactive quinoline frameworks from the same 2‐aminoarylketones under mild conditions, thus making this strategy highly useful in diversity‐oriented synthesis (DOS). The scope and limitations of the alkyne‐, activated methylene‐, and α‐oxoketene dithioacetal components on the reaction were also investigated.     

Determination of aminoglycoside residues in kidney and honey samples by hydrophilic interaction chromatography‐tandem mass spectrometry

Two methods based on liquid chromatography–tandem mass spectrometry were developed for the determination of ten aminoglycosides (streptomycin, dihydrostreptomycin, spectinomycin, apramycin, paromomycin, kanamycin A, gentamycin C1, gentamycin C2/C2a, gentamycin C1a, and neomycin B) in kidney samples from food‐producing animals and in honey samples. The methods involved extraction with an aqueous solution (for the kidney samples) or sample dissolution in water (for the honey samples), solid‐phase extraction with a weak cation exchange cartridge and injection of the eluate into a liquid chromatography–tandem mass spectrometry system. A zwitterionic hydrophilic interaction chromatography column was used for separation of aminoglycosides and a triple quadrupole mass analyzer was used for detection. The methods were validated according to Decision 2002/657/EC. The limits of quantitation ranged from 2 to 125 μg/kg in honey and 25 to 264 μg/kg in the kidney samples. Interday precision (RSD%) ranged from 6 to 26% in honey and 2 to 21% in kidney. Trueness, expressed as the percentage of error, ranged from 7 to 20% in honey and 1 to 11% in kidney.