Synthesis and Characterization of 1,8-bis(ferrocenylmethyl)-5,5,12,12,14-hexamethyl-1,4,8,11-tetraazacyclotetradecane, a Macrocyclic Ligand and its Complexes

A new diferrocenyl-substituted macrocyclic ligand (H₂L) and its complexes ML(M = Cu^II, Ni^II, Zn^II, Cd^II) were prepared and characterized by IR, elemental analysis, absorption spectra and FAB mass spectra. The ferrocenyl-substituted macrocyclic ligand was characterized by single crystal X-ray diffraction analysis. The superconjugative effect of the cyclopentadienyl (CP) rings increase the activity of the hydrogen atoms in the tetra-azacyclotetradecane macrocyclic ligand. The imine nitrogen atoms lose two protons and coordinate to the metal. The electrochemical properties of these compounds are discussed.     

Bioinspired manganese complexes catalyzed epoxidation for the synthesis of the epoxyketone fragment of carfilzomib

We report herein an efficient catalytic epoxidation reaction for the synthesis of epoxyketone (tert-butyl ((S)-4-methyl-1-((R)-2-methyloxiran-2-yl)-1-oxopentan-2-yl)carbamate), which is an important synthetic intermediate of carfilzomib.     

Boron implantation in Si: Channeling effects studied by SIMS and simulation

The axial channeling behaviour of boron implants in <100>, <110> and <111> silicon wafers is investigated by SIMS. Large differences of channeling characteristics such as channeled projected range (the projected range of channeled ions or channeling peak) and the fraction of channeled to implanted ions are observed among the three major crystal orientations. Within the critical angle, the channeling behaviour is very sensitive to the incidence beam angle with respect to crystal orientations. SIMS measurements are performed at different positions along several critical directions over a whole wafer. Well channeled profiles with an incidence beam angle to crystal orientations of 0 ° are obtained for each ion implantation energy and orientation. The results are used to test various models of ion implantation by simulation. A 3-parameter model for electronic stopping power of boron in silicon was proposed.     

Aqueous p-nitrotoluene oxidation induced with direct glow discharge plasma

A plasma induced degradation process has been studied to treat 4-nitrotoluene (4-NT) present as an aqueous pollutant. The plasma was locally generated from a glow discharge around a tip of a platinum anode in an electrolytic solution. The influence of initial pH and Fe²⁺ on the degradation was examined. Major intermediates resulting from the degradation process were identified. Amongst the aromatic intermediates, p-hydroxybenzoic acid was the predominant degradation product. The formation of oxalic acid, malic acid was also observed. The final products of degradation were NH ₄ ⁺ , NO ₃ ⁻ and CO₂. Based on the analysis of intermediates and the kinetic considerations, the degradation was shown to follow a pseudo-first order reaction hence, a possible reaction pathway was proposed.     

Preparation of a set of selectively protected disaccharides for modular synthesis of heparan sulfate fragments: toward the synthesis of several <Emphasis Type="Italic">O</Emphasis>-sulfonated [β-D-GlcUA-(1→4)-β-D-GlcNAc]OPr types

A concise method for a stereocontrolled synthesis of a set of selectively protected disaccharides is reported. Coupling of the donor 11 onto acceptors 23 and 24, promoted by trimethylsilyl triflate-N-iodosuccinimide (TMSOTf-NIS), generated the disaccharides 25 and 26. Under typical conditions, condensation of the fully protected donor 12 onto acceptors 23 and 24 produced the disaccharides 27 and 28. The building blocks 25–28 were prepared in moderate yields having exclusive β-stereoselectivity. A unique pattern of protecting groups distinguished clearly between positions to be sulfated and functional groups remaining as free hydroxyl groups. Acetyl and/or levulinoyl esters temporarily protected the positions to be sulfated, while benzyl ethers were used for permanent protection. The anomeric positions were protected as allyl ethers, whereas the 4′-positions were masked as p-methoxybenzyl (PMB) ethers. The orthogonality of the PMB and allyl groups can then be used for further elongation of the chain by recurrent deprotection and activation steps. The hydroxyl group, OH-6, of glucosamine moieties was protected as a TBDPS ether to avoid oxidation. A five-step deprotection/sulfonation sequence was applied to the disaccharide 27 to generate the corresponding sulfated [β-D-GlcUA-2-OSO₃Na-(1→4)-β-D-Glc pNAc]-(1→O-Pro) 34.     

Optimization of the design and operation of FAIMS analyzers

Field asymmetric waveform ion mobility spectrometry (FAIMS) holds significant promise for post-ionization separations in conjunction with mass-spectrometric analyses. However, a limited understanding of fundamentals of FAIMS analyzers has made their design and operation largely an empirical exercise. Recently, we developed an a priori simulation of FAIMS that accounts for both ion diffusion (including anisotropic components) and Coulomb repulsion, and validated it by extensive comparisons with FAIMS/MS data. Here it is corroborated further by FAIMS-only measurements, and applied to explore how key instrumental parameters (analytical gap width and length, waveform frequency and profile, the identity and flow speed of buffer gas) affect FAIMS response. We find that the trade-off between resolution and sensitivity can be managed by varying gap width, RF frequency, and (in certain cases) buffer gas, with equivalent outcome. In particular, the resolving power can be approximately doubled compared to "typical" conditions. Throughput may be increased by either accelerating the gas flow (preferable) or shortening the device, but below certain minimum residence times performance deteriorates. Bisinusoidal and clipped-sinusoidal waveforms have comparable merit, but switching to rectangular waveforms would improve resolution and/or sensitivity. For any waveform profile, the ratio of two between voltages in high and low portions of the cycle produces the best performance.     

Study on the interaction between nucleic acids and cationic surfactants

The interactions of nucleic acids and cationic surfactants (cetylpyridine bromide (CPB) and cetyltrimethylammonium bromide (CTMAB)) in aqueous solution have been studied using the techniques of resonance light scattering (RLS) spectroscopy, the absorption spectroscopy, zeta potential assay and NMR assignment measurement. It is considered that CPB or CTMAB can assemble on the surface of nucleic acid via electrostatic and hydrophobic forces, which results in the formation of large associate of nucleic acid-cationic surfactant and RLS enhancement of nucleic acid. Besides these forces, the pi-pi stacking force between CPB and nucleic acid also exists in the associate. In comparison with CTMAB, CPB has larger enhancement on RLS of nucleic acid, which is attributed to that the enhancement of the former is only due to the absorption of the bases of nucleic acid, while the enhancement of the latter is own to the synergetic resonance caused by the absorption of both bases of nucleic acid and the pyridyl in CPB. These results have important implication for understanding the influence of surfactants on nucleic acid functionality in life science.     

Structure-direct assembly of hexagonal pencil-like ZnO group whiskers

Hexagonal ZnO group whiskers synthesized from Zn(NH₃)₄²⁺ precursor at 145°C in a structure-directing template solvent (2.5% v/v alcohol) show strong photoluminescence at 409 and 420 nm. FE-SEM and TEM observation reveals that the ZnO group whiskers consist of uniform pencil-like whiskers with the diameter of around 1.5 μm and the length of up to 6 μm.     

Characterization and electrochemical investigation of boron-doped mesocarbon microbead anode materials for lithium ion batteries

The structure and anodic performance of boron-doped and undoped mesocarbon microbeads (MCMBs) have been comparatively studied and the results obtained by XPS, XRD, SEM, Raman spectroscopy and electrochemical measurements are discussed. It is found that boron doping introduces a depressed d ₀₀₂ spacing and the larger amount of "unorganized carbon", which induces vacancy formation in the graphite planes and leads to a quite different morphology from that of the undoped material. Electrochemical charge/discharge cycle tests indicated that after boron doping the lithium intercalation was carried through at a somewhat higher potential, being attended by greater irreversible capacity loss. Electronic Publication     

含环氧端基酚酞聚芳醚酮E-PEK的合成及表征

由酚酞和4,4′-二氯二苯酮经亲核缩聚制得了一系列不同分子量的含—OK端基的聚醚酮低聚物,将其与环氧氯丙烷反应得到了分子量为1000～8000的含环氧端基聚芳醚酮(E-PEK)。用IR和~1H NMR表征了E-PEK的分子链结构,测定了T_g、溶解性和熔融粘度。研究了E-PEK/DDE体系的固化,固化后树脂的T_(g∞)=183～215℃,与低聚物的初始分子量有关。