ESR study of Mn2+ in GeTe and GeTeSi glasses

The electron spin resonance spectra of Mn²⁺ ions have been studied in Ge_xTe_100?x with x = 15, 17.5 and 20, and Ge_20?xTe₈₀Si_x with 0 ?x? 20. All samples are found to exhibit six hyperfine lines centered at g = 4.3 with hyperfine interaction constant A = 56 × 10^?4cm^?1. The g = 4.3 line is interpreted as being caused by Mn²⁺ ions incorporated in the amorphous network and surrounded by four Te atoms in an arrangement of orthorhombic symmetry. Some of the samples of GeTe show a g = 2.0 line. This line also appears after heat treatment in air at temperatures above the glass transition temperature. It is concluded that the g = 2.0 line is caused by Mn²⁺ ions in phase separated microcrystalline or concentrated regions of MnO in the glass.     

Numerical analysis of dipole sound source around high speed trains

As the maximum speed of high speed trains increases, the effect of aeroacoustic noise on the sound level on the ground becomes increasingly important. In this paper, the distribution of dipole sound sources at the bogie section of high speed trains is predicted numerically. The three-dimensional unsteady flow around a train is solved by the large eddy simulation technique. The time history of vortices shows that unstable shear layer separation at the leading edge of the bogie section sheds vortices periodically. These vortices travel downstream while growing to finally impinge upon the trailing edge of the section. The wavelength of sound produced by these vortices is large compared to the representative length of the bogie section, so that the source region can be regarded as acoustically compact. Thus a compact Green's function adapted to the shape can be used to determine the sound. By coupling the instantaneous flow properties with the compact Green's function, the distribution of dipole sources is obtained. The results reveal a strong dipole source at the trailing edge of the bogie section where the shape changes greatly and the variation of flow with time is also great. On the other hand, the bottom of the bogie section where the shape does not change, or the leading edge and boundary layer where the variation of flow with time is small, cannot generate a strong dipole source.     

New microporous coordination polymer affording guest-coordination sites at channel walls

Utilization of a metalloligand, ([Cu(2,4-pydca)2(H2O)].2Et3NH) (1) (2,4-pydca = pyridine-2,4-dicarboxylate), as a building unit provides a novel porous coordination polymer, ([ZnCu(2,4-pydca)2(H2O)3(DMF)].DMF)n (2), in which the Zn(II) ion at the node of the network acts as a linker and the Cu(II) ion in the channel wall is available for guest-coordination.     

A novel synthesis of (E)-3,7-dimethyl-2-octene-1,8-diol secreted by the african monarch using the ring-opening reaction of α-methyl-β-propiolactone

The regioselective ring-opening reaction of α-methyl-β-propiolactone with 3,3-ethylene-dioxybutylmagnesium bromide in the presence of copper(I) catalyst afforded 2-methyl-6-oxoheptanoic acid, which was easily converted into (E)-3,7-dimethyl-2-2-octene-1,8-diol in good yield.     

Preparation of Na+-selective electrodes by ion-implantation of lithium and silicon into single-crystal alumina wafer and its application to the production of ISFET

Summary Sodium ion-selective electrodes (Na⁺-ISE) were prepared by implanting Si⁺ and Li⁺ into alumina wafers and their characteristics were investigated. The alumina wafer had a thickness of 100 m and a diameter of 1.40 cm. The ionselective membrane was produced by ion-implanting of Li⁺ and Si⁺ on both sides of a single-crystal alumina wafer. The total doses of Li⁺ and Si⁺ were controlled to be the same, viz. 10¹³–10¹⁵ ions/cm². The ion-implanted alumina wafer with 10¹⁴ or 4×10¹⁴ ions/cm² of Li⁺ and Si⁺ showed better characteristics than the others.The response curves of the 10¹⁴ ions/cm² implanted alumina wafer had a slope of 42 mV/pNa in a concentration range from 1–10^–4mol/l. The full response achieved after about 1 min was reproducible. The proposed idea of producing Na⁺-ISE by ion-implantation technique was applied to functuate the gate surface of the field effect transitor to sodium ion. The sodium ion-sensitive FET (Na⁺-ISFET) prepared by implanting Li⁺ and Al⁺ at a dose of 5×10¹⁴ ions/cm² showed a slope of 30 mV/pNa in a concentration range from 1–10^–4mol/l.

---

Herstellung Na⁺-ionenselektiver Elektroden durch Einbau von Lithium und Silicium in Einkristall-Alumniumoxidblättchen und Anwendung zur Erzeugung von ISFET

Zusammenfassung Na⁺-selektive Elektroden wurden durch Einbau von Si⁺ und Li⁺ in Aluminiumoxidblättchen hergestellt und ihre Charakteristiken untersucht. Die Blättchen hatten eine Dicke von 100 m und einen Durchmesser von 1,40 cm. Ebenso wurde die Membran für einen ISFET hergestellt. Die Gesamtmenge von Li⁺ und Si⁺ wurde auf 10¹³–10¹⁵ Ionen/cm² eingestellt, wobei sich bei 10¹⁴ oder 4×10¹⁴ Ionen/cm² die beste Charakteristik ergab.Die Responsekurven der mit 10¹⁴ Ionen/cm² versehenen Aluminiumoxidplättchen hatten eine Neigung von 42 mV/pNa in einem Konzentrationsbereich von 1–10^–4mol/l. Der nach 1 min erhaltene volle Response war reproduzierbar. Die vorgeschlagene Technik wurde zur Einstellung der Gate-Oberfläche des Feldeffekt-Transistors auf Natriumion benutzt. Der Na⁺-sensitive FET (Na⁺-ISFET), der durch Einbau von Li⁺ und Al⁺ mit 5×10¹⁴ Ionen/cm² hergestellt wurde, zeigte eine Neigung der Signalkurve von 30 mV/pNa in einem Bereich von 1–10^–4mol/l.

     

QUANTUM EFFICIENCY FOR THE PHOTOCONVERSION OF BACTERIORHODOPSIN AT VERY LOW TEMPERATURES

Abstract— Quantum efficiencies for photoconversion of bacteriorhodopsin (trans-bR) to a bathochromic product (batho-bR^t) and its photoreversion in purple membrane at 77 and 9 K were investigated with low temperature spectrophotometry. The kinetics of the photoconversion and its photoreversion cannot be expressed by a single exponential curve. The photoconversions at 77 and 9 K showed the same slope in the early stage. The kinetics of the photoreversions were identical at the two temperatures. These results indicate that the quantum efficiencies for the conversion of trans-bR to batho-bR^t or for its photoreversion are identical at the two temperatures.
The fact that the photoreversion cannot be expressed by a single exponential curve suggests the existence of several conformational states of batho-bR^t due to the trimer structure of the purple membrane.     

A simple monitoring system for single subpicosecond laser pulses using an SH spatial autocorrelation method and a CCD image sensor

A simple noncollinear SHG autocorrelator for monitoring the time behavior of single subpicosecond laser pulses is described. A new CCD image-line sensor with high sensitivity in the UV range is used to measure the second-harmonic (SH) spatial distribution which gives information on the duration of the fundamental light pulses. An input energy of only 10 μJ is enough to obtain the SH spatial beam patterns in this highly sensitive autocorrelation system.