Adsorption Behavior of a Water-soluble Porphyrin at the Glass-water Interface as Studied by Synchronous Total Internal Reflection Fluorescence Spectroscopy

Total imernal reflection fluorescence spectroscopy (TIRF) and synchronous scanning technique were combined to study the adsorption behavior of the meso-tetrakis (4-sulfonatophenyl)porphyrin (TPPS) at the glass-water interface without any surfactant. The pH dependence of synchronous fluorescence signal at the interface was analyzed. Both unprotonated (TPPS^4-) and diprotonated (H2TPPS^2-) forms of TPPS were observed at the interface. But the interface favored the adsorption of. The apparent estimated pKa2 value shifted from 5.00 in the bulk solution to 2.7 at the interface. STIRF provides a good technique to study multi-component systems at the interface.     

电化学合成聚苯胺粉末电极的电化学行为研究

我们曾用慢速动电位扫描法研究化学合成聚苯胺粉末的电化学行为.本文对恒电位电解合成聚苯胺粉末进行了研究.用这种方法制备的粉末由于合成溶液中不含氧化剂因而纯度高.本文还报导了这种聚苯胺粉末电极的交流阻抗测量结果.交流阻抗法曾用于聚苯胺膜的电导和化学合成聚吡咯的电阻测定. 所用盐酸、氟硼酸、硅氟酸、苯胺均为分析纯;苯胺经常压蒸馏提纯;硫酸为超纯;磷酸为分析纯;高氯酸为优级纯.溶液皆用两次蒸馏水配制.     

超高感彩卷乳剂微晶体电镜研究

应用物理和化学相结合的方法，将超高感彩卷分层剥离，离心沉降，水洗除胶，电镜观测各层乳剂的微晶体结构。揭示了超高感彩卷各乳剂层的结构情况，披露了超高感彩剂制造技术。     

紫杉醇的合成进展

紫杉醇是一种重要的抗癌药物,它具有复杂新颖的化学结构,为三环二萜类化合物.本文综述了紫杉醇的半合成和紫杉烷环的各种合成方法.     

金属蒸气合成在金属有机合成中的应用

本文简要地介绍了金属蒸气合成法的基本原理、仪器和实验技术, 并按金属原子分别与炔、单烯、多烯、环烯、芳烃体系、卤代烃、有机混和物的反应及有机金属硼化合物的合成, 对金属蒸气合成法在金属有机合成中的应用进行了讨论。     

CeO2及Pt/CeO2催化剂上H2、O2的作用特性

采用TPD、TPR、FT-IR和TPEC等方法研究了CeO_2及Pt/CeO_2上H_2、O_2作用特性。结果表明, Pt促进CeO_2还原, 并形成高活动性氢物种。Pt的存在使吸H_2和放氢温度下阵达300 ℃。部分还原的CeO_2常温下吸附氧形成分子离子氧物种(O_2~-, O_2~(2-)), Pt的存在改变氧化铈催化剂在常温下氧吸附物种的形态, 以解离态存在。氧化铈上吸附的氧物种在升温时可部分脱附, 高于170 ℃时则转化为晶格氧。     

结晶聚合物的辐射效应：多官能团单体对LDPE的结晶成核作用

根据x射线、电镜、DSC和凝胶分数的测试结果,讨论了多官能团单体结构对低密度聚乙烯聚集态结构的影响以及结晶度与辐射交联(或剂量)的关系。发现由于单体的存在导致低密度聚乙烯结晶度增加而结晶尺寸变小(即结晶成核效应);成核效应越大,增强辐射交联的效果也越大。添加具有高结晶成核作用的单体有利于低密度聚乙烯的辐射交联,同时也加速其结晶结构的破坏。     

酰亚胺及磺酰苯酰亚胺的氰甲基化新方法

二乙胺基乙腈分別与苯邻二酰亚胺、丁二酰亚胺或邻-磺酰苯酰亚胺反应后,可生成相应的N-氰甲基苯邻二酰亚胺、N-氰甲基丁二酰亚胺,N-氰甲基邻磺酰苯酰亚胺及O-氰甲基邻磺酰苯酰亚胺。酰亚胺或磺酰苯酰亚胺的氰甲基化反应活性,随氮负离子的稳定性及其酸性增强而增大。     

Composite Electrode SnO2／TiO2 for Dye-Sensitized Solar Cells

Composite nanoporous electrode SnO2/TiO2 was fabricated for the dye sensitized solar cell (DSSC) with N3 (Cis-Ru). After introducing of TiO2, the open-circuit photovoltage (Voc) was higher than that of the pure SnO2 electrode, while short-circuit photocurrent (Isc) was varied with the ratio of the TiO2. Appropriate content of the TiO2 can be beneficial to the efficiency of the solar cell, and it gives negative impact on the composite electrode when the content of TiO2 is higher.     

Chemical Liquid Phase Deposition of Thin Aluminum Oxide Films

Introduction Inorganic oxide films have attracted a lot of interest in the last several decades. Among them, silicon dioxide films are widely used in modern microelectronics, optics and mechanics. This material has been grown by various methods including thermal oxidation, chemical vapor phase deposition, plasma-enhanced chemical vapor phase deposition, and so on.1,2 Recently, Nagayama et al.3 have reported that SiO2 thin films could be produced by a new chemical method of liquid phase depos…