Temperature dependence of ion and water transport in perfluorinated ionomer membranes for fuel cells

To clarify the mechanisms of transport of ions and water molecules in perfluorosulfonated ionomer membranes for fuel cells, the temperature dependence of their transport behaviors was investigated in detail. Two types of Flemion membranes having different equivalent weight values (EW) were utilized along with Nafion 117 as the perfluorinated ionomer membranes, and H-, Li-, and Na-form samples were prepared for each membrane by immersion in 0.03 M HCl, LiCl, and NaCl aqueous solutions, respectively. The ionic conductivity, water self-diffusion coefficient (D(H)(2)(O)), and DSC were measured in the fully hydrated state as a function of temperature. The ionic conductivity of the membranes was reflected by the cation transport through the intermediary of water. Clearly, H(+) transports by the Grotthuss (hopping) mechanism, and Li(+) and Na(+) transport by the vehicle mechanism. The differences of the ion transport mechanisms were observed in the activation energies through the Arrhenius plots. The D(H)(2)(O) in the membranes exhibited a tendency similar to the ionic conductivity for the cation species and the EW value. However, no remarkable difference of D(H)(2)(O) between H- and the other cation-form membranes was observed as compared with the ionic conductivity. It indicates that water in each membrane diffuses almost in a similar way; however, H(+) transports by the Grotthuss mechanism so that conductivity of H(+) is much higher than that of the other cations. Moreover, the D(H)(2)(O) and DSC curves showed that a part of water in the membranes freezes around -20 degrees C, but the nonfreezing water remains and diffuses below that temperature. This fact suggests that completely free water (bulk water) does not exist in the membranes, and water weakly interacting with the cation species and the sulfonic acid groups in secondary and higher hydration shells freezes around -20 degrees C, while strongly binding water in primary hydration shells does not freeze. The ratio of freezing and nonfreezing water was estimated from the DSC curves. The D(H)(2)(O) in the membranes was found to be influenced by the ratio of freezing and nonfreezing water. DFT calculation of the interaction (solvation) energy between the cation species and water molecules suggested that the water content and the ratio of freezing and nonfreezing water depend strongly on the cation species penetrated into the membrane.     

Adsorption properties of activated carbon from waste newspaper prepared by chemical and physical activation

Adsorption properties of activated carbons prepared from waste newspaper by chemical and physical activation were investigated using water vapor, ammonia, methane, and methylene blue (MB) as adsorbents. The water vapor adsorption isotherms show type V behavior and the maximum vapor adsorption of the chemically and physically activated products is about 1050 and 450 ml/g, respectively. The higher water vapor adsorption of the chemically activated products is attributed to the higher specific surface area (S(BET)) and greater hydrophilic activity (arising from the surface oxygen-containing functional groups) than in the physically activated products. The adsorption of ammonia and methane was measured by temperature-programmed desorption (TPD). NH(3) adsorption is found to be higher in the chemically activated product than in the physically activated product while methane adsorption is slightly higher in the physically activated products even though these have lower S(BET) values. In the MB adsorption, the chemically activated products show higher adsorption (390 mg/g) than the physically activated product. These results are suggested to be related to the surface characteristics.     

Cation-pi interactions of a thiocarbonyl group and a carbonyl group with a pyridinium nucleus

Attractive interactions between a thiocarbonyl group and a pyridinium nucleus, and between a carbonyl group and a pyridinium nucleus have been proven by (1)H and (13)C NMR studies, UV-vis spectral analyses, and X-ray crystallographic analyses of nicotinic amides 1 and 3, and pyridinium salts 2 and 4. Comparison of the Deltadelta values, which are the differences in the chemical shifts with reference compounds 5 or 6, showed that the absolute Deltadelta values of 2 and 4 are much larger than those of 1 and 3. In the UV-vis spectra, the n-->pi absorption of the C=S group of 2a exhibited a significant blue shift in CHCl(3). X-ray crystallographic analysis of 1-4 clearly showed that the C=S group of 2a and the C=O group of 4 are very close to the pyridinium moiety compared to the case of 1 and 3. In addition, the X-ray crystal packing structure of 2a showed the C=S group is sandwiched between two pyridinium rings. These experimental results strongly suggested the existence of attractive (C=S)...Py(+) and (C=O)...Py(+) interactions in solution and in crystal. The optimized geometries of 1 and 2 calculated at the HF/6-311G level are in good agreement with their X-ray geometries. MP2/6-311G calculations for the model systems of pyridinium salts 2 and 4 predicted that the electrostatic and induction energies are the major source of the attractive interactions. Since the larger contribution of electrostatic and induction interactions are characteristic features of cation-pi interactions, the (C=S)...Py(+) and (C=O)...Py(+) interactions would be classified as a cation-pi interaction.     

Application of non-thermal atmospheric pressure ac plasmas to the carbon dioxide reforming of methane

Methane conversions of 11.9%, yields of hydrogen as high as 23.3% and energy yields of 1.0 mol H₂/kWh have been achieved from CO₂ reforming of CH₄ in non-thermal, atmospheric pressure plasma reactors with Pt coated electrodes. Two reactors have been studied. A novel fan type reactor consisting of a movable rotor and immobile stator produced the highest yields in contrast to a tube type (silent discharge) reactor with a glass dielectric barrier. Conversions, yields of hydrogen and energy yields (expressed as mol H₂/kWh) were studied for CO₂/CH₄ concentrations of 1.1% and 5.0% in He as a function of flow rate and input voltage. Hydrogen yields are observed to increase as the input voltage is increased from 411 V to 911 V and the flow rate is decreased from 100 cc/min to 30 cc/min. Energy yields vary only slightly with input voltage and flow rate. Hydrogen yields show little dependence on CO₂/CH₄ concentrations, but energy yields are approximately five times greater for the 5.0% mixture than the 1.1% mixture. Selectivities to H₂, CO, coke, and low molecular weight hydrocarbons were also evaluated and compared to data obtained without CO₂ in the feed. Hydrogen selectivities of nearly 100% were obtained, with small amounts of ethane and propane as the only observed side products and the selectivites were approximately the same whether CO₂ was present or absent in the mixture. However, the reaction proceeds much more cleanly when CO₂ is present, producing CO. The syngas product has an H₂ : CO ratio of 1.5 with the fan type reactor and 0.67 with the tubular reactor. In the absence of CO₂, coke is the main carbonaceous product. Under all conditions studied the fan type reactor demonstrated higher methane conversions (up to 11.9%) and selectivities to hydrogen.     

In Situ Processing of Nano Crystalline Oxide Particles/Polymer Hybrid

Nano sized crystalline particles/polymer hybrids were synthesized form designed metal-organic precursors. The newly developed method is composed of the synthesis of organic matrix by polymerization and the in situ nucleation and growth of crystalline oxide particles in the organic matrix below 100°C. The design of metal-organic precursor modified with polymerizable ligand and the selection of reaction conditions does influence the size and crystallinity of ceramic particles in organic matrix. The nano-sized magnetic particle/polymer hybrid exhibits the interesting feature of superparamagnetism and quantum size effect. The crystalline particles of BaTiO₃/, PbTiO₃/, and KNbO₃/polymer hybrids behave to be dielectric and show the typical electro-rheological behavior.     

Detection of environmental chemicals by SPR assay using branched cyclodextrin as sensor ligand

We obtained the association constants Ka of estrogen (E2) and environmental chemicals by the surface plasmon resonance (SPR) assay using the immobilized mono-6-O-α-maltosyl-β-CD (G₂βCD) compared with the immobilized β-CD and the immobilized estrogen receptor (ER). The association behavior of G₂βCD was shown as a ER model compound. The calibration curve was determined by the initial rate of association depending on the various concentrations, and the minimum detectable concentrations in the order of parts per billion were calculated. The SPR assay has advantages that the pre-treatment of the sample is not necessary and the immobilized ligand is stable and useful for the repeated measurement.     

Singular value decomposition applied to the compression of T3 amplitude for the coupled cluster method

We apply the singular value decomposition to compress the degrees of freedom of T3 amplitude for the CCSDT-1 method (compressed CCSDT-1). This method enables us to make the number of the T3 amplitudes less than that of the T2 amplitudes, making CCSDT-1 calculations much less expensive without losing accuracy. We perform test calculations on some atoms and molecules to investigate the applicability of this method. Computational results for the electronic energies as well as timings of these calculations are presented.     

Factors affecting physicochemical properties of liposomes prepared with hydrogenated purified egg yolk lecithins by the microencapsulation vesicle method

We examined hydrogenated purified egg yolk lecithins, having practical advantages over non-hydrogenated ones, as liposomal membrane materials. Liposomes were prepared by the microencapsulation vesicle (MCV) method in which liposomes are formed through two-step emulsification and dispersion. Three types of purified egg yolk lecithins with different iodine values were examined after being dissolved in one of three lipid solvents. The liposome size increased as the temperature during the second emulsification increased, being closer to the boiling temperature of the solvent. The preparation temperature in relation to the transition temperature of each lecithin was also a factor affecting liposome sizes. As for the encapsulation efficiencies of the model compound calcein in liposomes, they differed mainly depending on the solubility of each lecithin in a lipid solvent and it was more obvious in hydrogenated lecithins. A high preparation temperature resulted in lower encapsulation efficiencies, suggesting that leakage of encapsulated calcein was facilitated at high temperature in the MCV methods. There was a significant correlation between liposome sizes and encapsulation efficiencies in non-hydrogenated purified egg yolk lecithin but not in hydrogenated ones. When using hydrogenated purified egg yolk lecithins as liposomal membrane materials, it was suggested that a lipid solvent should be chosen so that a lecithin completely dissolves under the preparation condition in order to achieve a higher encapsulation efficiency. Smaller liposome particles were obtained when the second emulsification was performed at a lower temperature compared with the boiling point of the lipid solvent. These findings can be applied to control encapsulation efficiencies and particle sizes in each particular liposome preparation enclosing therapeutic agents.     

Novel syntheses of 2,3-dihydro-5H-1,4-benzoxathiepins and 1,2,3,5-tetrahydro-4,1-benzothiazepines

2,3-Dihydro-5H-1,4-benzoxathiepins were prepared by intramolecular Friedel-Crafts reactions of ethyl α-[2-(aryloxy)ethylthio]-α-chloroacetates or by acid-catalyzed cyclizations of ethyl α-[2-(aryloxy)ethylsulfinyl]-acetate. 1,2,3,5-Tetrahydro-4,1-benzothiazepines were similarly prepared.