New liquid nitrogen cryogenic modulator for comprehensive two-dimensional gas chromatography

A new liquid nitrogen (LN2) jet-based thermal modulator for performing comprehensive two-dimensional (2D) gas chromatographic (GC x GC) separations has been designed and constructed. Temperature measurements of the trapping zone, a segment of uncoated fused silica capillary, show that it can be cooled to -196 degrees C in about 300 ms. A film of liquid nitrogen develops on the outside of the trapping capillary even when the oven temperature is in excess of 200 degrees C. Compounds as volatile as propane can be trapped by the modulator and held for periods of at least 1 min without breakthrough. The peak widths for n-alkanes are on the order of 80 ms at half height after passing through an 80cm second dimension column. Repeated analysis of gasoline demonstrated excellent run-to-run reproducibility of the system.     

Facts and artifacts about aromatic stability estimation

The stability of a set of 105 five-membered π-electron systems (involving aromatic, non-aromatic and anti-aromatic species) was evaluated using six isodesmic reactions of which two belong to the subclass of homodesmotic reactions, which are based on cyclic and acyclic reference systems. We demonstrate that the ‘Resonance Energies’ derived from isodesmotic schemes have obvious flaws and do not correct or cancel other contributions to the energy, such as the changes of hybridization, homoconjugation of heterosubstituted cyclopentadienes, conjugative interactions of CC or CX (X=N or P) with a π or pseudo π orbital at Y (Y=O, S, NH, PH), strain, etc. as effectively as possible. Likewise, ‘aromatic stabilization energies (ASE)’ derived from homodesmotic schemes based on the acyclic reference compounds do not give satisfactory results. We strongly recommend that only cyclic reference compounds should be used for ASE and other aromaticity evaluations. The analysis is based on ab initio optimized geometries at B3LYP/6-311+G^∗∗.     

Optimized conditions for hydrocarbon group type analysis of base oils by thin-layer chromatography-flame ionisation detection

The results of research on the optimization of the thin-layer chromatography-flame ionisation detection for the determination of group composition of natural base oils, including separation of the aromatics into subgroups, are presented. Neutral base oils obtained in several steps of refining from vacuum distillation petroleum fractions are the most difficult to analyze by hydrocarbon group type analysis (HGTA) because of the high content of aliphatic fragments in their molecules. Factors affecting the accuracy and precision of the results were identified. The paper presents the analytical procedure, including two different calibration methods, as well as the results of studies on the reproducibility of HGTA of typical base oils of different viscosity classes under the optimized conditions. The same conditions were found suitable for HGTA of other high-boiling petroleum fractions by TLC with flame ionisation detection. The paper also introduces a new procedure for reproducible determination of polar fractions in base oils utilizing solid-phase extraction columns, and presents a corrected procedure for the determination of saturated compounds and aromatics (mono-, bi- and polycyclic) in base oils by column liquid chromatography.     

Simple and effective one‐pot synthesis of (meth)acrylic block copolymers through atom transfer radical polymerization

The synthesis of di‐ and triblock copolymers using atom transfer radical polymerization (ATRP) of n‐butyl acrylate (BA) and methyl methacrylate (MMA) is reported. In particular, synthetic procedures that allow for an easy and convenient synthesis of such block copolymers were developed by using CuBr and CuCl salts complexed with linear amines. Polymerizations were successfully conducted where the monomers were added to the reactor in a sequential manner. Poor cross‐propagation between poly(n‐butyl acrylate) (PBA) macroinitiators and MMA was minimized, and therefore control of molecular weights and distributions was realized, by using halogen exchange—a technique involving the addition of CuCl to the MMA during the chain extension of the PBA macroinitiator. High molecular weight (M_n ∼ 90,000) and low polydispersity (M_w /M_n < 1.35) ABA triblock copolymers were also prepared and their structure and properties in bulk have been preliminary characterized indicating the potential of ATRP for the production of all‐acrylic thermoplastic elastomers. © 2000 John Wiley & Sons, Inc. J Polym Sci A: Polym Chem 38: 2023–2031, 2000     

TLC and HPLC Analysis of the Phenolic Acids in Silphium perfoliatum L. Leaves,Inflorescences and Rhizomes

JPC – Journal of Planar Chromatography – Modern TLC - TLC and HPLC have been used for preliminary evaluation of the phenolic acids occurring in the leaves, inflorescences, and rhizomes...     

Elucidation of the vicarious nucleophilic substitution of hydrogen mechanism via studies of competition between substitution of hydrogen, deuterium, and fluorine.

Relations of rates of the vicarious nucleophilic substitution of hydrogen (VNS) and S(N)Ar substitution of fluorine in 2-fluoronitrobenzenes with chloroalkyl aryl sulfone carbanions were determined from competitive experiments carried out at various concentrations of base. The observed dependence of the VNS/S(N)Ar rate ratio on the base concentration confirmed the two-step mechanism of the VNS, which consists of reversible formation of sigma(H) adducts of the alpha-chlorocarbanion to nitroarene, followed by base-induced beta-elimination of HCl. It was also evidenced that both of these processes can be the rate-limiting steps: the beta-elimination at low base concentration and the nucleophilic addition at high base concentration. Consistent with that conclusion is the finding that the kinetic isotope effect in the VNS reaction decreases from 4.2 (a value typical of a primary KIE) to 0.8 (a value typical of a secondary KIE) with increasing base concentration. Also reported is our discovery that the S(N)Ar substitution of the 2-fluoronitrobenzenes studied in this work was subject to base catalysis under some of the experimental conditions employed in our competitive experiments.     

The 2:1 cocrystal of benzamide and penta­fluoro­benzoic acid

The crystal structure of the title compound, benzamide–2,3,4,5,6‐penta­fluoro­benzoic acid (2/1), 2C₇H₇NO·C₇HF₅O₂, consists of centrosymmetric hexa­meric supermolecules composed of four amide and two carboxylic acid mol­ecules connected via O—H⋯O and N—H⋯O hydrogen bonds. No phen­yl–perfluoro­phenyl π–π stacking inter­actions are observed in this cocrystal.     

Characterization of organosulfates from the photooxidation of isoprene and unsaturated fatty acids in ambient aerosol using liquid chromatography/(-) electrospray ionization mass spectrometry

In the present study, we have characterized in detail the MS(2) and MS(3) fragmentation behaviors, using electrospray ionization (ESI) in the negative ion mode, of previously identified sulfated isoprene secondary organic aerosol compounds, including 2-methyltetrols, 2-methylglyceric acid, 2-methyltetrol mononitrate derivatives, glyoxal and methylglyoxal. A major fragmentation pathway for the deprotonated molecules of the sulfate esters of 2-methyltetrols and 2-methylglyceric acid and of the sulfate derivatives of glyoxal and methylglyoxal is the formation of the bisulfate [HSO(4)](-) anion, while the deprotonated sulfate esters of 2-methyltetrol mononitrate derivatives preferentially fragment through loss of nitric acid. Rational interpretation of MS(2), MS(3) and accurate mass data led to the structural characterization of unknown polar compounds in K-puszta fine aerosol as organosulfate derivatives of photooxidation products of unsaturated fatty acids, i.e. 2-hydroxy-1,4-butanedialdehyde, 4,5- and 2,3-dihydroxypentanoic acids, and 2-hydroxyglutaric acid, and of alpha-pinene, i.e. 3-hydroxyglutaric acid. The deprotonated molecules of the sulfated hydroxyacids, 2-methylglyceric acid, 4,5- and 2,3-dihydroxypentanoic acid, and 2- and 3-hydroxyglutaric acids, showed in addition to the [HSO(4)](-) ion (m/z 97) neutral losses of water, CO(2) and/or SO(3), features that are characteristic of humic-like substances. The polar organosulfates characterized in the present work are of climatic relevance because they may contribute to the hydrophilic properties of fine ambient aerosol. In addition, these compounds probably serve as ambient tracer compounds for the occurrence of secondary organic aerosol formation under acidic conditions.     

Zinc Imine Polyhedral Oligomeric Silsesquioxane as a Quattro-Site Catalyst for the Synthesis of Cyclic Carbonates from Epoxides and Low-Pressure CO2

In the present research, the synthesis, spectroscopic characterization, and structural investigations of a unique Zn^II complex of imine-functionalized polyhedral oligomeric silsesquioxane (POSS) is designed, and hereby described, as a catalyst for the synthesis of cyclic carbonates from epoxides and CO₂. The uncommon features of the designed catalytic system is the elimination of the need for a high pressure of CO₂ and the significant shortening of reaction times commonly associated with such difficult transformations like that of styrene oxide to styrene carbonate. Our studies have shown that imine-POSS is able to chelate metal ions like Zn^II to form a unique coordination complex. The silsesquioxane core and the hindrance of the side arms (their steric effect) influence the construction process of the homoleptic Zn₄@POSS-1 complex. The compound was characterized in solution by NMR (¹H, ¹³C, ²⁹Si), ESI-MS, UV/Vis spectroscopy and in the solid state by thermogravimetric/differential thermal analysis (TG-DTA), elemental analysis, diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS), cross-polarization magic angle spinning (CP MAS) NMR (¹³C, ²⁹Si) spectroscopy, and X-ray crystallography.