A novel synthesis of (E)-3,7-dimethyl-2-octene-1,8-diol secreted by the african monarch using the ring-opening reaction of α-methyl-β-propiolactone

The regioselective ring-opening reaction of α-methyl-β-propiolactone with 3,3-ethylene-dioxybutylmagnesium bromide in the presence of copper(I) catalyst afforded 2-methyl-6-oxoheptanoic acid, which was easily converted into (E)-3,7-dimethyl-2-2-octene-1,8-diol in good yield.     

Preparation of Na+-selective electrodes by ion-implantation of lithium and silicon into single-crystal alumina wafer and its application to the production of ISFET

Summary Sodium ion-selective electrodes (Na⁺-ISE) were prepared by implanting Si⁺ and Li⁺ into alumina wafers and their characteristics were investigated. The alumina wafer had a thickness of 100 m and a diameter of 1.40 cm. The ionselective membrane was produced by ion-implanting of Li⁺ and Si⁺ on both sides of a single-crystal alumina wafer. The total doses of Li⁺ and Si⁺ were controlled to be the same, viz. 10¹³–10¹⁵ ions/cm². The ion-implanted alumina wafer with 10¹⁴ or 4×10¹⁴ ions/cm² of Li⁺ and Si⁺ showed better characteristics than the others.The response curves of the 10¹⁴ ions/cm² implanted alumina wafer had a slope of 42 mV/pNa in a concentration range from 1–10^–4mol/l. The full response achieved after about 1 min was reproducible. The proposed idea of producing Na⁺-ISE by ion-implantation technique was applied to functuate the gate surface of the field effect transitor to sodium ion. The sodium ion-sensitive FET (Na⁺-ISFET) prepared by implanting Li⁺ and Al⁺ at a dose of 5×10¹⁴ ions/cm² showed a slope of 30 mV/pNa in a concentration range from 1–10^–4mol/l.

---

Herstellung Na⁺-ionenselektiver Elektroden durch Einbau von Lithium und Silicium in Einkristall-Alumniumoxidblättchen und Anwendung zur Erzeugung von ISFET

Zusammenfassung Na⁺-selektive Elektroden wurden durch Einbau von Si⁺ und Li⁺ in Aluminiumoxidblättchen hergestellt und ihre Charakteristiken untersucht. Die Blättchen hatten eine Dicke von 100 m und einen Durchmesser von 1,40 cm. Ebenso wurde die Membran für einen ISFET hergestellt. Die Gesamtmenge von Li⁺ und Si⁺ wurde auf 10¹³–10¹⁵ Ionen/cm² eingestellt, wobei sich bei 10¹⁴ oder 4×10¹⁴ Ionen/cm² die beste Charakteristik ergab.Die Responsekurven der mit 10¹⁴ Ionen/cm² versehenen Aluminiumoxidplättchen hatten eine Neigung von 42 mV/pNa in einem Konzentrationsbereich von 1–10^–4mol/l. Der nach 1 min erhaltene volle Response war reproduzierbar. Die vorgeschlagene Technik wurde zur Einstellung der Gate-Oberfläche des Feldeffekt-Transistors auf Natriumion benutzt. Der Na⁺-sensitive FET (Na⁺-ISFET), der durch Einbau von Li⁺ und Al⁺ mit 5×10¹⁴ Ionen/cm² hergestellt wurde, zeigte eine Neigung der Signalkurve von 30 mV/pNa in einem Bereich von 1–10^–4mol/l.

     

QUANTUM EFFICIENCY FOR THE PHOTOCONVERSION OF BACTERIORHODOPSIN AT VERY LOW TEMPERATURES

Abstract— Quantum efficiencies for photoconversion of bacteriorhodopsin (trans-bR) to a bathochromic product (batho-bR^t) and its photoreversion in purple membrane at 77 and 9 K were investigated with low temperature spectrophotometry. The kinetics of the photoconversion and its photoreversion cannot be expressed by a single exponential curve. The photoconversions at 77 and 9 K showed the same slope in the early stage. The kinetics of the photoreversions were identical at the two temperatures. These results indicate that the quantum efficiencies for the conversion of trans-bR to batho-bR^t or for its photoreversion are identical at the two temperatures.
The fact that the photoreversion cannot be expressed by a single exponential curve suggests the existence of several conformational states of batho-bR^t due to the trimer structure of the purple membrane.     

A simple monitoring system for single subpicosecond laser pulses using an SH spatial autocorrelation method and a CCD image sensor

A simple noncollinear SHG autocorrelator for monitoring the time behavior of single subpicosecond laser pulses is described. A new CCD image-line sensor with high sensitivity in the UV range is used to measure the second-harmonic (SH) spatial distribution which gives information on the duration of the fundamental light pulses. An input energy of only 10 μJ is enough to obtain the SH spatial beam patterns in this highly sensitive autocorrelation system.     

Photodynamic Therapy for Cancer Cells Using a Flash Wave Light Xenon Lamp

We determined photodynamic therapy (PDT) efficacy using a flash wave (FW) and a continuous wave (CW) light, of which the fluence rate was 70 W/cm², for murine thymic lymphoma cells (EL-4) cultivated in vitro. The irradiation frequency and the pulse width of the FW light were in the range of 1–32 Hz and less than one millisecond, respectively. 5-Aminolevulinic acid-induced protoporphyrin IX (ALA-PpIX) was used as a photosensitizer. When EL-4 with ALA administration was irradiated by the light for 4 h (irradiation fluence: 1.0J/cm²), the survival rate of EL-4 by the FW light was lower than that by the CW light, except for the FW light with irradiation frequency of 32 Hz, and decreased gradually with decreasing irradiation frequency. Moreover, the FW light, especially at lower irradiation frequency, was superior to the CW light for the generation of singlet oxygen in an aqueous PpIX solution. Therefore, thehigher PDT efficacy for EL-4 of the FW light would be caused by the greater generation of singlet oxygen in the cells.     

Observation of nonlinear coupling between small-poloidal wave-number potential fluctuations and turbulent potential fluctuations in Ohmically heated plasmas in the JFT-2M tokamak

Two types of electrostatic modes with small-poloidal wave numbers (approximately 1 and 10-15 kHz) are observed in the edge region of Ohmically heated plasmas in the JFT-2M tokamak. The envelope of the higher frequency coherent mode is modulated at the frequency of the lower frequency mode. A bispectral analysis revealed that a significant nonlinear coupling among the two types of fluctuations and the broadband background turbulent potential fluctuations occurs inside the last closed magnetic flux surface, suggesting that a nonlinear process such as the parametric-modulational instability is involved.     

The effect of the presence of foreign salts on the formation of gaseous ions for electrospray and laser spray

The effect of the presence of foreign salts (NaCl, aerosol OT, tetra-n-hexylammonium bromide, and CH3COONH4) on the formation of gaseous ions for electrospray (ES) and laser spray (LS) was studied in the positive and negative modes of operations. The ion signals for amino acids show sudden decrease with the concentration of foreign salts greater than 10(-5) M for both ES and LS. When the surface-active counter ions were added, the signal intensities showed a marked decrease for both ES and LS. This may be due to the enrichment of the surface-active counter ions on the surface of the charged droplets. When CH3COONH4 was added to an aqueous solution of 10(-6) M lysozyme chloride, an increase of the signal intensities for (lysozyme+nH)n+ and a decrease in the values of n were observed. The decrease in n may be due to the salt formation of (lysozyme+nH)n+ with the negative acetate ion leading to the reduction of positive charges.     

Clove oil prevents glycyrrhizin gel formation in aqueous solution

One persistent problem with using therapeutic concentrations of glycyrrhizin (GZ) is that, at these high concentrations, it forms a gel in an aqueous solution. We previously solved this problem by dissolving GZ in a highly concentrated phosphate buffer. Unfortunately, the resulting GZ solution has a hyperosmotic pressure that renders it unsuitable for use in patients. The aim of this study was to prepare a highly concentrated GZ solution having an osmotic pressure ratio of 1 and a pH of 7.4. By adding small amounts of oil and using a 100 mM phosphate buffer, we achieved an emulsified GZ solution that is stable at room temperature and has a physiological osmotic pressure and pH. When clove oil was used as an emulsifier, the gel formation temperature of GZ solution decreased appreciably compared to that of GZ solution without clove oil. Using scanning electron microscopy (SEM), we examined the detailed characteristics of GZ gels prepared from solutions with or without clove oil. SEM of cross sections of GZ gels revealed an irregular structure in gels prepared with clove oil, indicating that clove oil prevented the formation of the intermolecular GZ networks typically characterized by gels derived from pure GZ solutions.     

First results from KamLAND: evidence for reactor antineutrino disappearance

KamLAND has measured the flux of nu;(e)'s from distant nuclear reactors. We find fewer nu;(e) events than expected from standard assumptions about nu;(e) propagation at the 99.95% C.L. In a 162 ton.yr exposure the ratio of the observed inverse beta-decay events to the expected number without nu;(e) disappearance is 0.611+/-0.085(stat)+/-0.041(syst) for nu;(e) energies >3.4 MeV. In the context of two-flavor neutrino oscillations with CPT invariance, all solutions to the solar neutrino problem except for the "large mixing angle" region are excluded.