Multistep mass spectrometry of heterocyclic amines in a quadrupole ion trap mass analyser

The fragmentation of heterocyclic amines (HAs) in an ion trap was studied by means of the infusion of methanolic solutions containing the compounds under assay, and using an atmospheric pressure chemical ionization (APCI) as ion source. The MS(n) spectra obtained for compounds included in the same family, either aminoimidazoazaarenes (AIAs) or carbolines, were compared in order to propose fragmentation pathways for each HA. Moreover, labelled AIAs were used to establish the mechanisms. The protonated molecule was always obtained, but subsequent fragmentation was different for both families. In the case of AIAs, major product ions came from the fragmentation of the aminoimidazole moiety, thus the base peak in MS(2) corresponded to the loss of the methyl group, and losses of C(2)NH(3) and CN(2)H(2) were also observed. Further fragmentation occurred in the heterocyclic rings, mainly with losses of HCN and CH(3)CN. For carbolines, the most important product ions came from the loss of ammonia, except for harman and norharman, the loss of a methyl group for methylated carbolines or the loss of diverse fragments from the heterocyclic rings. In some cases, ion-molecule reactions into the ion trap were observed. For instance, for AalphaC or MeAalphaC one ion originating from these reactions corresponded to the base peak.     

Simple Method for Simultaneous Determination of Selenium and Arsenic in Human Hair by Means of Atomic Fluorescence Spectrometry with Hydride Generation Technique

This study describes a simple, rapid and reliable method for simultaneous determination of selenium and arsenic in human hair by means of atomic fluorescence spectrometry combined with a hydride generation technique (HG-AFS). The procedure developed encompasses microwave digestion of a sample in the nitric acid environment only. The interferences caused by nitrous oxides are eliminated by removing a gas from above the digested solution with a stream of argon. The sample is then chemically treated in a flow-through hydride generation system and exposed to measurements in a double-channel atomic fluorescence spectrometer. The method permits determining both analytes in the linear range of 0.5–100µgL^–1 with a detection limit equal to 0.2µgL^–1, as well as with very good repeatability not exceeding 1% for Se and 2% for As. No mutual interferences from either of the analytes in the concentrations ranges matching the hair composition were found. The method was verified in terms of accuracy with the use of a reference material and then applied to the analysis of the natural samples of human hair.     

Carboxylate-bridged copper(II)-lanthanide(III) complexes [(Cu(3)Ln(2)(oda)(6)(H(2)O)(6)).12H(2)O](n)(Ln = Dy,Ho, Er,Y; oda = oxydiacetate)

The hydrothermal reaction of Ln(2)O(3) (Ln = Dy and Ho), Cu(OAc)(2).2H(2)O, and oxydiacetic acid in the approximate mole ratio of 1:3:8 resulted in the formation of two new members of the isostructural series of polymers formulated as [(Cu(3)Ln(2)(oda)(6)(H(2)O)(6)).12H(2)O](n), crystallizing in the hexagonal crystal system, space group P6/mcc (No. 192). Temperature-dependent magnetic susceptibilities and EPR spectra are reported for the heterometallic compounds Cu-Dy 1, Cu-Ho 2, Cu-Er 3, and Cu-Y 4. The results are discussed in terms of the structure of the compounds, the electronic properties of the lanthanide ions, and the exchange interactions between the magnetic ions.     

ICP-MS multi-element analysis of wine samples - a comparative study of the methodologies used in two laboratories

A comparison of the performance of the methodologies used in two distinct laboratories (Lab A and Lab B) for multi-element analysis in different wines was carried out. ICP-MS apparatus (quadrupole mass analyzers) of different brands as well as different wine pre-treatments were used. At Lab A, a pre-treatment by UV-irradiation was performed. At Lab B, a micro-concentric nebulizer was used for direct analysis of the wine. Twenty-six elements (Li, V, Co, Ni, Cu, Zn, Ga, As, Rb, Sr, Ba, La, Ce, Pr, Nd, Sm, Eu, Gd, Tb, Dy, Ho, Er, Tm, Yb, Lu, and Pb) were measured in common at the two labs in three different wine samples (red and white Bordeaux table wines and Port wine) and the results were compared. The two methodologies provided similar LODs and similar precisions, with RSDs of 0.5-5%, for most of the elements. The recovery percentages were 85-120% at Lab A for the three wines, and 78-119% at Lab B for the Bordeaux wines, validating the accuracy of the methods used. Comparable results were obtained at both labs for ten elements (Li, V, Co, Ni, Cu, Zn, Rb, Sr, Ba, and Pb) in the three selected wines; the differences were lower than 10% in most cases. For REEs, the differences observed were slightly higher, but still in the acceptable range due to the sub-ppb levels involved. The results obtained for As and Ga were not comparable, due to methodological influence. A comparison through linear least-squares adjustment indicated that the results obtained by the two labs were linearly correlated (correlation coefficient =0.997) but statistically different as the slope was slightly, but significantly different from one, for a confidence level of 95% (the intercept was statistically identical to zero in any case). In the future, strictly more identical results can be achieved by using a reference wine sample.     

Influence of aromatic substituents on metal(II)salen catalysed, asymmetric synthesis of α-methyl α-amino acids

The influence of substituents on both the aromatic rings of the catalyst, and the benzylidene unit of the substrate are investigated in the (salen)copper(II) catalysed asymmetric benzylation of alanine derivatives. Catalysts with electron-donating, and electron-withdrawing substituents of various sizes and at various locations on the aromatic rings of the salen ligand were prepared, but all exhibited inferior enantioselectivity to the parent (salen)copper(II) complex. In contrast, the introduction of halogenated substituents onto the aromatic ring of the N-benzylidene alanine methyl ester substrate was found to enhance the enantioselectivity of the alkylation with a para-chloro substituent giving optimal results. A new procedure for the preparation of the catalysts which avoids the need for chromatography on sephadex LH20 is reported, and the optimal catalyst obtained in this way was found to be a cobalt(salen) complex.     

Morphological and structural characteristics of diazo dyes at the air-water interface: in situ Brewster angle microscopy and polarized UV/vis analysis

A morphological analysis is presented for Langmuir films of the diazo dyes Sudan 4 (S4), Sudan 3 (S3), and Sudan red (SR), using Brewster angle microscopy. Stable nonmonomolecular structures are formed at the air-water interface denoted as a plateau in the pressure-area isotherms. Monolayer domains are evident by the contrastless image even before the pressure onset, which grow in size until it reached a condensed monolayer. This behavior resembles that of Langmuir films from simple aromatic fatty acids. Films from all the azo dyes display similar features, according to the surface potential isotherms and in situ polarized UV/vis spectroscopy except for the larger area per molecule occupied by S4 and SR. This is attributed to the presence of CH(3) groups that cause steric hindrance modifying the organization of diazo dye molecules at the air-water interface. UV/vis polarized absorption spectroscopy showed preferential orientation of S4 and S3 on the water surface, while SR molecules lie isotropically. For these three diazo dyes, film absorption was negligible at very large areas per molecule, becoming nonzero only at a critical area coinciding with the onset of surface potential. The critical area is ascribed to the formation of a H-bonded network between water molecules and diazo dye headgroups.     

SKIN DAMAGE IN ADULT AMPHIBIANS AFTER CHRONIC EXPOSURE TO ULTRAVIOLET RADIATION

Abstract— The effects of repeated UV exposure on the skin of the European crested newt, Triturus cristatus carnifex , have been investigated. The animals were irradiated 3 times per week with a Westing-house FS40T12 fluorescent sun lamp (wavelength spectrum 275–350 nm). Two groups of animals received the same total fluence of 1.3 × 10⁵ J/m² in single fluences of either 1570 J/m² (group A) or 9430 J/m² (group C), and one group received a total fluence of 2.6 × 10⁵ J/m² in single fluences of 4710 J/m² (group B). All the animals were killed 7 months after the first UV exposure, but at different intervals after the last exposure. Striking epidermal hyperplasia was found in the newts irradiated at the lower fluence rate (group A). In the animals given the higher total fluence (group B), the most prominent skin changes were dermal fibrosis and irregular thinning and thickening of the epidermis. No significant skin changes were found in group C., in which if there had been UV lesions, they had been repaired during the 5 month interval between the last irradiation and the killing of the animals. No skin tumors developed in any experimental group.     

Synthesis and Characterization of Monomeric Aryloxo Palladium Complexes of the Type [Pd(N–N)(OAr)(C6F5)]. Crystal Structure of [Pd(tmeda)(C6F5)(OC6H4NO2‐p)]

Mononuclear palladium‐hydroxo complexes of the type [Pd(N–N)(C₆F₅)(OH)][(N–N) = 2,2′‐bipyridine (bipy), 4,4′‐dimethyl‐2,2′‐bipyridine (Me₂bipy), 1,10‐phenantroline (phen) or N,N,N′,N′‐tetramethylethylenediamine (tmeda) react with phenols ArOH in tetrahydrofuran giving the corresponding aryloxo complexes [Pd(N–N)(C₆F₅)(OAr)]. Elemental analyses and spectroscopic (IR, ¹H and ¹⁹F) methods have been used to characterize the new complexes. The X‐ray crystal structure of [Pd(tmeda)(C₆F₅)(OC₆H₄NO₂‐p)] has been determined. In the crystal packing the planes defined by two C₆H₄ rings show a parallel orientation. There are also intermolecular C–H···F and C‐H···O hydrogen bonds.     

Spectrophotometric determination of selenium(IV) with 5,5-dimethyl-1,3-cyclohexanedione

5,5-Dimethyl-1,3-cyclohexanedione (dimedone) reacts in acid aqueous solution with selenium(IV) to give a benzoxaselenol which has an absorption maximum at 313 nm with a molar absorptivity of 4.00 x 10(3) l.mole(-1).cm(-1). The compound is extractable into chloroform, to give a solution with an absorption maximum at 300 nm with a molar absorptivity of 3.77 x 10(3) l.mole(-1).cm(-1). The calibration graph is linear up to 30 ppm selenium, with a detection limit of 0.1 ppm in the final solutions. Of the various other ions tested, only iron(III) interferes at all concentrations but the addition of 1000 ppm fluoride will mask 50 ppm Fe(3+). The method has good reproducibility, with a relative standard deviation of 1.0% for pure solutions. The method has been applied to the analysis of fire-refined copper.