Comparisons of several dead time correction methods in the case of a mixture of short- and long-lived nuclides

Several dead time correction methods were compared experimentally with the exact correction method and their limits were discussed. These correction methods were applied to neutron activation analysis of a biological sample. A special electronic circuit and an additional counting equipment were used to obtain the fractional dead time with a suficiently high frequency.     

Application of dibutyltin oxide method to regioselective acylation and alkylation of tylosin at C-4'

4'-O-Acyl-, 4'-O-alkyl- and 4'-deoxy-tylosin derivatives were synthesized using 2'-O-acetyl-3',4'-O-(dibutyl-stannio)tylosin as a synthetic intermediate. The in vitro biological evaluation showed that the new derivatives were active against macrolide-resistant clinical isolates of bacteria and mycoplasmas, and that they were resistant to hepatic esterase.     

Detection of environmental chemicals by SPR assay using branched cyclodextrin as sensor ligand

We obtained the association constants Ka of estrogen (E2) and environmental chemicals by the surface plasmon resonance (SPR) assay using the immobilized mono-6-O-α-maltosyl-β-CD (G₂βCD) compared with the immobilized β-CD and the immobilized estrogen receptor (ER). The association behavior of G₂βCD was shown as a ER model compound. The calibration curve was determined by the initial rate of association depending on the various concentrations, and the minimum detectable concentrations in the order of parts per billion were calculated. The SPR assay has advantages that the pre-treatment of the sample is not necessary and the immobilized ligand is stable and useful for the repeated measurement.     

Purification of enzymes by high-speed gel filtration on TSK-GEL SW columns

The purification of enzymes was investigated by high-speed gel filtration on TSK-GEL G3000SWG columns packed with porous silica gel deactivated by chemically bonded hydrophilic compounds. Crude β-galactosidase from bacterial cells and commercial urease were purified ca. 15-fold in a single gel filtration. These enzymes were eluted within an hour from the column and the recoveries of enzymatic activity were almost 100% although the operation was carried out at room temperature (22°). Samples up to 100 mg could be applied to the column without loss of separation efficiency.     

The practical synthesis of a uterine relaxant, bis(2-[[(2S)-2-([(2R)-2-hydroxy-2-[4-hydroxy-3-(2-hydroxyethyl)-phenyl]ethyl]amino)-1,2,3,4-tetrahydronaphthalen-7-yl]oxy]-N,N-dimethylacetamide) sulfate (KUR-1246)

The synthetic route for a uterine relaxant, bis(2-[[(2S)-2-([(2R)-2-hydroxy-2-[4-hydroxy-3-(2-hydroxyethyl)-phenyl]ethyl]amino)-1,2,3,4-tetrahydronaphthalen-7-yl]oxy]-N,N-dimethylacetamide) sulfate (KUR-1246), was established by the coupling of optically active components, the bromohydrin 14 and the amine 24. We now describe the practical synthesis of these two optically active components. Bromohydrin 14 was obtained by the asymmetric borane reduction of the prochiral phenacyl bromide 13 using a catalyst prepared from aluminum triethoxide and a chiral amino alcohol. The other optically active component 24 was prepared from (S)-AMT.     

High modulus polyimide/polyimide molecular composite films that utilize acetylene unit as a crosslink site

Polyimide/polyimide molecular composite (MC) films comprised of a rigid polyimide derived from biphenyltetracarboxylic dianhydride (BPDA) and p-phenylenediamine (PDA) and a flexible polyimide derived from BPDA and bis (3,3'-diaminodiphenyl) acetylene (intA) and/or oxydianiline (ODA) were prepared by blending the polyamic acid solutions in 7 : 3 weight ratio, and then imidizing the blend films. Acetylene content in the flexible polyimide backbone was controlled by the ratio of intA and ODA. Cold-drawing of the blend polyamic acid films, followed by imidization, gives high modulus polyimide/polyimide MC films. The modulus of the MC films increased almost linearly with the draw ratio, reaching 25.5 GPa for the 40% drawn film. Acetylene groups in the flexible polyimide can be thermally cured to crosslink. The onset of exotherm appeared at 340°C on DSC, reaching maximum at 398°C. After the thermal crosslinking, the MC films maintained the high modulus, though elongation became small. Taking advantage of the crosslinkable acetylene units, two MC films were laminated and processed at 400°C for 20 min under 100 kg/cm² to give a good-quality laminate film. The interface of the two films was strongly bonded through the crosslinking of acetylene groups. Laminate films maintained the high modulus afforded by the cold-drawing. © 1994 John Wiley & Sons, Inc.     

Destabilization of whole skin lipid bio-liposomes induced by skin penetration enhancers and FT-IR/ATR (Fourier transform infrared/attenuated total reflection) analysis of stratum corneum lipids.

Whole skin lipid bio-liposomes (skin bio-liposomes), in size ranging from 2 to 8 microns, were prepared by a reverse phase evaporation technique using rat full thickness skin. Leakage of an encapsulated fluorescence probe, ANTS (delta-amino-1,3,6-naphthalene-trisulfonate), was measured by adding transdermal penetration enhancers (penetrants) into the medium where the skin bio-liposomes were present. Oleylamine induced a fast release of ANTS from the liposomes compared to lauryl-amine which showed a weak action. With these penetrants, the degree of ANTS release from the prepared bio-liposomes was found to correlate well with the results of frequency changes in the CH-asymmetric stretching band near 2920 cm-1 in the rat stratum corneum. The penetrant which caused relatively strong leakage of ANTS induced the significantly large shift of the peak toward the higher wave-numbers due to the perturbation in the structure of lipids of the stratum corneum. The skin bio-liposomes prepared from the rat full thickness skin could be useful in evaluating the penetrants.     

Highly regio- and stereoselective hydrometallation reactions of fluorine-containing internal alkynes: Novel approaches to fluoroalkylated alkenes

Hydroalumination, hydrocupration, and hydroboration reactions of various fluorine-containing alkynes were investigated. The alkyne reacted smoothly with 2.0 equiv. of Red-Al at −78 °C to give the hydroaluminated adduct in a highly regio- and stereoselective manner, which was treated with iodine, the corresponding vinyliodide being produced in moderate yield. Hydrocupration of the alkynes also took place, but the resulting vinylmetal reacted with various electrophiles sluggishly. In sharp contrast, the reaction with dicyclohexylborane proceeded smoothly to afford the cis-addition products preferentially, which were subjected to Suzuki-Miyaura cross-coupling reaction, leading to trisubstituted alkenes in high yields.     

Simultaneous determination of inorganic nitrogen species by microcolumn ion chromatography

Inorganic nitrogen species (nitrate, nitrite and ammonium ions) were simultaneously determined by microcolumn ion chromatography. Nitrate and nitrite were determined by UV detection at 206 nm, whereas ammonium ion was determined by fluorescence detection at excitation 410 nm and emission 470 nm. The latter fluorescence detection is based on the postcolumn reaction of ammonium ion with o-phthalaldehyde in the presence of 2-mercaptoethanol. Effects of the reagent concentration, pH, and other reaction conditions on the signal intensity were examined, and the optimum condition was explored. The present method allowed simultaneous determination of nitrate, nitrite and ammonium ions in river water.     

Formulation design of ointment base suitable for healing of lesions in treatment of bedsores

We intended to develop a desired ointment base suitable for treatment of bedsores including the proliferation of granulation and epidermis. The main bedsore bacteria detected in our hospital were S. aureus in gram-positive coccus and P. aeruginosa in gram-negative bacillus. As the macrogol ointment (MO) was found to have bactericidal effects on these bacteria, MO was adopted as the base for the objective ointment. To improve the properties of the ointment base such as regulating the humidity of the exudation and controlling the release of antibiotics formulated in the ointment, co-formulating effects of various additives to MO were evaluated. The sustained release function of the ointment base was obtained by adding hydrophilic petrolatum (HP) to MO. However, the resultant ointment was found to have a poor humidity regulating property. On the other hand, MO containing 5% of hydroxypropyl cellulose (HPC) showed both the humidity regulating and the controlled drug releasing properties. It was considered that HPC particles dispersed in the ointment could be swelled by absorbing water to form a gel network. The curd tension meter tests for the ointments prepared with the various polymers showed that the MO-HPC base, which showed the highest sustained drug releasing property, was found to have the highest hardness. This result means that HPC formulated into the base forms the most rigid gel structure to resist the erosion of the ointment and to control the drug release.