Synthesis of poly (ether-sulfone-amide)s by palladium-catalyzed polycondensation of aromatic dibromides containing ether sulfone structure,aromatic diamines,and carbon monoxide

A general method for the preparation of aromatic poly (ether-sulfone-amide)s has been developed. Polymerization is based on the palladium-catalyzed polycondensation of aromatic dibromides containing ether sulfone structural units, aromatic diamines, and carbon monoxide. Reactions were carried out in N, N-dimethylacetamide (DMAc) in the presence of palladium catalyst, triphenylphosphine, and 1,8-diazabicyclo [5,4,0]–7–undecene (DBU), and gave a series of poly (ether-sulfone-amide)s with inherent viscosities up to 0.86 dL/g under mild conditions. The polymers were quite soluble in strong acids, dipolar aprotic solvents, and pyridine. Thermogravimetry of the polymers showed excellent thermal stability, indicating that 10% weight losses of the polymers were observed in the range above 470°C in air. The glass transition temperatures of the polymers were around 230°C, which are higher than those of poly (ether-sulfone) analogues. These polymers also showed the good tensile strengths and tensile modulus. © 1994 John Wiley & Sons, Inc.     

Determination of ammonium ion in a flow-injection system with a gas-diffusion membrane : Selection of Optimal Conditions for the pH Indicator

The spectrophotometric determination of ammonium ion in water by flow-injection analysis with a membrane-separator and a pH indicator for detection is studied in detail. The relations derived facilitate the selection of appropriate solution compositions or the prediction of sensitivity. It is shown that 1.5×10^?5 M bromocresol purple (pH 6.8) as acceptor solution gives the maximal sensitivity in the flow system with a laboratory-made separation unit. Application of ultrasonic radiation in the separation step and the use of different flow rates for the donor and acceptor streams may result in increased permeation of ammonia and a correspondingly high sensitivity. By modifying the acceptor solution so that the sensitivity is decreased, more concentrated samples such as urine can be analyzed by direct injection without prior dilution. In this procedure, the sample rate was 60 h^?1 for ammonium concentration of more than 10^?5 M and 30–40 h^?1 for concentrations in the range 3×10^?7?10^?5 M. The detection limit was about 3×10^?7 M.     

Mössbauer study of new vanadate glass with large charge-discharge capacity

Charge-discharge capacity and cyclicity of lithium ion battery (LIB) was evaluated in which 15Li₂O·10Fe₂O₃·xSnO₂·5P₂O₅·(70–x)V₂O₅ glass (x?=?0 and 20 in mol%, abbreviated as xLFSPV) was used as a cathode. A local structure of xLFSPV glass before and after charging was investigated by ⁵⁷Fe- and ¹¹⁹Sn-Mössbauer spectroscopies. ⁵⁷Fe-Mössbauer spectrum of xLFSPV glass with ‘x’ of 20 was composed of a doublet with isomer shift (δ) of 0.35_±0.02 mm s^???1 and quadrupole splitting (Δ) of 0.88_±0.03 mm s^???1 due to distorted Fe^IIIO₄ tetrahedra. ¹¹⁹Sn-Mössbauer spectrum of this glass consisted of a doublet with δ of 0.08_±0.01 and Δ of 0.52_±0.01 mms^???1 due to distorted Sn^VIO₆ octahedra. After discharging the battery from 4.5 to 1.0 V, larger δ of 0.40_±0.03 mm s^???1 and Δ of 0.94_±0.04 mm s^???1 were obtained, indicating that both iconicity of Fe-O bonds and local distortion of Fe^IIIO₄ tetrahedra were increased. On the contrary, identical δ of 0.09_±0.01 mm s^???1 and Δ of 0.50_±0.01 mm s^???1 were observed in the ¹¹⁹Sn-Mössbauer spectrum of 20LFSPV glass after the discharge, indicating that chemical environment of Sn^IVO₆ octahedra was not affected after the discharge. Charge-discharge curve of LIB containing 20LFSPV glass as a cathode active material recorded under the current density of 8.3 mA g^???1 (0.011 mA cm^???2) between 1.0 and 4.5 V showed a large initial charge capacity of 431.1 mAh g^???1 and discharge capacity of 382.3 mAh g^???1, respectively. These results indicate that 20LFSPV glass could be a new cathode active material for LIB.     

Mapping analyses of Fe-diffused mc-Si using M?ssbauer microscope and photoluminescence

Twenty CK chondrites collected in the Antarctica Continent were characterized by inductively-coupled plasma mass spectrometry (ICP-MS), prompt gamma ray analysis (PGA), instrumental neutron activation analysis (INAA), X-ray diffractometry (XRD) and ⁵⁷Fe-M?ssbauer spectroscopy. As a result of elemental analysis, it was revealed that 18.2~26.4 mass% of iron was included in the each chondrite. M?ssbauer spectrum of LEW86258, classified as a typical CK chondrite, was found to be composed of two paramagnetic doublets and two magnetic sextets. M?ssbauer spectra were assigned to the absorption due to forsterite (Mg_1.36Fe_0.64SiO₄) and magnetite (Fe₃O₄), as also confirmed by XRD. XRD study of LAP03834, reclassified from CK to R chondrite, revealed the presence of crystalline phase due to forsterite. These results indicate that LAP03834 and related chondrites, i.e., MET01149, LAP03923 and MAC02453, should be reclassified as R or LL chondrite.     

Mechanically strengthened new Hagi porcelain developed by controlling the chemical environment of iron

In order to enhance the mechanical strength of Hagi Porcelain (Hagiyaki), one of the oldest and famous potteries in Japan, new preparation condition was examined. Tempered Hagi porcelain, denominated as ‘Hagi Porcelain B’, was prepared with the Porcelain clay originating from Daido district, Yamaguchi Prefecture, Japan. Structural change of ‘Hagi Porcelain B’ was investigated by means of ⁵⁷Fe-Mössbauer spectroscopy, X-ray diffractometry (XRD) and three-point bending test. Mechanical strength of the ‘original Hagi Porcelain B’ was estimated to be 43.1 MPa by means of the three-point bending test, while much larger value of 104.5 MPa could be achieved when tempered by a chemical modification. Mössbauer spectrum of the ‘original Hagi porcelain B’ was composed of a paramagnetic doublet and a magnetic sextet due to Fe(III) of γ-Fe₂O₃(maghemite), while only one paramagnetic doublet due to to octahedral Fe(II)O₆ was observed for the ‘tempered Hagi Porcelain B’ with isomer shift and quadrupole splitting values of 1.13 and 2.15 mm s^?1, respectively. It is considered that the absence of magnetic phase causes an increase of the mechanical strength because the maghemite phase has a defect spinel structure. These results indicate that mechanical strength of the ‘Hagi porcelain B’ could be enhanced by controlling the sintering condition.     

Transfer hydrogenation of imines with carboxyl-tailed benzothiazoline as readily removable hydrogen donor

A benzothiazoline bearing 4-carboxyphenyl group at 2-position was developed as an efficient hydrogen donor for the transfer hydrogenation reaction. Introduction of the carboxyl group significantly facilitated the removal of the residual benzothiazoline and benzothiazole by washing with aqueous basic solution. The present approach provides a convenient and straightforward access to various amines with broad substrate scope and in good yields.     

Polymeric Electron Carriers

Polymers containing 1,4-dihydronicotinamide (P-NAH) alloxan (P-A), and viologen (P-V²⁺) moieties were synthesized and characterized. P-NAH reduced various organic substances such as lipoic acid, alloxan, and viologens and also immobilized quinone mediated by alloxan. P-A was reduced to the polymer-bearing alloxan radical and the dialuric acid structure without crosslinks by one- and two-electron reduction, respectively, and P-A also mediated the redox reaction occurring between aqueous and organic (water-immiscible) layers. P-V²⁺ was converted to the stable viologen radical reversibly by one-electron reduction. Electric potentials and currents on photo-reduction of P-V²⁺ and catalytic behavior of P-V²⁺ in the reduction of carbonyl compounds were examined.     

Excess enthalpies of binary mixtures of butylamines + propanols at 298.15 K

The molar excess enthalpies of eight systems of butylamines + propanols were determined at 298.15 K using a twin-microcalorimeter. All excess enthalpies were exothermic and large. An equilibrium constant K ₁ expressed in terms of mole fractions and standard thermodynamic properties of formation (Δ_f H, Δ_f G, Δ_f S) of 1:1 complex were evaluated by ideal mixtures of monomeric molecules and their associated complexes. Concentration dependence of the FT-Raman spectrum showed systematic changes of bands. Spectroscopic considerations based on this and ab initio calculations on molecules were performed at the Mp2/6-311G(d,p) level of theory. Interaction energies between butylamine and propanol were calculated by the supermolecular and NBO methods. The results were discussed with previous results to clarify the steric and positional effect of the amino and hydroxyl group.     

Induced production of novel prenyldepside and coumarins in endophytic fungi Pestalotiopsis acaciae

Concomitant supplementation of a histone deacetylase inhibitor, suberoylanilide hydroxamic acid, and a DNA methyltransferase inhibitor, 5-azacytidine, to the culture medium of a plant endophytic fungus, Pestalotiopsis acaciae, dramatically altered its metabolic profiles. As a result, three novel aromatic compounds, 2′-hydroxy-6′-hydroxymethyl-4′-methylphenyl-2,6-dihydroxy-3-(2-isopentenyl)benzoate (1), 4,6-dihydroxy-7-hydroxymethyl-3-methylcoumarin (2) and 4,6-dihydroxy-3,7-dimethylcoumarin (3), were isolated, along with five known polyketides, endocrocin (4), pestalotiollide B (5), pestalotiopyrone G (6), scirpyrone A (7) and 7-hydroxy-2-(2-hydroxypropyl)-5-methylchromone (8).     

Electro-optic effect,propagation loss,and switching speed in polymers containing nano-sized droplets of liquid crystal

Polymers containing droplets of liquid crystal smaller than 100 nm, which have good transparency and easily form films, were prepared under various conditions to evaluate their potential as electro-optic materials for waveguide-type devices. By varying the liquid crystal concentration and the strength of the UV irradiation causing photo-induced phase separation of the droplets, we were able to control the droplet size and density. We have clarified how the birefringence generated in an applied electric field, switching speed, and optical loss of light propagating in the film depend on droplet size and density. Polymer materials having a large electro-optic effect (δn = 0.001 at 8 V μm^-1), low propagation loss (~2.5 dB cm^-1), and fast response time (~10 μs) have been developed.