Chiral separation of trimetoquinol hydrochloride and related compounds by micellar electrokinetic chromatography using sodium taurodeoxycholate solutions and application to optical purity determination

The chiral separation of trimetoquinol hydrochloride, which is a bronchodilator (Inolin), and three related compounds by micellar electrokinetic chromatography was investigated using a bile salt as a chiral surfactant. Enantiomers of these compounds, except laudanosoline, were successfully separated within 12 min using a separation tube of effective length 500 mm × 0.05 rum i.d. and a 0.05 M sodium taurodeoxycholate solution of pH 7.0. The observed theoretical plate numbers of the peaks were ca. 150000. Chiral recognition was affected by the structure of bile salts, the pH of the buffer solutions used and the structure of the solutes. Of four kinds of bile salts, successful chiral separation was achieved only using sodium taurodeoxycholate solution under neutral conditions. The method was applied to the optical purity determination of trimetoquinol hydrochloride. The effects of surfactant concentrations and some additives to the micellar solution are briefly described.     

Investigation of the crystal structure and the structural and magnetic properties of SrCu2(PO4)2

SrCu2(PO4)2 was prepared by the solid-state method at 1153 K. Its structure was solved by direct methods in the space group Pccn (No. 56) with Z = 8 from synchrotron X-ray powder diffraction data measured at room temperature. Structure parameters were then refined by the Rietveld method to obtain the lattice parameters, a = 7.94217(8) A, b = 15.36918(14) A, and c = 10.37036(10) A. SrCu2(PO4)2 presents a new structure type and is built up from Sr2O16 and Cu1Cu2O8 units with Cu1...Cu2 = 3.256 A. The magnetic properties of SrCu2(PO4)2 were investigated by magnetic susceptibility, magnetization up to 65 T, Cu nuclear quadrupole resonance (NQR), electron-spin resonance, and specific heat measurements. With spin-dimer analysis, it was shown that the two strongest spin-exchange interactions between Cu sites result from the Cu1-O...O-Cu2 and Cu2-O...O-Cu2 super-superexchange paths with Cu1...Cu2 = 5.861 A and Cu2...Cu2 = 5.251 A, and the superexchange associated with the structural dimer Cu1Cu2O8 is negligible. The magnetic susceptibility data were analyzed in terms of a linear four-spin cluster model, Cu1-Cu2-Cu2-Cu1 with -2J(1)/kB = 82.4 K for Cu1-Cu2 and -2J(2)/k(B) = 59 K for Cu2-Cu2. A spin gap deduced from this model (Delta/kB = 63 K) is in agreement with that obtained from the Cu NQR data (Delta/kB = 65 K). A one-half magnetization plateau was observed between approximately 50 and 63 T at 1.3 K. Specific heat data show that SrCu2(PO4)2 does not undergo a long-range magnetic ordering down to 0.45 K. SrCu2(PO4)2 melts incongruently at 1189 K. We also report its vibrational properties studied with Raman spectroscopy.     

Synthesis and properties of new crystalline poly(arylene ether nitriles)

Crystalline poly(arylene ether nitrile) could be prepared by the polycondensation of 2,6-dihalobenzonitrile with resorcinol at 200°C in N-methylpyrrolidone in the presence of sodium carbonate. A reaction temperature of at least 200°C was necessary to attain high molecular weight polymer. Spectral data indicated that the polymer had the structure of a poly(meta-phenylene ether) with pendent nitrile groups on every other phenylene unit. Despite this structure, the crystallinity and the crystallization rate of the polymer were greater than those of the corresponding polymer with a para-linked structure. The glass transition temperature and the melting temperature of the polymer were almost the same as those of poly(etheretherketone) (PEEK^TM). A series of other new poly(arylene ether nitriles) were also examined. The polymers derived from 4,4′-biphenol, dihydroxytetra-phenylmethane, dihydroxydiphenylsulfone, and 1,5-isoquinolinediol had high glass transition temperatures. The poly(arylene ether nitriles) exhibited excellent tensile strength compared with the corresponding ketone- or sulfone-containing polymers. Comparing the three different kinds of polymers containing the same bisphenol units, the order of glass transition temperature was found to be sulfone- > nitrile- > ketone-containing polymers, while the order of tensile strength was nitrile- > ketone- > sulfone-containing polymers. The excellent mechanical properties are attributable to dipole-dipole interactions of nitrile groups. © 1993 John Wiley & Sons, Inc.     

Lithium‐Ion Endohedral Fullerene (Li+@C60) Dopants in Stable Perovskite Solar Cells Induce Instant Doping and Anti‐Oxidation

Herein, we report use of [Li⁺@C₆₀]TFSI^? as a dopant for spiro‐MeOTAD in lead halide perovskite solar cells. This approach gave an air stability nearly 10‐fold that of conventional devices using Li⁺TFSI^?. Such high stability is attributed to the hydrophobic nature of [Li⁺@C₆₀]TFSI^? repelling moisture and absorbing intruding oxygen, thereby protecting the perovskite device from degradation. Furthermore, [Li⁺@C₆₀]TFSI^? could oxidize spiro‐MeOTAD without the need for oxygen. The encapsulated devices exhibited outstanding air stability for more than 1000 h while illuminated under ambient conditions.     

Ruthenocene‐Type Complexes of N‐Fused Porphyrins

Ruthenocene‐type hybrid complexes with N‐fused porphyrinato ligands, [Ru(NFp)Cp] (NFp=N‐fused porphyrin, Cp=cyclopentadienyl), have been prepared and characterized by NMR and UV/Vis/NIR spectroscopy, cyclovoltammetry, and X‐ray crystallography. [Ru(NFp)Cp] is a common low‐spin ruthenium(II) complex and shows strong aromaticity. The Ru–Cp distance (1.833 Å) in [Ru(NFp)Cp] is comparable to that in [RuCp₂] (1.840 Å). DFT calculations on [Ru(NFp)Cp] showed the unequivocal contribution of the RuCp moiety as well as the NFp moiety to both the HOMO and LUMO, constructing a three‐dimensional d–π conjugated system. The HOMO–LUMO gaps of [Ru(NFp)Cp] are insensitive to the substituents on the NFp ligand, which is illustrated spectroscopically as well as theoretically. This is in sharp contrast to the ligand precursor, the N‐fused porphyrin, in which the HOMO–LUMO gap is affected by substituents in a similar manner to standard porphyrins and related macrocycles.     

ZINC TETRAPHENYLPORPHYRIN-SENSITIZED PHOTOREDUCTION OF ANTHRAQUINONESULFONATE IN AQUEOUS MICELLAR SOLUTIONS*

Abstract— Zn-tetraphenylporphyrin (ZnTPP), solubilized in non-ionic surfactant micelles, was found to sensitize photoreductions of some sodium anthraquinonesulfonatesz in the presence of ascorbic acid under anaerobic conditions. The reaction rate was increased by the addition of an anionic surfactant, while retardation was observed with a cationic surfactant. The pH-reaction rate profiles showed maxima located in the order corresponding to pK_a-values for the semiquinone of each anthraquinone-sulfonate. A reaction scheme involving the formation of ZnTPP⁺ at the primary step, followed by back-reduction with ascorbic acid, is proposed. The reaction scheme is in good agreement with the results of flash photolysis. The surfactant micelles are suggested to aid the charge-separation between the ionic species just after the redox reaction involving the photoexcited ZnTPP and anthraquinonesulfonates.     

Ferrocene-containing polymers. I. Radiation-induced polymerization of ferrocenylmethyl methacrylate

γ-Ray-induced polymerizations of ferrocenylmethyl methacrylate (FMMA) in crystalline and amorphous states were investigated with kinetical and ESR methods. In the crystalline state the polymerization of FMMA proceeded slowly and gave low-molecular-weight polymers, whereas in the amorphous state it proceeded rapidly and gave polymers of much higher molecular weight. Molecular weight distributions of these polymers were binodal. The temperature dependence and the dose-rate dependence of the polymerization rates were different between the two states. Wide-line nuclear magnetic resonance (NMR) spectra of the amorphous monomer suggested that the polymerization proceeded in a supercooled state. Electron spin resonance (ESR) spectra of γ-irradiated FMMA and 1,1′-ferrocenyl-di(methyl methacrylate) showed that ferrocene radicals and methacrylic radicals were formed simultaneously at low temperature; with increasing temperature the former radicals disappeared, whereas the latter changed into growing chain radicals. The yields of radicals were relatively low; this means that ferrocene groups in the monomers behave as a radiation energy absorber.     

Efficient formation of giant liposomes through the gentle hydration of phosphatidylcholine films doped with sugar

Giant liposomes, or giant vesicles, are cell-size (approximately 5-100 microm) compartments enclosed with phospholipid bilayers, and have often been used in biological research. They are usually generated using hydration methods, "electroformation" and "gentle hydration (or natural swelling)", in which dry lamellar films of phospholipids are hydrated with aqueous solutions. In gentle hydration, however, giant liposomes are difficult to prepare from an electrostatically neutral phospholipid because lipid lamellae cannot repel each other. In this study, we demonstrate the efficient formation of giant liposomes using the gentle hydration of neutral phospholipid (dioleoyl phosphatidylcholine, DOPC) dry films doped with nonelectrolytic monosaccharides (glucose, mannose, and fructose). A mixture of DOPC and such a sugar in an organic solvent (chloroform/methanol) was evaporated to form the films, which were then hydrated with distilled water or Tris buffers containing sodium chloride. Under these conditions, giant liposomes spontaneously formed rapidly and assumed a swollen cell-sized spherical shape with low lamellarity, whereas giant liposomes from pure DOPC films had multilamellar lipid layers, miscellaneous shapes and smaller sizes. This observation indicates that giant unilamellar vesicles (GUVs) of DOPC can be obtained efficiently through the gentle hydration of sugar-containing lipid dry films because repulsion between lipid lamellae is enhanced by the osmosis induced by dissolved sugar.     

Matrix-free high-resolution imaging mass spectrometry with high-energy ion projectiles

The importance of imaging mass spectrometry (MS) for visualizing the spatial distribution of molecular species in biological tissues and cells is growing. We have developed a new system for imaging MS using MeV ion beams, termed MeV-secondary ion mass spectrometry (MeV-SIMS) here, and demonstrated more than 1000-fold increase in molecular ion yield from a peptide sample (1154 Da), compared to keV ion irradiation. This significant enhancement of the molecular ion yield is attributed to electronic excitation induced in the near-surface region by the impact of high energy ions. In addition, the secondary ion efficiency for biologically important compounds (>1 kDa) increased to more than 10(10) cm(-2), demonstrating that the current technique could, in principle, achieve micrometer lateral resolution. In addition to MeV-SIMS, peptide compounds were also analyzed with cluster-SIMS and the results indicated that in the former method the molecular ion yields increased substantially compared to the latter. To assess the capability of MeV-SIMS to acquire heavy-ion images, we have prepared a micropatterned peptide surface and successfully obtained mass spectrometric imaging of the deprotonated peptides (m/z 1153) without any matrix enhancement. The results obtained in this study indicate that the MeV-SIMS technique can be a powerful tool for high-resolution imaging in the mass range from 100 to over 1000 Da.