矿化剂对铝酸钙粉的结构与光谱性能的影响

研究了矿化剂对制备铝酸钙粉的结构与性能的影响.研究中以铝矾土和石灰石为原料,加入一定量的矿化剂,混合均匀,经高温煅烧制得铝酸钙粉.借助于红外光谱、X射线粉末衍射、差热-热重分析等手段对不同原料的铝酸钙粉的结构、组成及性能进行了表征和研究,并对矿化剂在合成铝酸钙中的矿化机理进行探讨.研究表明:加入矿化剂后,可在更低温度条件下煅烧制备出铝酸钙粉,有利于节能减排.红外光谱分析、XRD分析、DTA-TG分析显示:未加矿化剂煅烧时,生成的产物主要是Ca3Al10O18,CaAl2Si2O8.加入矿化剂后煅烧生成的产物主要是易浸出Al2O3的CaAl3BO7和Ca3Al10O18,而不易浸出Al2O3的CaAl2Si2O8的含量大大降低.同时显示,加入矿化剂后,原料中的方解石(CaCO3)分解更容易;CaCO3与铝矾土反应更充分;更有利于促使铝矾土中的Al-Si键断裂,将铝矾土中的Al释放出来;并可降低铝酸钙的煅烧温度.研究还显示:加入矿化剂后,可以改变原产物的晶体结构与成分,有利于降低煅烧反应温度.     

庆大霉素与水溶性CdTe量子点的荧光共振能量转移作用

以巯基丙酸(mercaptopropionic acid,MPA)为稳定剂合成水溶性CdTe最子点(quantum dots,QDs),以CdTe QDs作为能量供体.庆大霉素(Gentamycin,GT)作为能垦受体,建立了荧光共振能量转移(fluorescence resonance energy transfer,FRET)体系.在690 nm处可见发射峰,半峰宽约10 nm,在一定范围内荧光强度与GT的含量旱线性关系,线性范围为2～20 mg·L-1,相关系数r=0.986 7.优化了不同的激发波长、pH、离子强度、时间和温度等凼素对反应的影响,并应用傅里叶变换红外光谱(Fourier transform infrared spectroscopy,FTIR)和高效液相色谱(high-performance liquid chromatography,HPLC)分别表征了化学结构和相对专一性.结果表明巯基丙酸的巯基中S原子和羧基中氧原子与纳米微粒表面的富Cd离子发生了配位作用,CdTe QDs与GT的耦合主要是通过量子点周围巯基丙酸羧基(-COOH)中的氧原子与GT的胺基(-NH2)形成分子问氧键实现的;GT与CdTe QDs的结合率为0.35:1.研究表明GT可以作为检测CdTe QDs标记牛血清白蛋白(bovine serum albumin,BSA)的荧光增敏剂,荧光强度值增强6倍,应用前景广阔.     

ICP等离子体鞘层附近区域发光光谱特性分析

为了独立控制鞘层附近区域离子密度和离子能最分布,采用光发射谱(OES)测量技术,对不同射频功率、放电气压和基底偏压下感应耦合等离子体鞘层附近区域辉光特性进行了研究.原子谱线和离子谱线特性分析表明,在鞘层附近区域感应耦合等离子体具有较高的离子密度和较低的电子温度.改变放电气压和射频功率,对得到的光谱特性分析表明,鞘层附近区域离子密度随射频功率的增大而线性增大,在低压下随气压的升高而增大.低激发电位原子谱线强度增加迅速,高激发电位原子谱线强度增加缓慢,而离子谱线强度增加很不明显.改变基底直流偏压,对得到的发射光谱强度变化分析表明,谱线强度随基底正偏压的增加而增大.随着基底负偏压的加入,谱线强度先减小而后增大;直流偏压为-30 V时,光谱强度最弱.快速离子和电子是引起Ar激发和电离过程的主要能量来源.     

Numerical studies of penetration problems by an improved particle method

A particle mapping transportation algorithm was proposed on the basis of the particle-in-cell method.The particles with rectangular influence domains were employed in the transportation algorithm to reduce the numerical fluctuations.Based on the error analysis in the process of particle motion computation,a prediction-correction algorithm was introduced to improve the computational accuracy.Furthermore,the performance of the particle mapping transportation method was evaluated by using the rotation,the slotted disk and the shear advection tests,and the results were compared with other interface reconstruction methods.Finally,the hemispherical projectile penetration into a steel target was numerically simulated.The results showed that the proposed method produced less numerical fluctuations and exhibited clear material interfaces,which indicated that it is accurate and effective.     

超导材料的各向异性特征与超导转变温度T_c

在本文中,以电声子机制超导电性理论为基础,用电负性均衡原理研究了由于超导材料的各向异性引起的电子态密度分布的不均匀性,晶格稳定性的差异性及超导材料中元素成键特征对超导转变温度影响的特征,提出了在各向异性的超导材料中电声子机制可以产生高的超导转变温度Tc.     

Precision position measurement of single atom

Atom localization in a five-level atomic system under the effect of three driving fields and one standing wave field is suggested. A spontaneously emitted photon from the proposed system is measured in a detector. Precision position measurement of an atom is controlled via phase and vacuum field detuning without considering the parity violation.     

Primary result of ~(236)U measurement with accelerator mass spectrometry at CIAE

The rare isotope 236U has a half-life of 2.342(3)×107 years,and is produced principally by thermal neutron capture on 235U.The isotopic atom ratio of 236U/238U depends on the integral thermal neutron flux received by the material of interest.236U is potentially useful as a fingerprint for indicating the presence of neutron-irradiated uranium usually originating from nuclear activity.By extracting negative molecular ion UO- from the uranium oxide target,simulating the 236U16O- beam transport with 238U16O- an...     

First experimental research of the bunch compressor at CAEP

Magnetic bunch compressor is one of the key technologies on the path to next generation accelerator driven facilities. In this paper we report the design principles and the first experimental research of the bunch compressor developed at Chinese Academy of Engineering Physics （CAEP）. The length of the bunch after compressor is found to be about 0.7 ps （rms） and the peak current exceeds 500 A when operated in the optimized condition. The sensitivity of the bunch length on the phase of the acceleration field and magnetic field of the bunch compressor was also measured and analyzed.     

Instrumentation of coherent X-ray imaging and the primary experimental results

Coherent X-ray microscopy has advanced towards higher-energy, more brilliant sources over the past decade since its demonstrations, and many advancements have been made towards optimizing this imaging technique. Here we present both the experimental instrument for obtaining diffraction patterns and the primary reconstruction of yeast cell 2D projection. In addition, the characteristics of the existing optics at BL29XUL of SPring-8 Facility and the method of image reconstruction are discussed.