NO Release from trans-[Ru(NH3)4L(NO)]3+ Complexes Upon Reduction (L = 1-Methylimidazole or Benzoimidazole)

The synthesis, characterization and reactivity of trans-[Ru(NH₃)₄(L)NO](PF₆)₃(L = benzoimidazole or 1-methylimidazole in trans position to NO) are presented. ¹H-n.m.r. spectroscopy data indicate that the benzoimidazole and 1-methylimidazole ligands are coordinated to Ru^II through carbon and nitrogen, respectively. The nitrosyl stretching frequencies [(NO) > 1900 cm^–1] suggest that the coordinated nitrosyl has substantial NO⁺ character. The complexes undergo a single-electron reduction (E ⁰–0.245 versus NHE), which involves the coordinated nitrosyl. Dissociation of NO in the reduced species is facilitated by the 1-methylimidazole ligand, which is not observed for the benzoimidazole species. The complex with 1-methylimidazole does not suffer hydroxide attack on the NO⁺, at least at pH values lower than 11.     

Solid-phase fluorescence spectroscopy for the determination of acetylsalicylic acid in powdered pharmaceutical samples

A rapid, simple and rugged procedure without requiring any prior sample treatment was developed for the determination of acetylsalicylic acid (ASA) in tablets formulations by solid-phase fluorescence spectroscopy. The method was carried out on powdered samples, consisting of an active substance dispersed in lactose, maize starch, talc and magnesium stearate. Previous knowledge of the sample bulk composition is needed for proper application of the method. Wavelengths for maximum excitation and emission were 288 and 318 nm, respectively, and the fluorescence intensity was linear with ASA concentration within the 50-170 mg g⁻¹ range. Detection and quantification limits were 2.2 and 7.3 mg g⁻¹, and the analytical frequency was 200 h⁻¹. For a typical sample, the relative standard deviation of results was estimated as 2.3% (n = 10). Accuracy was assessed by comparing the analytical results obtained with the proposed method with those related to a reference method recommended by British Pharmacopoeia: no differences between the methods were found at the 95% confidence level.     

Performance of a sound card as data acquisition system and a lock-in emulated by software in capillary electrophoresis

The performance of fluorescence detectors in capillary electrophoresis is maximized when the excitation light intensity is modulated in time with optimal frequencies. This is especially true when photomultiplier tubes are used to detect the fluorescent light. The photomultiplier tube amplified raw output signal can in principle be captured directly by a personal computer sound card (PCSC) and processed by a lock-in emulated by software. This possibility is demonstrated in the present work and the performance of this new setup is compared with a traditional data acquisition system. The results obtained with this “PCSC and lock-in emulated by software” were of the same quality or even better compared to that obtained by conventional time integrators (Boxcars) and data acquisition boards. With PCSC the limits of detection (LOD) found for both naphthalene-2,3-dicarboxaldehyde-derivatized tyrosine and alanine were 3.3 and 3.5 fmol (injection of 5 nL of samples at 0.66 and 0.70 μmol/L), respectively. This is at least three times better compared to conventional systems when light emitting diodes (LEDs) are used as the excitation source in fluorescence detectors. The PCSC linear response range was also larger compared to conventional data acquisition boards. This scheme showed to be a practical and convenient alternative of data acquisition and signal processing for detection systems used in capillary electrophoresis.     

31P{1H}-n.m.r. as a tool for identification of ruthenium isomers containing PPh3 or 1,4-bis(diphenylphosphino)butane ligands. X-ray structures of the cis-{RuCl2(PPh3)2 [4,4′-(-X)2-2,2′-bipy]} complexes [X=-H, -Me, -SMe and (-Cl, -Me)]

A series of cis-{RuCl₂(PPh₃)₂[4,4-(X)₂-2,2-bipy]} [cis-chlorines; X=-H, -Me, -SMe, and (-Cl,-Me)] complexes have had their structures determined by single crystal X-ray diffraction. The geometry of these complexes, also determined in CH₂Cl₂ solution by ³¹P{¹H}-n.m.r. spectroscopy, showed that the chemical shifts for the phosphorus atoms are slightly dependent on the pKa of the 4,4-(-X)₂-2,2-bipy ligands.     

Titanium as a chemical modifier for the determination of cobalt in marine sediments

The determination of cobalt in marine sediments by electrothermal atomic absorption spectrometry was studied using no modifier and magnesium and titanium as modifiers. Titanium is one of the major sediment constituents, which widely affects the cobalt determination and it was studied as a chemical modifier since it was the only concomitant that increased the cobalt signal in the concentration range usually found in sediments. The performance of Mg and Ti as chemical modifiers was compared relative to maximum pyrolysis and atomization temperatures, linear calibration range, sensitivity and matrix effects. The pyrolysis curves showed that the analyte could be stabilized up to 1400 °C when either Ti or Mg(NO₃)₂ was present, while only 1000 °C could be used in the absence of a modifier. The optimum atomization temperature was 2500 °C in all cases. Analytical curves were compared using no modifier, 5 μg Ti and 100 μg Mg(NO₃)₂ as modifiers, and the linear range found was up to approximately 4 ng Co whether a modifier was used or not. With Ti as a chemical modifier, analytical curves for cobalt in aqueous solution and in a synthetic matrix resulted in the same sensitivity (m₀=55 pg), whereas the use of Mg led to characteristic mass values of 59 and 72 pg in aqueous solution and in a synthetic matrix, respectively, showing some matrix effect. The detection limits (3σ, n=10) were 0.4 μg g⁻¹ using no modifier and 0.3 μg g⁻¹ with Ti as a modifier in the original matrix. A reference estuarine sediment NIST 1646 with a non-certified content of 10.5 μg g⁻¹ Co was analyzed and the found value of 10.9±2.4 μg g⁻¹, (n=3), using Ti as chemical modifier and calibration against aqueous standards, was in good agreement with the recommended value.     

EPR spectroscopy on irradiated nickel tetracyanide in NaCl host lattice: mechanism for the simultaneous formation of reduced and oxidized species

The kinetics of oxidized and reduced Ni²⁺ complexes produced by X-ray irradiation on single crystals of NaCl doped with [Ni(CN)₄]²⁻ is studied by Electron Paramagnetic Resonance at room temperature. The interdependent generation of these two complexes is attributed to migration of the charge compensating vacancy from the reduced to the oxidized complex in a reversible reaction. At higher X-ray doses, there is a predominant formation of the reduced complex.     

Mechanism for basic hydrolysis of N-nitrosoguanidines in aqueous solution

A kinetic study was carried out on the hydrolysis of two N-nitrosoguanidines, 1-nitroso-1-methyl-3-tolylsulfonylguanidine (TSGNO) and 1-nitroso-1-methyl-3-benzoylguanidine (BCGNO). We observed an absence of buffer catalysis using H(2)PO(4)(-)/HPO(4)(2)(-), H(3)BO(3)/H(2)BO(3)(-), and HCO(3)(-)/CO(3)(2)(-) regulators and a complex dependency of the rate constant on the pH. We discovered the existence of three simultaneous reaction paths: spontaneous decomposition of the neutral form of the N-nitrosoguanidine, decomposition of the monoanion, and decomposition through the form of the dianion. The analysis of the kinetic data has allowed us to obtain the acidity constant for the formation of the monoanion of the N-nitrosoguanidine, with values of p = 11.5. The reaction rate for the process through the monoanion, k(2), decreases as the acidity increases. The application of the principle of nonperfect synchronization shows that the basicity and reactivity do not correlate when there exists a possibility of stabilization of the negative charge by resonance. This behavior is consistent with the mechanism E1cB whereby the stabler the negative charge, the slower the elimination reaction. When dealing with the case of the elimination through the neutral form we observe that the reaction rate increases together with the capacity of stabilization of the positive charge on the nitrogen atom adjacent to the imino group. For the reaction through the dianion we used a maximum value of k(3) = 10(10) s(-)(1) to estimate the value of p for the formation of the dianion of the N-nitrosoguanidine, obtaining values of p < 24.     

Hydrolysis of new phthalimide-derived esters catalyzed by immobilized lipase

The last step of the production of four phthalimide-derived acids, designed to act as antiasthma drugs, was performed by enzymatic hydrolysis of the respective methyl or ethyl esters. The esters 4-ethyl-[2-(1,3-dioxo-1,3-dihydro-2-isoindoylyl)]-phenoxyacetic methyl ester (PHT-MET), 4-ethyl-[2-(1,3-dioxo-1,3-dihydro-2-isoindoylyl)]-phenoxyacetic ethyl ester, 4-(1,3-dioxo-1,3-dihydro-2-isoindoylyl)-phenoxyacetic ethyl ester, and 2-(1,3-dioxo-1, 3-dihydro-2-isoindoylyl)-phenoxyacetic ethyl ester were hydrolyzed by immobilized lipase. The enzymatic reaction could be used only to produce the desired 4-substituted compounds. The best result that was found to hydrolysis of PHT-MET, and, therefore, that ester was selected for optimization experiments in a three-phase system. Reactions were performed with solid biocatalyst (Lipozyme® RM IM), organic solvent phase (ethyl acetate), and aqueous phase (saturated Na₂CO₃ solution). To optimize the reaction conditions, an experimental design optimization procedure was used. The variables studied were the amount of enzyme, the temperature, and the volume of the aqueous solution. Time course experiments were then performed for different initial enzyme concentrations (0.5, 0.9, and 1.4 U_H/mL of solvent). The optimized reaction conditions found were 20 mg of Lipozyme (0.9 U_H/mL_solvent) and 5.0 mL of Na₂CO_3(sat) at 40°C for 6 h.