An attempt on the calculation of relativistic potential energy curves: Noble gas difluorides

Total energy SCF calculations were performed for noble gas difluorides in a relativistic procedure and compared with analogous non-relativistic calculations. The discrete variational method with numerical basis functions was used. Rather smooth potential energy curves could be obtained. The theoretical Kr-F and Xe-F bond distances were calculated to be 3.5 a.u. and 3.6 a.u. which should be compared with the experimental values of 3.54 a.u. and 3.7 a.u. Although the dissociation energies are off by a factor of about five it was found that ArF₂ may be a stable molecule. Theoretical ionization energies for the outer levels reproduce the experimental values for KrF₂ and XeF₂ to within 2 eV.     

On a recursive method for the estimation of unknown parameters of partially observed chaotic systems

We investigate a recently proposed method for on-line parameter estimation and synchronization in chaotic systems. This novel technique has been shown effective to estimate a single unknown parameter of a primary chaotic system with known functional form that is only partially observed through a scalar time series. It works by periodically updating the parameter of interest in a secondary system, with the same functional form as the primary one but no explicit coupling between their dynamic variables, in order to minimize a suitably defined cost function. In this paper, we review the basics of the method, and investigate its robustness and new extensions. In particular, we study the performance of the novel technique in the presence of noise (either observational, i.e., an additive contamination of the observed time series, or dynamical, i.e., a random perturbation of the system dynamics) and when there is a mismatch between the primary and secondary systems. Numerical results, including comparisons with other techniques, are presented. Finally, we investigate the extension of the original method to perform the estimation of two unknown parameters and illustrate its effectiveness by means of computer simulations.     

Highly polarized dithiafulvenes: synthesis and nonlinear optical properties

Push-pull dithiafulvenes with reduced bond length alternation (BLA) and high optical nonlinearities have been prepared. The interplay between the proaromaticity of the donor and the structural and optical properties of these merocyanines is discussed. The donor ability of dithiafulvenes can reach that of ferrocene or dialkylaminophenyl groups.     

Dual frames in connected with generalized sampling in shift-invariant spaces

The aim of this article is to derive stable generalized sampling in a shift-invariant space by using some special dual frames in L²(0,1). These sampling formulas involve samples of filtered versions of the functions in the shift-invariant space. The involved samples are expressed as the frame coefficients of an appropriate function in L²(0,1) with respect to some particular frame in L²(0,1). Since any shift-invariant space with stable generator is the image of L²(0,1) by means of a bounded invertible operator, our generalized sampling is derived from some dual frame expansions in L²(0,1).     

The Polyakov path integral over bordered surfaces

Following the general scheme of the convariant path integral quantization of gauge systems, two alternative formulations of the first quantized closed bosonic string in a position representation are presented. In both approaches the covariant path integral representations of the propagator and of the higher order off-shell amplitudes are constructed. For a wide class of gauges the explicit formulae for off-shell amplitudes are obtained. This paper is the continuation of our previous work where the corresponding problems in the open string case were considered [20].     

Preparation of activated carbons from cherry stones by activation with potassium hydroxide

Using cherry stones, the preparation of activated carbon has been undertaken in the present study by chemical activation with potassium hydroxide. A series of KOH-activated products was prepared by varying the carbonisation temperature in the 400-900 °C range. Such products were characterised texturally by gas adsorption (N₂, −196 °C), mercury porosimetry, and helium and mercury density measurements. FT-IR spectroscopy was also applied. The carbons prepared as a rule are microporous and macroporous solids. The degree of development of surface area and porosity increases with increasing carbonisation temperature. For the carbon heated at 900 °C the specific surface area (BET) is 1624 m² g⁻¹, the micropore volume is 0.67 cm³ g⁻¹, the mesopore volume is 0.28 cm³ g⁻¹, and the macropore volume is 1.84 cm³ g⁻¹.     

On bulk-service MAP/PH L,N /1/N G-Queues with repeated attempts

We consider a retrial queue with a finite buffer of size N, with arrivals of ordinary units and of negative units (which cancel one ordinary unit), both assumed to be Markovian arrival processes. The service requirements are of phase type. In addition, a PH^L,N bulk service discipline is assumed. This means that the units are served in groups of size at least L, where 1≤ L≤ N. If at the completion of a service fewer than L units are present at the buffer, the server switches off and waits until the buffer length reaches the threshold L. Then it switches on and initiates service for such a group of units. On the contrary, if at the completion of a service L or more units are present at the buffer, all units enter service as a group. Units arriving when the buffer is full are not lost, but they join a group of unsatisfied units called “orbit”. Our interest is in the continuous-time Markov chain describing the state of the queue at arbitrary times, which constitutes a level dependent quasi-birth-and-death process. We start by analyzing a simplified version of our queueing model, which is amenable to numerical calculation and is based on spatially homogeneous quasi-birth-and-death processes. This leads to modified matrix-geometric formulas that reveal the basic qualitative properties of our algorithmic approach for computing performance measures. AMS Subject Classification: Primary 60K25 Secondary 68M20 90B22.     

Velocity Quantization Approach of the One-Dimensional Dissipative Harmonic Oscillator

Given a constant of motion for the one-dimensional harmonic oscillator with linear dissipation in the velocity, the problem to get the Hamiltonian for this system is pointed out, and the quantization up to second order in the perturbation approach is used to determine the modification on the eigenvalues when dissipation is taken into consideration. This quantization is realized using the constant of motion instead of the Hamiltonian. PACS: 03.20.+i, 03.30.+p, 03.65.−w,03.65.Ca     

Microperforated insertion units: An alternative strategy to design microperforated panels

Microperforated panels (MPPs) coupled to a rigid wall have been proposed recently as an alternative to porous absorbers in situations having concerns with bacterial contamination and small particles discharge, like food, pharmaceutical and microelectronic industries. There exists also an increasing interest for MPP absorbers in the transportation industry and civil engineering. In general, an optimally designed MPP with good broadband absorption requires many submillimetric holes distributed over a panel of also submillimetric thickness. Such thin plates or foils become so fragile that they need to be protected from mechanical damage. In this paper, an alternative strategy is investigated which allows the design of MPPs with panels of millimetric thickness while maintaining their acoustic performance. These absorbers, named microperforated insertion units (MIUs), avoid the structural problems of the classical MPPs. An assessment of the sound absorption properties of these structures is presented. Comparisons between calculations and measurements are also made under two experimental conditions: plane waves at normal incidence (impedance tube) and free field (anechoic room).