带干扰的多险种风险模型

由于保险公司风险经营规模不断扩大,用单一险种的模型来描述风险过程存在局限性,本文讨论了带干扰多险种风险模型,应用鞅论方法,得出伦德伯格不等式和最终破产概率公式。     

电子束产生大尺度等离子体过程的数值模拟研究

建立了一个四组分一维混合模型，对电子束注入大气产生大尺度等离子体的过程进行了数值模拟.结果表明了能量为140keV、流强为50mA/cm²的注入电子束，可以产生线度为0.5m，密度为10¹²cm^-3量级的大气环境下等离子体.电子束所伴随的空间电荷效应由于等离子体的产生会很快消失，不影响后续的等离子体产生过程.电子束注入流强主要影响产生等离子体的密度，而电子束能量则同时影响其空间线度和密度. 关键词： 电子束 碰撞 电离     

V3+:YAG晶体的生长、色心与光谱性能研究

采用石墨电阻加热的温梯法生长了V:YAG晶体,晶体的不同部位呈现两种不同的颜色:浅绿色和黄褐色.通过对比分析不同颜色V:YAG晶体的室温吸收光谱,推断出石墨发热体高温下扩散出来的C可以起到还原作用,提高晶体中V3+tetra离子的浓度,同时诱导了F心的形成.在1300℃下,对不同颜色的V:YAG晶体进行真空退火处理,发现处于八面体格位中的V3+离子在热激发作用下与近邻的四面体格位Al3+离子存在置换反应,由此产生一定浓度的四面体格位V3+离子.同时,F心在退火过程中被完全消除,释放出来的自由电子被高价态的V离子俘获,可以进一步提高晶体中四面体格位V3+离子的浓度.     

聚丙烯孔洞铁电驻极体膜的电极化及其电荷动态特性

根据栅控恒压电晕充电组合反极性电晕补偿充电法的实验结果计算出铁电驻极体的极化强度.结果说明，伴随着薄膜内孔洞气体的Paschen击穿，该铁电体的极化强度随栅压增加而显著上升.利用上述充电方法和热刺激放电(TSD)谱的分析讨论了这类空间电荷型宏观电偶极子，及与其补偿的空间电荷热退极化的电荷动态特性；阐明了这两类俘获电荷的能阱分布，即构成宏观电偶极子的位于孔洞上下介质层内的等值异号空间电荷分别被俘获在深、浅两种能值陷阱内，而位于薄膜表面层的注入空间电荷则被俘获在中等能值陷阱中. 关键词： 反极性电晕补偿充电法 铁电驻极体 充电电流 热刺激放电     

The entropy of Garfinkle-Horne dilaton black hole due to arbitrary spin fields

Using the membrane model which is based on brick wall model, we calculated the free energy and entropy of Garfinkle-Horne dilatonic black hole due to arbitrary spin fields. The result shows that the entropy of scalar field and the entropy of Fermionic field have similar formulas. There is only a coefficient between them.     

High photosensitivity in cis-polyphenylacetylene films irradiated with 60Co γ-ray

This paper reports that ⁶⁰Co γ-ray irradiation can convert cis-polyphenylacetylene (cis-PPA) films prepared with rare-earth coordination catalysts to highly photosensitive materials. The dependence of the photosensitivity on irradiation dose, preparation methods, and microstructure of the PPA films has been investigated by means of a potential discharge technique. The photosensitivity was enhanced with increasing irradiation dose. The critical dose to produce a light response was 5 × 10³ Gy. The maximum surface potential discharge rate was 618 V/s, and the dark decay was approximately 2 V/s for cis-PPA films irradiated with ⁶⁰Co γ-ray (dose: 2 × 10⁵ Gy). The cis-transoidal-PPA and an electrophotographic photoreceptor device incorporating cis-PPA showed a higher irradiation effect. The structure and properties of ⁶⁰Co γ-ray irradiated rare-earth PPA films are similar to the unirradiated films.     

Ultraviolet Luminescence in Mg0.12Zn0.88O Alloy Films

We investigate the origin of ultraviolet （UV） emission from Mg0.12 Zn0.88 O alloy thin films with a wurtzite structure fabricated on c-plane Al2O3 substrates by plasma assisted molecular beam epitaxy. At room temperature, the absorption edge and UV emission band of the Mg0.12Zn0.88O film shift to high-energy side compared with ZnO films. Temperature dependence of the photoluminescence spectra shows that the UV emission is composed of free exciton and neutral donor bound exciton emissions. Two-step dissociation processes of the UV emission are observed with the increasing temperature. The thermal quenching mechanism is attributed to the dissociation of the free exciton from the neutral donor bound exciton in the low temperature region and the dissociation of free electron and hole from the free exciton in the high temperature region.     

Crystallographic report: Bis{[diacetyl‐bis(2,6‐isopropylphenylimine)]nickel(I)(µ‐chloro)}

The first α‐diimine nickel(I) complex having a chloro bridge is reported. The centrosymmetric dinuclear structure of {[ArN?C(Me)C(Me)?NAr]NiCl}₂[Ar?2,6?C₆H₃(i‐Pr)₂] features two chelating α‐diimine ligands and two bridged chlorine atoms, so that a distorted tetrahedral N₂Cl₂ coordination geometry for nickel results. Copyright © 2004 John Wiley & Sons, Ltd.     

Miscibility and phase structure of binary blends of polylactide and poly(methyl methacrylate)

Blends of amorphous poly(DL‐lactide) (DL‐PLA) and crystalline poly(L‐lactide) (PLLA) with poly(methyl methacrylate) (PMMA) were prepared by both solution/precipitation and solution‐casting film methods. The miscibility, crystallization behavior, and component interaction of these blends were examined by differential scanning calorimetry. Only one glass‐transition temperature (T_g) was found in the DL‐PLA/PMMA solution/precipitation blends, indicating miscibility in this system. Two isolated T_g's appeared in the DL‐PLA/PMMA solution‐casting film blends, suggesting two segregated phases in the blend system, but evidence showed that two components were partially miscible. In the PLLA/PMMA blend, the crystallization of PLLA was greatly restricted by amorphous PMMA. Once the thermal history of the blend was destroyed, PLLA and PMMA were miscible. The T_g composition relationship for both DL‐PLA/PMMA and PLLA/PMMA miscible systems obeyed the Gordon–Taylor equation. Experiment results indicated that there is no more favorable trend of DL‐PLA to form miscible blends with PMMA than PLLA when PLLA is in the amorphous state. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 23–30, 2003     

ON THE PRODUCT OF GATEAUX DIFFERENTIABILITY LOCALLY CONVEX SPACES

A locally convex space is said to be a Gateaux differentiability space (GDS)provided every continuous convex function defined on a nonempty convex open subset D of the space is densely Gateaux differentiable in D.This paper shows that the product of a GDS and a family of separable Frechet spaces is a GDS,and that the product of a GDS and an arbitrary locally convex space endowed with the weak topology is a GDS.