In situ ATR-IR investigation of L-lysine adsorption on montmorillonite

The adsorption behavior of lysine on montmorillonite in aqueous solution was investigated by in situ attenuated total reflectance infrared (ATR-IR) spectroscopy. To distinguish the protonation states of α-amino group, side-chain amino group and carboxyl group in lysine structure using ATR-IR spectra (i.e., NH₂ versus and COO⁻ versus COOH), pH-induced spectral changes of dissolved lysine were firstly measured and correlated with the thermodynamically calculated dissociation states of lysine (di-cationic, cationic, zwitterionic and anionic states). The obtained result was applied to interpret the ATR-IR spectra of lysine adsorbed on montmorillonite. We found that the adsorbed lysine was dominantly present as cationic state over the whole range of tested pH (pH = 4.9–9.7). This indicates that the adsorption is mainly driven by electrostatic interaction between the negatively charged montmorillonite surface and positively charged cationic lysine. We also found that lysine interacts with montmorillonite surface through the protonated side-chain amino group. This result suggests that lysine has a preferred vertical orientation, with the side-chain amino group pointing toward the surface.     

Fluorescence studies on phenylene moieties embedded in a framework of periodic mesoporous organosilica

The excited state characteristics of phenylene (Ph)-bridged periodic mesoporous organosilica (PMO) powders with crystal-like and amorphous wall structures are investigated. Crystal-like Ph-PMO has a molecular ordering of the bridging organic moieties with intervals of 0.76 and 0.44 nm parallel and perpendicular to the mesochannel direction, respectively, whereas amorphous Ph-PMO has no molecular-level periodicity in the wall. Fluorescence from the exciton and excimer of the Ph moieties and the defect center in the silicate network were detected at room temperature, but fluorescence from the excimer and the defect center were not detected at 77 K for crystal-like Ph-PMO dispersed in a methanol/ethanol mixed solvent. The decay curve of the exciton fluorescence of crystal-like Ph-PMO at room temperature was analyzed successfully using a one-dimensional diffusion model quenched by the defect center and the excimer site. The results were discussed in comparison with those for the crystal-like biphenylene-bridged PMO reported in the preceding paper (Yamanaka et al., Phys. Chem. Chem. Phys., 2010, 12, 11688-11696). The existence of excited states with various conformations including ground state dimers or aggregates of the Ph moieties was suggested for amorphous Ph-PMO. It was clearly apparent that the differences in the excited state dynamics reflected the differences in the molecular-level structure in the wall.     

Interplay between magnetism and conductivity derived from spin-polarized donor radicals

Tutorial review: to achieve molecule-based spintronic devices, an organic conducting magnet that exhibits both conductivity and magnetism in a cooperative manner must be constructed. As a building block for such new materials, a spin-polarized donor radical, which serves as a molecular "spin-filter" in its singly oxidized state, was designed and synthesized. The resistivity of ion radical salts of selenium-substituted, tetrathiafulvalene-based spin-polarized donor radicals decreased substantially in the presence of a magnetic field, thus indicating cooperative conductivity and magnetism.     

MYCOCHROME SYSTEM AND CONIDIAL DEVELOPMENT IN CERTAIN FUNGI IMPERFECTI

Abstract. A photoreceptor system, “mycochrome”, is involved in a blue and near UV reversible photo-reaction which in turn plays an important role in the photocontrol of conidial development in Alternaria tomato, Botrytis cinerea and Helminthosporium oryzae. Conidial development was controlled by alternating exposures to blue and near UV light with the final response being determined by the final light received. When the final light was near UV a conidium developed; when it was blue, conidiation was inhibited and a “sterile” conidiophore was formed. The effects of the two lights were alternatively reversible. Blue and near UV reversible photoreaction was also found in a light-minus-dark difference spectrum of an intracellular particulate fraction isolated from dark-grown mycelia of A. tomato, and two pigments, P_B (blue absorbing type) and P_NUV (near UV absorbing type), were contained in that photoreaction. P_B was tightly bound to the particulate fraction and P_NUV was either soluble in the cytoplasm or very loosely bound to the particulate fraction. Blue and near UV reversible photoreaction occurred only under the coexistence of P_B and P_NUV. That is, a dip in the near UV region and peak absorbance in the blue region was induced by irradiation with near UV light; however, both conditions were partially dissipated with a subsequent irradiation of blue light. These absorbance changes were revers-ibly repeated by alternating doses of blue and near UV light. When molecular oxygen was introduced after exposure to near UV light, peak absorbance in the blue region rapidly disappeared, and these absorbance changes were repeatedly reversible. Similar results were obtained by treatment with sodium hydrosulfite and molecular oxygen. Thus, it was concluded that the mycochrome system suggested in photo-conidiation was consistent with certain active substances showing blue and near UV reversible absorbance changes and caused by photooxidation reduction reaction.     

Polymerization of coordinated monomers. III. Copolymerization of acrylonitrile–zinc chloride,methacrylonitrile–zinc chloride or methyl methacrylate–zinc chloride complex with styrene

The 1:1 or 2:1 complex of acrylonitrile, methacrylonitrile, or methyl methacrylate with ZnCl₂ was copolymerized with styrene at the temperature of 0–30°C without any initiator. The structure of the copolymer from methyl methacrylate complex and styrene was examined by NMR spectroscopy. The complexes of acrylonitrile or methacrylonitrile with ZnCl₂ gave a copolymer containing about 50 mole-% styrene units. The complexes of methyl methacrylate yielded an alternating copolymer when the feed molar ratio of methyl methacrylate to styrene was small, but with increasing feed molar ratio the resulting copolymer consisted of about 2 moles of methyl methacrylate per mole of styrene. The formation of a charge-transfer complex of styrene with a monomer coordinated to zinc atom was inferred from the ultraviolet spectra. The regulation of the copolymerization was considered to be effected by the charge-transfer complex. The copolymer resulting from the 2:1 methyl methacrylate–zinc chloride complex had no specific tacticity, whereas the copolymer from the 1:1 complex was richer in coisotacticity than in cosyndiotacticity. The change of the composition of the copolymer and its specific tacticity in the polymerization of the methyl methacrylate complex is related to the structure of the complex.     

Chalcogeno-Morita-Baylis-Hillman Reaction of Chalcogenide-Enones with Carbonyl Compounds

Abstract

The Chalcogeno-Morita-Baylis-Hillman reaction was achieved by the reactions of 2-(methylchalcogeno)phenyl vinyl ketones with carbonyl compounds or acetals in the presence of BF₃· Et₂O. This reaction proceeds via the intramolecular Michael addition of the chalcogenide group to an enone moiety followed by the aldol reaction of the resulting chalcogenonio-enolate with an aldehyde. The reactions were worked up with triethylamine or saturated aqueous NaHCO₃ to give the α -methylene aldols (the Morita-Baylis-Hillman adducts).     

Solvent extraction of tetrachloronitridotechnetate(VI) ion with tetraphenylarsonium chloride

Radiochemical and spectrophotometric studies on the solvent extraction of tetrachloronitridotechnetate(VI) ion with tetraphenylarsonium chloride into chloroform have been reported. Analysis of the dependence of the distribution ratio for technetium species on the concentration of hydrogen ion (0.1–1.0M) revealed that an equilibrium between tetrachloronitridotechnetate(VI) ion and [(H₂OCl₃NTc–O–TcNCl₃(H₂O)]^2– is established in the aqueous phase. However, formation of di(-O) dimer was suggested, when the concentration of hydrochloric acid is less than 0.2M. The extraction constant for technetium and formation constant for -oxo technetium nitrido complex were evaluated.     

Effect of Alkynyl Group on Reactivity in Photoaffinity Labeling with 2-Thienyl-Substituted α-Ketoamide

Minimalist photo-reactive probes, which consist of a photo-reactive group and a tag for detection of target proteins, are useful tools in chemical biology. Although several diazirine-based and aryl azide-based minimalist probes are available, no keto-based minimalist probe has yet been reported. Here we describe minimalist probes based on a 2-thienyl-substituted α-ketoamide bearing an alkyne group on the thiophene ring. The 3-alkyne probe showed the highest photo-affinity labeling efficiency.     

Mechanism of BPh3-Catalyzed N-Methylation of Amines with CO2 and Phenylsilane: Cooperative Activation of Hydrosilane

BPh₃ catalyzes the N-methylation of secondary amines and the C-methylenation (methylene-bridge formation between aromatic rings) of N,N-dimethylanilines or 1-methylindoles in the presence of CO₂ and PhSiH₃; these reactions proceed at 30–40 °C under solvent-free conditions. In contrast, B(C₆F₅)₃ shows little or no activity. ¹¹B NMR spectra suggested the generation of [HBPh₃]⁻. The detailed mechanism of the BPh₃-catalyzed N-methylation of N-methylaniline ( 1 ) with CO₂ and PhSiH₃ was studied by using DFT calculations. BPh₃ promotes the conversion of two substrates (N-methylaniline and CO₂) into a zwitterionic carbamate to give three-component species [Ph(Me)(H)N⁺CO₂⁻⋅⋅⋅BPh₃]. The carbamate and BPh₃ act as the nucleophile and Lewis acid, respectively, for the activation of PhSiH₃ to generate [HBPh₃]⁻, which is used to produce key CO₂-derived species, such as silyl formate and bis(silyl)acetal, essential for the N-methylation of 1 . DFT calculations also suggested other mechanisms involving water for the generation of [HBPh₃]⁻ species.     

Thermal stability of phthalate esters: Effect of substituents on the β-carbon atom

In order to clarify the mechanism conferring heat resistance on phthalate esters, those with a substituent on the β-carbon atom, such as bis(2-aminobutyl) phthalate, bis(2-nitrobutyl) phthalate, bis(2,4-diphenylbutyl) phthalate and dineopentyl phthalate, were synthesized and their thermal stabilities were studied by thermogravimetry and differential thermal analysis. The analytical results for these phthalate esters were compared with those for dibutyl phthalate, with a straight alkyl chain. As the temperatures required for a 3% weight loss of phthalate esters with a substituent, an electron-donating group (amino group) or an electron-accepting group (nitro group) on the β-carbon atom move to the higher end of the range, the effect of the adjacent group was recognized. The presence of a phenyl group in phthalate esters considerably improved the heat resistance. It is considered that the high heat resistance of bis(2,4-diphenylbutyl) phthalate is due to the obstruction of the planar configuration for cis elimination by the phenyl group and hindrance by the phenyl group of the formation of the six-membered cyclic transition state owing to the interaction between non-bondable molecules.