Laser-induced fluorescence of cyclohexadienyl (c-C6H7) radical in the gas phase

A laser-induced fluorescence spectrum was observed in the 500-560 nm region when a mixture of 1,4-cyclohexadiene and oxalyl chloride was photolyzed at 193 nm. The observed excitation spectrum was assigned to the A (2)A(2)<--X (2)B(1) transition of the cyclohexadienyl radical c-C6H7, produced by abstraction of a hydrogen atom from 1,4-cyclohexadiene by Cl atoms. The origin of the A<--X transition of c-C(6)H(7) was at 18 207 cm(-1). From measurements of the dispersed fluorescence spectra and ab initio calculations, the frequencies of several vibrational modes in both the ground and excited states of c-C(6)H(7) were determined: nu(5)(C-H in-plane bend)=1571, nu(8)(C-H in-plane bend)=1174, nu(10)(C-C-C in-plane bend)=981, nu(12)(C-C-C in-plane bend)=559, nu(16)(C-C-C out-of-plane bend)=375, and nu(33)(C-C-C in-plane bend)=600 cm(-1) for the ground state and nu(8)=1118, nu(10)=967, nu(12)=502, nu(16)=172, and nu(33)=536 cm(-1) for the excited states.     

Synthesis of carbazole,acridine, phenazine, 4H‐benzo[def]carbazole and their derivatives by thermal cyclization reaction of aromatic amines

A variety of nitrogen‐containing heterocycles were synthesized by passing vapors of aromatic amines over calcium oxide at 450–650 °C under nitrogen carrier gas. Reaction of 2‐aminobiphenyl 3a at 560 °C gave carbazole 4 in 80% yield. Reaction of 2, 2′‐diaminobiphenyl 3b afforded a mixture of carbazole 4 and 4‐aminocarbozole 6b. In the case of 2‐amino‐2′‐nitrobiphenyl 3c, benzo[c]cinnoline 7 was obtained along with carbazole 4. Reaction of 2‐amino‐2′‐methoxybiphenyl 3d gave four products of carbazole 4,4‐hydroxycarbazole 6e, phenanthridine 8 and dibenzofuran 9. Reaction of 2‐aminodiphenylmethane 5a afforded acridine 10. In the case of 2‐aminobenzophenone 5b, acridone 11 was obtained as a major product. Reaction of 2‐aminobenzhydrol 5c gave acridine 10. When 2‐aminodiphenylamine 5d was reacted, phenazine 12 was obtained in good yield. In contrast, reaction of 2‐aminodiphenyl ether 5e produced only 2‐hydroxydiphenylamine 13. Reaction of 4‐aminophenanthrene 14 produced 4H‐benzo[def]carbazole 15 in 61% yield.     

Miscibility of sodium chloride and decyl methyl sulfoxide in the adsorbed film and micelle

The surface tension of aqueous solutions of a sodium chloride (NaCl)-decyl methyl sulfoxide (DeMS) mixture was measured as a function of the total molality of the mixture and the mole fraction of DeMS in the mixture at 298.15 K under atmospheric pressure. The total surface density of the mixture and the mole fraction of DeMS in the adsorbed film and micelle were numerically evaluated by applying the thermodynamic treatment of surfactant mixture to the NaCl-DeMS mixture. Miscibility of NaCl and DeMS in the adsorbed film and micelle was clarified by use of the phase diagram of adsorption and micelle formation. Positive adsorption of NaCl was observed in the presence of DeMS and attributed to attractive interaction between the polar head group of DeMS molecule and Na+ or Cl- ions in the adsorbed film and micelle. The results were compared with those of NaCl-octyl methyl sulfoxide and NaCl-decyldimethylphosphine oxide mixtures to elucidate the structure effect of nonionic surfactant on the miscibility.     

Surface dilational moduli of polymer and blended polymer monolayers spread at air-water interfaces

Surface dilational moduli of polymer monolayers, blended polymer monolayers, and polymer particle monolayers spread at air–water interfaces are reviewed, focusing on measurements using surface pressure isotherm, surface pressure relaxation, and oscillating barrier methods. Differences between the surface dilational moduli of condensed polymer monolayers and expanded polymer monolayers are explored. Moreover, the features of the surface dilational moduli in blended polymer monolayers are discussed in terms of their miscibility.     

Adsorption/oxidation of CO on highly dispersed Pt catalyst studied by combined electrochemical and ATR-FTIRAS methods: oxidation of CO adsorbed on carbon-supported Pt catalyst and unsupported Pt black

ATR-FTIRAS measurements combined with linear potential sweep voltammetry were conducted to investigate oxidation of CO adsorbed on a highly dispersed Pt catalyst supported on carbon black, Pt/C, and carbon-unsupported Pt black catalyst, Pt-B. Bands nu(CO) of atop- and bridge-bonded COs were resolved into those of COs adsorbed at terrace and step edge sites by curve-fitting analysis. At the high coverage near the saturation, a band around 1950-1960 cm(-1) assigned to asymmetric bridge-bonded CO, CO(B)(asym), was observed to develop on both Pt/C and Pt-B, which was the predominant type on the latter. Preferential oxidation of atop-CO adsorbed at the step edge site was commonly observed on both Pt/C and Pt-B during the potential sweep from 0.05 to 1.2 V. However, it has been found that CO(B)(asym) is the most reactive species. The high reactivity of the CO(B)(asym) on Pt/C and Pt-B is demonstrated for the first time in the present report. Adsorption of CO on the Pt/C and Pt-B resulted in growth of a sharp nu(OH) band around 3642-3645 cm(-1) which is assigned to non-hydrogen-bonded water molecules coadsorbed with CO. The nu(OH) band frequency exhibits a linear increase with potential with a Stark tuning rate of ca. 20 cm(-1)/V. Analysis of the potential dependence of this band in the CO oxidation potential region led us to conclude that this is the oxygen-containing species to oxidize adsorbed CO. Stark tuning rates of nu(CO) bands for the COs at the terrace and step edge sites on both Pt/C and Pt-B are almost independent of the adsorption sites for both atop- and bridge-bonded COs. However, CO(B)(asym) exhibits tuning rates of 41 cm-1/V and 37 cm-1/ V on Pt/C and Pt-B, respectively, which is in between the rates of atop and symmetric bridge-bonded COs.     

Spectrophotometric determination of titanium with o-carboxyphenylfluorone in cationic micellar media, and its equilibrium and kinetic studies

Spectrophotometric determination of titanium(IV) was accomplished with o-carboxyphenylfluorone (OCPF) in the presence of hexadecyltrimethyl ammonium chloride (HTAC) under strongly acidic media. In the determination of titanium(IV), Beer's law was obeyed in the range of 24-340 ng mL⁻¹ with an effective molar absorption coefficient (at 530 nm) and relative standard deviation of 2.24 × 10⁵ dm³ mol⁻¹ cm⁻¹ and 0.64% (n = 8), respectively. The severe interference of iron ions was easily eliminated by the addition of ethylenediaminetetraacetic acid (EDTA); the effects of other foreign substances were low. Equilibrium and kinetic studies under analytical conditions were investigated to quantitatively evaluate the reaction mechanism. The obtained orange complex is considered to be Ti(OCPF)₄. Its stability log K_f and rate constant K_obs are 16.88 and 1.65 × 10⁻² s⁻¹, respectively. It is suggested that the color of the complex is related to the species of OCPF in the solution.     

A sensitive and quantitative technique for detecting autophagic events based on lysosomal delivery

We sought to develop a sensitive and quantitative technique capable of monitoring the entire flux of autophagy involving fusion of lysosomal membranes. We observed the accumulation inside lysosomal compartments of Keima, a coral-derived acid-stable fluorescent protein that emits different-colored signals at acidic and neutral pHs. The cumulative fluorescent readout can be used to quantify autophagy at a single time point. Remarkably, the technique led us to characterize an autophagy pathway in Atg5-deficient cells, in which conventional LC3-based autophagosome probes are ineffective. Due to the large Stokes shift of Keima, this autophagy probe can be visualized in conjunction with other green-emitting fluorophores. We examined mitophagy as a selective autophagic process; time-lapse imaging of mitochondria-targeted Keima and GFP-Parkin allowed us to observe simultaneously Parkin recruitment to and autophagic degradation of mitochondria after membrane depolarization.     

Orientational isomerism controlled by the difference in electronic environments of a self-assembling heterodimeric capsule

Tetrakis(4-hydroxyphenyl)-cavitand 1 and tetra(4-pyridyl)-cavitand 2 self-assemble into a heterodimeric capsule 1.2 via four ArOH...pyridyl hydrogen bonds in CDCl3. The 1.2 expresses the orientational isomerism of an encapsulated unsymmetrical guest with high orientational selectivity because the electronic environment of the 1 unit is different from that of the 2 unit. For p-ethoxyiodobenzene and 2-iodo-6-methoxynaphthalene encapsulated in 1.2, the iodo group is specifically oriented to the cavity of the 2 unit. The orientational isomeric selectivity for methyl p-acetoxybenzoate and methyl p-ethoxybenzoate within 1.2 is 1:0.11 and 1:<0.05, respectively, wherein the methyl ester group is preferentially oriented to the cavity of the 2 unit. The delicate balance among electrostatic potential repulsion, CH-pi interaction, or CH-halogen (halogen-pi) interaction, in 1.2-guest assembly influences the orientational isomeric selectivity of unsymmetrical guests within 1.2.     

Two-directional elaboration of hydroxyacetone under thermodynamically controlled conditions: allylation or 2-propynylation and aldol reaction

Enolate generated from O-(tetrahydropyran-2-yl)hydroxyacetone under thermodynamically controlled conditions (1.3 equiv of NaH, THF, 0 degrees C to rt) was allylated at the carbon bearing the protected hydroxy group with very high regioselectively. When tert-BuOH, equivalent to the excessive portion of initially added NaH, was introduced into the mixture followed by addition of aldehyde, aldol reaction took place on the methyl group to give 1-substituted 4-hydroxy-(1E),6-heptadien-3-one in acceptable yields after acidic treatment of the mixture for dehydration and deprotection. Introducing a chiral auxiliary protecting group into hydroxyacetone led to asymmetric allylation though stereoselectivity was around 50% ee. Thus, the hidden aspect of the chemoselective nature of protected hydroxyacetone-derived enolate generated under thermodynamically controlled conditions has opened a new avenue for two-directional elaboration of hydroxyacetone that should be potentially useful in organic synthesis.