Synthesis, thermal treatment and characterization of cobalt ferrite-based nanocomposites

We have used time-differential perturbed angular correlation (PAC) spectroscopy with ¹⁸¹Ta-probes to study the electric field gradient at Zr-sites in synthetic zircon and hafnon between room temperature and 1,200°C. PAC spectra are similar to those obtained from naturally occurring zircons. In particular, a change in slope of the quadrupole coupling vs. temperature is observed in the synthetic zircon at the same temperature as seen in natural zircons from the Mud Tank carbonatite (Australia). The synthetic hafnon data also shows this feature but at somewhat higher temperature. Low-temperature PAC spectra of both synthetic zircon and hafnon have a clearly reduced anisotropy. We believe that the cause for this is a electronic defect, possibly created during the β-decay of the probe parent nucleus.     

Hybrid free radical/cationic frontal photopolymerizations

The irradiation of hybrid photopolymer systems consisting of a free radically polymerizable multifunctional acrylate monomer and a cationically polymerizable epoxide or oxetane monomer was conducted under conditions where only the free radical polymerization takes place. This results in the formation of a free‐standing polyacrylate network film containing quiescent oxonium ions along with the unreacted cyclic ether monomer. The subsequent application of a point source of heat to the film ignites a cationic ring‐opening frontal polymerization that emanates from that site and propagates to all portions of the irradiated sample. This article examines the impact of various molecular structural and experimental parameters on these novel hybrid frontal polymerizations that produce interpenetrating network polymers. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4331–4340, 2007     

A refined stress-strain analysis in the load transfer zone of flat specimens of high-strength unidirectional composites in uniaxial tension 1. Theoretical analysis

With the use of an analytical approach developed, the influence of distribution of a tangential load on the stress concentration in uniaxially tensioned flat specimens of high-strength unidirectional composites near the grips of a testing machine is evaluated. In view of singularity of the analytical solution derived at the points of discontinuity of boundary conditions, for estimating the stress concentration, it is suggested to employ the averaged value of longitudinal stresses, which is calculated by means of an improper integral across the thickness of a near-surface layer. __________ Translated from Mekhanika Kompozitnykh Materialov, Vol. 42, No. 6, pp. 787–796, November–December, 2006.     

Asymptotic estimation of states of linear nonautonomous systems with scalar output

For a linear nonautonomous system with one output, the existence conditions for an identifier that estimates the current state with exponential rate are established. An algorithm for constructing such an identifier is described and its dependence on small perturbations of coefficients is studied.     

Transport properties of polyphenylquinoxalines

The correlation between chemical structure and gas transport properties is considered for a new class of membrane materials based on structurally similar polyphenylquinoxalines that are characterized by different numbers of flexible-O-ether bonds in the repeating unit and different chain rigidities. Permeability, diffusion, and solubility coefficients have been estimated for the gases H₂, He, O₂, N₂, CO, CO₂, and CH₄; separation factors for various gas pairs have been determined. For the materials with a similar level of cohesive energy density, which characterizes interchain interactions, permeability decreases with a decrease in chain rigidity, whereas selectivity of gas separation increases.     

Electronic structure and elastic moduli of the simple cubic fullerite C24—A new allotropic carbon modification

The energy band structure, equation of state, density of states, and elastic moduli of a new allotropic carbon modification, namely, fullerite C₂₄ with a simple cubic lattice (known previously as cubic graphite), are calculated by the full-potential linearized augmented-plane-wave (FLAPW) method with geometry optimization for the first time. The dependence of the total energy on the lattice constant exhibits a minimum for a ₀ = 0.60546 nm. In this case, the lengths of the C-C bonds between fullerene molecules, the lengths of the 6,6-bonds shared by hexagons, and the lengths of the 4,6-bonds shared by a square and a hexagon are equal to 0.1614, 0.1503, and 0.1637 nm, respectively. An analysis of the energy band structure and the density of states demonstrates that the simple cubic fullerite C₂₄ is a direct-band-gap insulator or a semiconductor with a band gap of 1.6 eV. The calculated bulk modulus B ₀ = 196 GPa and the elastic moduli C ₁₁ = 338 GPa, C ₁₂ = 139 GPa, and C ₄₄ = 30 GPa indicate that the fullerite under investigation is a mechanically stable material. The inference is made that the simple cubic fullerite C₂₄ is a new diamond-like molecular zeolite with a unique combination of properties, such as the porosity and nonpolarizability, on the one hand, and the mechanical strength, chemical inertness, and high thermal conductivity, on the other hand. The simple cubic fullerite C₂₄ can be considered a promising low-dielectric-constant (low-k) material (?₀ < 5.7) for use in fabricating interconnections and substrates intended for integrated circuits and nanoelectronics.     

Propagation of a focused light beam in a circuital system of tunnel-coupled waveguides

The propagation of a pencil beam in a circuital system of tunnel-coupled waveguides is considered. It is shown that the beam periodically focuses into a point when moving along the trajectory. A maximal number of waveguides supporting the propagation of the beam can be estimated in simple terms. The cross-sectional area of the waveguides can be subdivided into three zone with the beam pulsing only in the central one.     

Nonlinear-optical and micro-Raman diagnostics of thin films and nanostructures of ABO3 ferroelectrics

Ferroelectric composite two-dimensional ferroelectric/aluminum oxide nanostructures were studied. A porous aluminum oxide matrix was used as a template into which a ferroelectric precursor was introduced, followed by annealing. The prepared nanostructures were studied using optical second harmonic generation and micro-Raman scattering.