Gelation with N-lauroyl-L-glutamic-α,γ-dibutylamide for liquid scintillation counting of low specific activities of35S and32P

A gelling agent, N-lauroyl-L-glutamic-,-dibutylamide, was applied for liquid scintillation counting of inorganic³²P and³⁵S. The gel with toluene cocktail is transparent and rigid for a long time. Several grams of ammonium magnesium phosphate or barium sulfate can easily be measured without complicating procedures.     

Diffusion coefficient of 36Cl in silver chloride

Diffusion coefficient of 36Cl in silver chloride was revealed to be about 1 x 10(-10)-4 x 10(-11) cm2 . s-1 in the range of 400 degrees C-200 degrees C by means of radioactive tracer measurements. Activation energy for diffusion was calculated about 0.13 eV. These results were different from those obtained by Maurer and Compton.     

Second-order nonlinear optical properties from poled silicate channel-waveguide

Thin film waveguides of germanosilicate glass are fabricated byrf-sputtering. Second-order nonlinearity ofd ₃₃=3.2 pm/V is obtained from electrically poled film, and the lifetime of the nonlinearity is found to be310 years. The poled channel-waveguide is prepared and the Cerenkov-type phase-matched frequency doubling is successfully observed.     

Pi-face-selective Diels-Alder reactions of 3,4-di-tert-butylthiophene 1-oxide and 1-imide and formation of 1,2-thiazetidines

3,4-Di-tert-butylthiophene 1-oxide (1a) reacted with a series of electron-deficient alkenic dienophiles at its syn-pi-face relating to the S=O bond to give [4+2] adducts in excellent yields. The 1-oxide 1a also reacted even with angle-strained dienophiles acenaphthylene and norbornene at its syn-pi-face to afford [4+2] adducts; in the latter case, norbornene reacted exclusively at its exo-pi-face. The oxide 1a reacted with dimethyl acetylenedicarboxylate to produce dimethyl 4,5-di-tert-butylphthalate in high yield with spontaneous extrusion of SO from the initial adduct even at room temperature. Similarly, 3,4-di-tert-butylthiophene 1-(p-toluenesulfonyl)imide (3a) reacted with alkenic dienophiles at its syn-pi-face relating to the S=N bond to give [4+2] adducts in good yields. The reaction of 3a with 4-phenyl-1,2,4-triazoline-3,5-dione (PTAD) afforded a 1,2-thiazetidine 12a, the first example of S-unoxidized 1,2-thiazetidine, in good yield, through rearrangement of the initial [4+2] adduct. The molecular structure of 12a is discussed on the basis of the X-ray crystallographic analysis. Comparison of the foregoing reactions leads to the conclusion that the 1-oxide 1a is more reactive as a diene than the 1-imide 3a, which is more reactive than 3,4-di-tert-butylthiophene 1,1-dioxide. The origin of the syn-pi-face selectivities of 1a and 3a in Diels-Alder reactions is discussed in terms of the orbital mixing rule and steric effect and also based on B3LYP/6-31G(d) calculations.     

Photophysical and (photo)electrochemical properties of a coumarin dye

A new coumarin dye, cyano-{5,5-dimethyl-3-[2-(1,1,6,6-tetramethyl-10-oxo-2,3,5,6-tetrahydro-1H,4H,10H-11-oxa-3a-aza-benzo[de]anthracen-9-yl)vinyl]cyclohex-2-enylidene}-acetic acid (NKX-2753), was prepared and characterized with respect to photophysical and electrochemical properties. It was employed as a dye sensitizer in dye-sensitized solar cells and showed efficient photon-to-electron conversion properties. The photocurrent action spectrum exhibited a broad feature with a maximum incident photon-to-electron conversion efficiency (IPCE) of 84% at 540 nm, which is comparable to that for the famous red dye RuL2(NCS)2 (known as N3), where L stands for 2,2'-bipyridyl-4,4'-dicarboxylic acid. The sandwich-type solar cell with NKX-2753, under illumination of full sun (AM1.5, 100 mW cm(-2)), produced 16.1 mA cm(-2) of short-circuit photocurrent, 0.60 V of open-circuit photovoltage, and 0.69 of fill factor, corresponding to 6.7% of overall energy conversion efficiency using 0.1 M LiI, 0.05 M I2, 0.1 M guanidinium thiocyanate, and 0.6 M 1,2-dimethyl-3-n-propyl-imidazolium iodide in dry acetonitrile as redox electrolyte. In comparison with its analogue NKX-2586 (Langmuir 2004, 20, 4205), NKX-2753 with an extra side ring on the alkene chain produced much higher IPCE values at the same conditions. The side ring acted as a spacer to efficiently prevent dye aggregation when adsorbed on the TiO2 surface, resulting in significant improvements of short-circuit photocurrent, open-circuit photovoltage, and fill factor compared with NKX-2586 that aggregated on the TiO2 surface.     

Substituent effects in the mass spectral fragmentation of aryl esters

The mass spectra of m- and p-substituted phenyl acetates, phenyl propionates, phenyl chloroacetates and phenyl fluoroacetates have been determined. The fragmentation of aryl esters is affected by acyl substituents as well as by aryl substituents. Esters having acyl groups of low ionization potential show greater changes in fragmentation because of aryl substituents than those having acyl groups of high ionization potential. Each series has a fairly definite crossover point where fragmentation changes from predominant rearrangement to predominant cleavage.     

Donor–acceptor–acceptor-type near-infrared fluorophores that contain dithienophosphole oxide and boryl groups: effect of the boryl group on the nonradiative decay

The use of donor–π–acceptor (D–π–A) skeletons is an effective strategy for the design of fluorophores with red-shifted emission. In particular, the use of amino and boryl moieties as the electron-donating and -accepting groups, respectively, can produce dyes that exhibit high fluorescence and solvatochromism. Herein, we introduce a dithienophosphole P-oxide scaffold as an acceptor–spacer to produce a boryl- and amino-substituted donor–acceptor–acceptor (D–A–A) π-system. The thus obtained fluorophores exhibit emission in the near-infrared (NIR) region, while maintaining high fluorescence quantum yields even in polar solvents (e.g. λ_em = 704 nm and Φ_F = 0.69 in CH₃CN). A comparison of these compounds with their formyl- or cyano-substituted counterparts demonstrated the importance of the boryl group for generating intense emission. The differences among these electron-accepting substituents were examined in detail using theoretical calculations, which revealed the crucial role of the boryl group in lowering the nonradiative decay rate constant by decreasing the non-adiabatic coupling in the internal conversion process. The D–A–A framework was further fine-tuned to improve the photostability. One of these D–A–A dyes was successfully used in bioimaging to visualize the blood vessels of Japanese medaka larvae and mouse brain.

Combination of electron-accepting diarylboryl terminal groups and dithienophosphole oxide spacers with electron-donating triarylamine moieties produces donor–acceptor–acceptor type π-systems, which exhibit emissions in the near-infrared region.     

A temperature study on critical micellization concentration (CMC), solubility, and degree of counterion binding of α-sulfonatomyristic acid methyl ester in water by electroconductivity measurements

 For a sodium salt of α-sulfonatomyristic acid methyl ester (14SFNa), one of the α-SFMe series surfactants, critical micellization concentration (CMC), solubility and degree of counterion binding (β) were determined by means of electrocon-ductivity measurements at different temperatures (at every 5 °C) ranging from 15 to 50 °C. The phase diagram of 14SFNa in pure water was constructed from the CMC- and solubility-temperature data, in which the Krafft temperature (critical solution temperature) was found around 0 °C. The changes in the Gibbs energy, ΔG ⁰ _m, enthalpy, ΔH ⁰ _m, and entropy, ΔS ⁰ _m, upon micelle formation as a function of temperature were evaluated taking βvalues into calculation. Received: 28 August 1996 Accepted: 5 November 1996