Development of dynamic compartment model for prediction of behavior of radioiodine in rice paddy field

For the assessment of a public impact caused by radionuclides released from nuclear facilities, a dynamic compartment model was developed for prediction of behavior of radioiodine in air, paddy field and rice plant system. The transfer coefficients among compartments were determined by some experimental data and assumptions for each chemical form of iodine. A verification of the model was carried out by some case studies.     

Structure of Sol-Gel-Derived Sodium Dititanate Glass

The sodium dititanate, Na₂O·2TiO₂ glass was prepared by the sol-gel method. The structure of the glass, especially local environment of Ti⁴⁺ ions was examined using X-ray diffraction and X-ray absorption fine structure (XAFS) analyses, and was compared with that of the melt-derived glass with the same composition. It was found that Ti⁴⁺ ions are rather in five-fold coordination state, forming TiO₅ pyramids with one doubly bonded Ti=O in the gel-glass, while they were in lower coordination state or four-fold coordination in the melt-derived glass.     

Plasma polymerization of tetrafluoroethylene. III. Reproducibility and effects of substrate and reactor materials

Plasma polylmerization occurs in plasmas surrounded by surfaces and polymer formation is one of the complicated interactions that take place between active species and molecules which constitute surfaces and gas phases. Effects of reactor wall, substrate materials, flow rate, and discharge power on polymer formation, and properties of polymer deposits were investigated by ESCA, IR (infrared) spectroscopy, and the measurement of system pressure. The effect of surface is important at the initial stage of plasma polymerization which can be easily detected by the system pressure change; however, integrated properties such as IR spectroscopy and the deposition rate show the effect in a less pronounced manner. ESCA, which reflects the properties of surface (approximately 20 A? in depth), showed the effect of surface in an even less sensitive manner. The amount and properties (including the effects of surfaces) are dependent on plasma polymerization parameter W/FM(W, wattage; F, volume flow rate; and M, molecualar weight of monomer) and the location of deposition within a reactor. IR and ESCA data clearly showed the dependence of polymer properties on W/FM; i.e., increase of W and decrease of M to be equivalent. When all these factors were kept under control, the reproducibility of plasma polymerization was found to be excellent.     

Property of TS-16N solid state nuclear track detectors as an imaging medium for macroautoradiography of alpha-emitters in biological specimens

Feasibility of TS-16N solid state nuclear track detectors for an imaging medium of rapid autoradiography of alpha-emitters is described. Though a little longer etching time was required, the contrast of autoradiographic image on this detector proved to be superior to CR-39 detectors whose property for macroautoradiography was previously reported by the authors. The resolutions of these two different type detectors were almost equivalent to each other. The autoradiography taken by way of trial proved that this detector could be used to study metabolism and dosimetry of internally deposited alpha-emitters. With further study, the inherent properties of this detector such as low background or high sensitivity should extend the field of track etch imaging technique such as fast neutron radiography.     

Novel synthesis of heterocyclic spirans by tandem cycloaddition to sulfur-containing heterocumulenes

Novel Ni(C0)₄-promoted tandem cycloadditions of diphenylcyclo- propenone to isothiocyanates and to CS₂ were found to provide new heterocyclic spirans, pyrroline-2-one-5-spiro-5′-thiolene-4′-ones and a thiolene-2-one-5-spiro-5′-thiolene-4′-one, respectively, in moderate yields.     

First asymmetric total synthesis of tetrodotoxin

Tetrodotoxin, a toxic principle of puffer fish poisoning, is one of the most famous marine natural products because of the complex structure having many functional groups and its potent biological activity leading to death. Since the structure elucidation in 1964, this toxin has been recognized as a formidable target molecule for total synthesis. We have recently achieved the first asymmetric total synthesis from 2-acetoxy-tri-O-acetyl-d-glucal as a chiral starting material. The highly hydroxylated cyclohexane ring was constructed by Claisen rearrangement and regioselective hydroxylations of an acetone moiety and an intramolecular directed aldol condensation of the precursor having methyl ketone with dihydroxyacetone, which was synthesized through Sonogashira coupling. Installation of nitrogen functionality was unsuccessful through an attempted Overman rearrangement. We, therefore, employed a new intramolecular conjugate addition strategy between the carbamate and unsaturated ester groups. The alpha-hydroxyl lactone moiety was synthesized through an intramolecular epoxide opening by the Z-enolate of aldehyde, which was followed by oxidation-reduction of the resulting cyclic vinyl ether. The lactone was then converted to a protected ortho ester, and then gunanidinylation was followed by cleavage of the 1,2-glycol to give the fully protected tetrodotoxin. Selection of the protective groups has finally led us to accomplish the total synthesis of tetrodotoxin in an enantiomerically pure form. All the stereogenic centers were controlled with high selectivity, and the hydroxyl groups were differently protected to discriminate for the future analogue synthesis of a bioorganic program. The synthetic tetrodotoxin was purified by ion exchange chromatography and characterized to be identical with the natural compound.     

Development and prevalidation of a method for phenol determination by solid-phase spectrophotometry

A simple, sensitive and rapid solid-phase spectrophotometric procedure was developed for the determination of traces of phenol with 4-aminoantipyrine as a reagent (AAP-SPS), and the optimal experimental conditions were established. This method was performed by sorption and direct absorbance measurements of the product phenol-AAP sorbed on the anion-exchanger Dowex 1-X4 (0.2 g) at 495 nm (absorption maximum) and 700 nm (non-absorption wavelength). The sensitivity offered by the AAP-SPS procedure was higher by a factor of 40 compared with the respective conventional spectrophotometric method. Metrological characteristics were established using a prevalidation strategy. The AAP-SPS procedure is characterized by a linear calibration function in the working range of 0.05–0.50 μmol, low standard deviation of procedure (±0.012), low limit of determination (0.021 μmol), and favorable random (±0.85 to ±11.27%) and systematic deviations (−4.55 to +11.50%). Moreover, the accuracy of the system investigated by the recovery test is acceptable (99–102%). Favorable working and performance characteristics make the new SPS method ideal for phenol monitoring in pharmaceutical preparations as well as other matrices.     

Elucidation of solid-state complexation in ground mixtures of cholic acid and guest compounds

The solid-state complexation between cholic acid (CA) and either methyl p-hydroxybenzoate (MPB) or ibuprofen (IBP) was investigated. Powder X-ray diffractometry, IR spectroscopy and thermal analysis suggested the complex formation between CA and MPB as well as between CA and IBP by co-grinding method. The stoichiometry of CA-MPB was 1 : 1 while that of CA-IBP was 2 : 1, reflecting the effect of guest size on complex formation. The guest compounds were assumed to be included in the channel of complexes formed by hydrogen bonds among CA molecules.     

Thermodynamic theory of viscoelasticity

The relaxation spectra in polymers arise from the existence of many possible modes for dissipating the strain energy raised by the imposed force. These modes are made up by coupling the simplest and fastest mode of relaxation involving the rotation of a conformer, typically represented by the picosecond rotation of the carbon to carbon bond. This fast relaxation process cannot take place easily in the condensed state crowded by the densely packed conformers, necessitating cooperativity among them. The domain of cooperativity grows at lower temperatures, toward the infinite size at the Kauzman zero entropy temperature. From the temperature dependence of the domain size, the well-known Vogel equation is derived, which is numerically equivalent to the empirical WLF and free volume equations. The molar volume is a crucial factor in determining the molar free volume and, therefore, in determining theT _g of a material. The molar ΔC _P is proportional to the logarithmic molar volume, and is greater for a polymer with a higherT _g, but ΔC _P per gram for it is smaller, as it is proportional to (logM) divided byM, whereM is the molecular weight of the conformer. From this theory, it is possible to predict the dependence of the characteristic relaxation time on temperature if eitherT _g or the conformer size is known, since one can be derived from the other. From the Vogel equation with all parameters thus derived, it is possible to obtain a master relaxation curve and the spectrum from one set of dynamic mechanical data taken at one frequency over a range of temperatures. Whereas the linear viscoelastic principle is limited to small strains only, a real polymer is often deformed well beyond such a limit. Above a certain limit of strain energy level, linear viscoelastic deformation is no longer possible and the plastic deformation takes over. However, because a polymer typically manifests a spectrum of relaxation times, its behavior is a combination of viscoelastic and plastic behaviors. The ratio between the two behaviors depend on the rate of deformation, and can be precisely predicted from the linear viscoelastic relaxation spectrum. The combined behavior is termed viscoplasticity, and it applies to a wide range of practically important mechanical behaviors from the flow of the melt to the yield and fracture of glassy and crystalline solids.