Highly sensitive determination of haloperidol in human serum by capillary gas chromatography using a surface ionization detector

A method has been developed for highly sensitive determination of haloperidol in human serum involving a simple extraction procedure followed by gas chromatographic separation. Target components were separated from the extracting solvents with a Van den Berg type solventless sample injector before introduction Into a DB-1 capillary separation column. A surface ionization detector (SID), which has highly selective sensitivity for Substituted amines, was employed for quantitation using bromperidol as an internal standard. Chloroform proved to be the best extracting solvent, yielding a quantitative detection limit of 5 ng/ml (S/N = 2). Comparison of the response to target compounds obtained by the SID, FTD (flame thermionic detector), and FID (flame ionization detector) showed the SID to be superior.     

Quantitative analysis of hyaluronic acid by high-performance liquid chromatography of streptomyces hyaluronidase digests

The separation and quantitative analysis of streptomyces hyaluronidase ( HAase ) degradation products of hyaluronic acid (HA) by high-performance liquid chromatography are described. The substituted 4,5-unsaturated tetrasaccharide and hexasaccharide which result from the digestion of HA are quickly separated on a silica gel (Zorbax SIL) column. The assay of HA is linear between 5 and 250 micrograms of HA. This procedure is suitable for some weakly acidic glycosaminoglycan contaminants having similar properties to those of HA.     

Determination of meropenem by capillary electrophoresis using direct injection of serum

Concentration determination of meropenem, a carbapenem antibiotic, using a capillary electrophoresis method by direct injection of serum samples without any pretreatment is described herein. Sodium tetraborate (25 mM)-sodium hydroxide (0.1 M) containing sodium dodecyl sulfate (90 mM) is used as a run buffer (pH 10.0). Meropenem is detected at its absorption maximum at 297 nm. Migration time of meropenem is approximately 7.2 min, and the detection limit of the assay is 2.0 mg/L at a signal-to-noise ratio of 3.0. The relative standard deviations of intra- and interassay accuracies are 3.43-8.87% and 4.28-8.54%, respectively, at a nominal concentration of 6.3-100.0 mg/L, and their recovery rates are 94-111% and 92-105%, respectively.     

Characterization of an avidin-bonded column for direct injection in reversed-phase high-performance liquid chromatography

An automatic method for the determination of metabolites of Ropivacaine in urine was set up. It utilizes supported liquid membrane extraction for sample clean-up and enrichment, followed by ion-pair chromatography determination using UV detection. The extraction was very selective with no observed interfering compounds from the urine matrix, permitting simple isocratic chromatographic analysis. The detection limits for spiked urine samples were 2–18 nM for the different compounds. The repeatability was 1–3% (RSD) with an internal standard that was also extracted, and about twice without this standard. A throughput of 3.3 samples per hour was achieved and the liquid membrane was stable for more than a week.     

Targeting of mitomycin C to the liver by the use of asialofetuin as a carrier.

Desialylated fetuin (asialofetuin) was adopted as a carrier for introducing drugs in parenchymal liver cells. Mitomycin C, as a model guest-compound, was covalently attached to asialofetuin through a spacer of the succinyl group. The asialofetuin-mitomycin C conjugate contained 4.4 w/w% of mitomycin C and liberated it gradually at physiological conditions (t1/2 = 37 h). The survival time of the conjugate in rat blood circulation was significantly smaller than that of the non-desialylated fetuin conjugate; the elimination half-life was 7.3 min after intravenous injection. At 30 min after injection of the conjugate in rats, 40% of the dose was present in the liver. Parenchymal cells in the liver selectively took up the conjugate, which was highly distributed to the lysosomal fraction in the cell. The greater uptake of the conjugate by hepatocytes reflected the increased excretion in the bile; totally 10.4% of the dose was recovered.     

Polyiodide composition in poly(vinyl acetate)-iodine-iodide complex

Polyiodide formed by complexation of poly(vinyl acetate) (PVAc) with iodine in the presence of iodide has been investigated by chemical analysis and resonance Raman spectrophotometry. When PVAc films were immersed in iodide-iodine aqueous solutions which had different ratios of iodide to iodine concentration [I^?]/[I₂], the complex films exhibited tremendous variations of swelling degree, despite the relatively small change in the amount of bound iodine. From a quantitative chemical analysis, the composition of polyiodide bound to PVAc was found to be 1.01 ± 0.035 in the molar ratio of iodide to iodine irrespective of the composition of the iodide-iodine aqueous solution ([I^?]/[I₂] = 2–500). The polyiodide formed in PVAc-iodine-iodide complex was therefore inferred to be (I₃^?)_n. Resonance Raman spectra obtained on PVAc-iodine-iodide complexes were also identical to those of the benzamide-iodine complex, in which the polyiodide consists of (I₃^?)_n, consistent with the result from chemical analysis.     

INAA determination of holmium in submilligram samples of cosmochemical and geochemical interest and the second-order activation interference

Second-order neutron activation becomes a serious interference in NAA determinations of REE in submilligram samples of meteoritic and terrestrial materials when neutron fluences reach levels of 10²⁰ n·cm^–2 or more. The Dy-interference to Ho determination and the Eu-interference to Gd determination are quite, large. We discuss the importance of second-order activation interferences in REE determinations, and present an experimental method to correct the Dy-interference to Ho determination by INAA. Ho concentrations in splits of less than 0.2 mg of BCR-1 and SP can be accurately determined by INAA with a neutron fluence of 2·10²⁰ n·cm^–2 in spite of large Dy interferences of up to 200%. It is necessary for NAA determinations of REE with high neutron fluences that each REE standard be separated from its neighboring REE, in order to correct the second-order activation interferences experimentally.     

Analysis of oxidized epigallocatechin gallate by liquid chromatography/mass spectrometry

(-)-Epigallocatechin gallate (EGCG) of catechins changes from non-colored at around neutral pH to yellow at higher pH region in aqueous solution. The pH-dependent oxidation of EGCG was analyzed by liquid chromatography/electrospray ionization tandem mass spectrometry (LC/ESI-MS/MS). LC/MS/MS analysis of EGCG and its related compounds, (-)-epicatechin gallate (ECG) and (-)-epigallocatechin (EGC), successfully elucidated the structure relationship of EGCG solution involving the color change reaction at different pH conditions. The oxidation species produced at alkaline pH was detected at a different retention time from EGCG in the chromatograms of the EGCG sample. The oxidation species was found to correspond to M+14 (where M is the molecular weight of EGCG), which has two hydrogen atoms removed and addition of one oxygen atom to the gallyl moiety in the B-ring of EGCG.     

Synthesis and characterization of flavylium salts having three types color depending on recrystallization conditions

Three types of flavylium salts (FVs, yellow, green and red) have been synthesized and the colors depended on recrystallization conditions. The existence of these color states was confirmed by diffuse reflectance spectra. The spectra were almost the same as the absorption spectra in ethanol solution. The molecular state of FVs in crystals will be the same as that in solutions. The crystal colors of the FVs are controlled by the recrystallization conditions.