In situ ATR-IR investigation of L-lysine adsorption on montmorillonite

The adsorption behavior of lysine on montmorillonite in aqueous solution was investigated by in situ attenuated total reflectance infrared (ATR-IR) spectroscopy. To distinguish the protonation states of α-amino group, side-chain amino group and carboxyl group in lysine structure using ATR-IR spectra (i.e., NH₂ versus and COO⁻ versus COOH), pH-induced spectral changes of dissolved lysine were firstly measured and correlated with the thermodynamically calculated dissociation states of lysine (di-cationic, cationic, zwitterionic and anionic states). The obtained result was applied to interpret the ATR-IR spectra of lysine adsorbed on montmorillonite. We found that the adsorbed lysine was dominantly present as cationic state over the whole range of tested pH (pH = 4.9–9.7). This indicates that the adsorption is mainly driven by electrostatic interaction between the negatively charged montmorillonite surface and positively charged cationic lysine. We also found that lysine interacts with montmorillonite surface through the protonated side-chain amino group. This result suggests that lysine has a preferred vertical orientation, with the side-chain amino group pointing toward the surface.     

Fluorescence studies on phenylene moieties embedded in a framework of periodic mesoporous organosilica

The excited state characteristics of phenylene (Ph)-bridged periodic mesoporous organosilica (PMO) powders with crystal-like and amorphous wall structures are investigated. Crystal-like Ph-PMO has a molecular ordering of the bridging organic moieties with intervals of 0.76 and 0.44 nm parallel and perpendicular to the mesochannel direction, respectively, whereas amorphous Ph-PMO has no molecular-level periodicity in the wall. Fluorescence from the exciton and excimer of the Ph moieties and the defect center in the silicate network were detected at room temperature, but fluorescence from the excimer and the defect center were not detected at 77 K for crystal-like Ph-PMO dispersed in a methanol/ethanol mixed solvent. The decay curve of the exciton fluorescence of crystal-like Ph-PMO at room temperature was analyzed successfully using a one-dimensional diffusion model quenched by the defect center and the excimer site. The results were discussed in comparison with those for the crystal-like biphenylene-bridged PMO reported in the preceding paper (Yamanaka et al., Phys. Chem. Chem. Phys., 2010, 12, 11688-11696). The existence of excited states with various conformations including ground state dimers or aggregates of the Ph moieties was suggested for amorphous Ph-PMO. It was clearly apparent that the differences in the excited state dynamics reflected the differences in the molecular-level structure in the wall.     

Interplay between magnetism and conductivity derived from spin-polarized donor radicals

Tutorial review: to achieve molecule-based spintronic devices, an organic conducting magnet that exhibits both conductivity and magnetism in a cooperative manner must be constructed. As a building block for such new materials, a spin-polarized donor radical, which serves as a molecular "spin-filter" in its singly oxidized state, was designed and synthesized. The resistivity of ion radical salts of selenium-substituted, tetrathiafulvalene-based spin-polarized donor radicals decreased substantially in the presence of a magnetic field, thus indicating cooperative conductivity and magnetism.     

MYCOCHROME SYSTEM AND CONIDIAL DEVELOPMENT IN CERTAIN FUNGI IMPERFECTI

Abstract. A photoreceptor system, “mycochrome”, is involved in a blue and near UV reversible photo-reaction which in turn plays an important role in the photocontrol of conidial development in Alternaria tomato, Botrytis cinerea and Helminthosporium oryzae. Conidial development was controlled by alternating exposures to blue and near UV light with the final response being determined by the final light received. When the final light was near UV a conidium developed; when it was blue, conidiation was inhibited and a “sterile” conidiophore was formed. The effects of the two lights were alternatively reversible. Blue and near UV reversible photoreaction was also found in a light-minus-dark difference spectrum of an intracellular particulate fraction isolated from dark-grown mycelia of A. tomato, and two pigments, P_B (blue absorbing type) and P_NUV (near UV absorbing type), were contained in that photoreaction. P_B was tightly bound to the particulate fraction and P_NUV was either soluble in the cytoplasm or very loosely bound to the particulate fraction. Blue and near UV reversible photoreaction occurred only under the coexistence of P_B and P_NUV. That is, a dip in the near UV region and peak absorbance in the blue region was induced by irradiation with near UV light; however, both conditions were partially dissipated with a subsequent irradiation of blue light. These absorbance changes were revers-ibly repeated by alternating doses of blue and near UV light. When molecular oxygen was introduced after exposure to near UV light, peak absorbance in the blue region rapidly disappeared, and these absorbance changes were repeatedly reversible. Similar results were obtained by treatment with sodium hydrosulfite and molecular oxygen. Thus, it was concluded that the mycochrome system suggested in photo-conidiation was consistent with certain active substances showing blue and near UV reversible absorbance changes and caused by photooxidation reduction reaction.     

Polymerization of coordinated monomers. III. Copolymerization of acrylonitrile–zinc chloride,methacrylonitrile–zinc chloride or methyl methacrylate–zinc chloride complex with styrene

The 1:1 or 2:1 complex of acrylonitrile, methacrylonitrile, or methyl methacrylate with ZnCl₂ was copolymerized with styrene at the temperature of 0–30°C without any initiator. The structure of the copolymer from methyl methacrylate complex and styrene was examined by NMR spectroscopy. The complexes of acrylonitrile or methacrylonitrile with ZnCl₂ gave a copolymer containing about 50 mole-% styrene units. The complexes of methyl methacrylate yielded an alternating copolymer when the feed molar ratio of methyl methacrylate to styrene was small, but with increasing feed molar ratio the resulting copolymer consisted of about 2 moles of methyl methacrylate per mole of styrene. The formation of a charge-transfer complex of styrene with a monomer coordinated to zinc atom was inferred from the ultraviolet spectra. The regulation of the copolymerization was considered to be effected by the charge-transfer complex. The copolymer resulting from the 2:1 methyl methacrylate–zinc chloride complex had no specific tacticity, whereas the copolymer from the 1:1 complex was richer in coisotacticity than in cosyndiotacticity. The change of the composition of the copolymer and its specific tacticity in the polymerization of the methyl methacrylate complex is related to the structure of the complex.     

Chalcogeno-Morita-Baylis-Hillman Reaction of Chalcogenide-Enones with Carbonyl Compounds

Abstract

The Chalcogeno-Morita-Baylis-Hillman reaction was achieved by the reactions of 2-(methylchalcogeno)phenyl vinyl ketones with carbonyl compounds or acetals in the presence of BF₃· Et₂O. This reaction proceeds via the intramolecular Michael addition of the chalcogenide group to an enone moiety followed by the aldol reaction of the resulting chalcogenonio-enolate with an aldehyde. The reactions were worked up with triethylamine or saturated aqueous NaHCO₃ to give the α -methylene aldols (the Morita-Baylis-Hillman adducts).     

Induction and Acceleration of Bonelike Apatite Formation on Tantalum Oxide Gel in Simulated Body Fluid

Untreated tantalum metal forms bonelike apatite layer on its surface in a simulated body fluid (SBF) after a long period. The apatite formation on the tantalum metal is significantly accelerated, when the metal was previously subjected to NaOH and heat treatments to form an amorphous sodium tantalate on its surface. The fast formation of the apatite on the NaOH- and heat-treated tantalum metal was explained as follows. The sodium tantalate on the surface of the metal releases the Na⁺ ion via exchange with H₃O⁺ ion in SBF to form a lot of Ta-OH groups on its surface. Thus formed Ta-OH groups induce the apatite nucleation and the released Na⁺ ion accelerates the apatite nucleation by increasing ionic activity product of the apatite in SBF due to increase in OH^– ion concentration. In the present study, in order to confirm this explanation, apatite formations on sodium tantalate gels with different Na/Ta atomic ratios, which were prepared by a sol-gel method were investigated. It was found that even Na₂O-free tantalum oxide gel forms the apatite on its surface in SBF. This proves that the Ta-OH groups abundant on the gel can induce the apatite nucleation. The apatite-forming ability of the gels increased with increasing Na/Ta atomic ratios of the gels. The sodium-containing tantalum oxide gels released the Na⁺ ion, the amount of which increased with increasing Na/Ta atomic ratios of the gels. The released Na⁺ ion gave an increase in pH of SBF. These results prove that the apatite nucleation induced by the Ta-OH groups is accelerated with the released Na⁺ ion by increasing ionic activity product of the apatite in SBF.     

Photochemical intramolecular nitrene insertion of 6-azidouridine derivatives

A highly efficient intramolecular nitrene insertion was observed upon irradiation of 6-azidouridine derivatives. The N⁶,2′-cyclo structure of the product was determined unequivocally by X-ray crystallography.     

A new synthesis, including asymmetric synthesis, of spiro[4.n]alkenones from three components: cyclic ketones, chloromethyl p-tolyl sulfoxide, and acetonitrile; and a formal total synthesis of racemic acorone

1-Chlorovinyl p-tolyl sulfoxides were synthesized from several kinds of cyclic ketones and chloromethyl p-tolyl sulfoxide in good yields. Treatment of the 1-chlorovinyl p-tolyl sulfoxides with cyanomethyllithium at −78°C to room temperature gave spirocyclic enaminonitriles in high yields. Acidic treatment of the enaminonitriles afforded spiro[4.n]alkenones in good yields. By using an unsymmetrical cyclic ketone, α-tetralone, and optically active chloromethyl p-tolyl sulfoxide, this procedure afforded enantiomerically pure spiro[4.5]decenone in good yield with excellent asymmetric induction from the sulfoxide chiral center. By using this method a formal total synthesis of a racemic spirocyclic sesquiterpene, acorone, was realized.