Novel superconducting phases in copper oxides and iron-oxypnictides: NMR studies

We reexamine the novel phase diagrams of antiferromagnetism (AFM) and high-T_c superconductivity (HTSC) for a disorder-free CuO₂ plane based on an evaluation of local hole density (p) by site-selective Cu-NMR studies on multilayered copper oxides. Multilayered systems provide us with the opportunity to research the characteristics of the disorder-free CuO₂ plane. The site-selective NMR is the best and the only tool used to extract layer-dependent characteristics. Consequently, we have concluded that the uniform mixing of AFM and SC is a general property inherent to a single CuO₂ plane in an underdoped regime of HTSC. The T=0 phase diagram of AFM constructed here is in quantitative agreement with the theories in a strong correlation regime which is unchanged even with mobile holes. This Mott physics plays a vital role for mediating the Cooper pairs to make T_c of HTSC very high. By contrast, we address from extensive NMR studies on electron-doped iron-oxypnictides La1111 compounds that the increase in T_c is not due to the development of AFM spin fluctuations, but because the structural parameters, such as the bond angle α of the FeAs₄ tetrahedron and the a-axis length, approach each optimum value. Based on these results, we propose that a stronger correlation in HTSC than in FeAs-based superconductors may make T_c higher significantly.     

Estimating the amplitude of measurement noise present in chaotic time series

We propose a method for estimating the amplitude of measurement noise present in chaotic time series. This method is based on the evaluation of initial errors for a given time series and for a new one synthesized by adding an adequate amount of noise to the given one. The method is valid over a much wider range of noise levels than the previous methods are because it is not based on the detail of dynamical structure which generates the data. In addition, it is possible to check if the method is valid for the given data prior to its application. To confirm the effectiveness of the method we show the results of numerical experiments and apply the method to chaotic data obtained from an electrochemical experiment. (c) 1999 American Institute of Physics.     

Reinvestigation of the thermoelectric properties of Ag8GeTe6

High‐density polycrystalline samples (above 98% of the theoretical density) of Ag₈GeTe₆ were prepared by solid‐state reactions of Ag₂Te, GeTe, and Te, followed by hot‐pressing. The thermoelectric properties were measured at temperatures ranging from room temperature to around 700 K. The thermal conductivity values were extremely low (0.25 Wm^–1 K^–1 at room temperature), and consequently Ag₈GeTe₆ exhibited a relatively high thermoelectric figure of merit, ZT = 0.48 at 703 K. (© 2008 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

On the global wellposedness for the nonlinear Schrödinger equations with L p -large initial data

We consider the Cauchy problem for the nonlinear Schrödinger equations $ \begin{array}{l} iu_t + \triangle u \pm |u|^{p-1}u =0, \qquad x \in \mathbb{R}^d, \quad t \in \mathbb{R} \\ u(x,0)= u_0(x), \qquad x \in \mathbb{R}^d \end{array} $ for 1 < p < 1 + 4/d and prove that there is a ${\rho (p ,d) \in (1,2)}We consider the Cauchy problem for the nonlinear Schr?dinger equations

l iut + \triangle u ±|u|p-1u = 0,        x ? \mathbbRd,     t ? \mathbbR u(x,0) = u0(x),        x ? \mathbbRd \begin{array}{l} iu_t + \triangle u \pm |u|^{p-1}u =0, \qquad x \in \mathbb{R}^d, \quad t \in \mathbb{R} \\ u(x,0)= u_0(x), \qquad x \in \mathbb{R}^d \end{array}      17. Time-series analysis of foreign exchange rates using time-dependent pattern entropy      Ryuji Ishizaki  Masayoshi Inoue 《Physica A》2013 Time-dependent pattern entropy is a method that reduces variations to binary symbolic dynamics and considers the pattern of symbols in a sliding temporal window. We use this method to analyze the instability of daily variations in foreign exchange rates, in particular, the dollar–yen rate. The time-dependent pattern entropy of the dollar–yen rate was found to be high in the following periods: before and after the turning points of the yen from strong to weak or from weak to strong, and the period after the Lehman shock.      18. Laser terahertz-emission microscope for inspecting electrical faults in integrated circuits      Kiwa T  Tonouchi M  Yamashita M  Kawase K 《Optics letters》2003,28(21):2058-2060 A laser terahertz-emission microscope (LTEM) system is proposed and developed for inspecting electrical faults in integrated circuits (IC). We test a commercial operational amplifier while the system is operating. Two-dimensional terahertz-emission images of the IC chip are clearly observed while the chip is scanned with a femtosecond laser. When one of the interconnection lines is cut, the damaged chip has a LTEM image different from that of normal chips. The results indicate that the LTEM system is a potential tool for IC inspection.      19. Lamellar thickening in nascent poly(acrylonitrile) upon annealing      Daisuke Sawai  Mika Miyamoto  Tetsuo Kanamoto  Masayoshi Ito 《Journal of Polymer Science.Polymer Physics》2000,38(19):2571-2579 No systematic study has been reported on the lamellar thickening in atactic poly(acrylonitrile) (PAN) upon annealing because PAN, in the form of solution‐cast films or their drawn products, generally shows no small‐angle X‐ray scattering (SAXS) maximum corresponding to the lamellar thickness. In this work, PAN crystals were precipitated during the thermal polymerization of acrylonitrile in solution. The nascent PAN film, obtained by the filtration of the crystal suspension, exhibited a clear SAXS maximum revealing the lamellar structure. The lamellar thickening upon annealing of the nascent PAN films was studied in the temperature range 100–180 °C, where the degradation was minimal, as confirmed by the absence of an IR absorption band at 1605 cm−1 ascribed to the cyclized nitrile groups. Above 190 °C, the degradation of the samples was significant, and the SAXS became too broad to determine the scattering maximum. The long period was significantly affected by the annealing time (ta) and the temperature (Ta). Depending on ta, three stages were observed for the lamellar thickening behavior. The lamellar thickness stayed constant in stage I (ta = 0.5–3 min, depending on Ta), rapidly increased in stage II (ta = 0.5–8 min), and stayed at a constant value characteristic for each Ta at yet longer ta's in stage III. The lamellar thickness characteristic for Ta increased rapidly with increasing Ta at 165 °C (or higher), which was 152 °C lower than the estimated melting temperature of PAN (Tm = 317 °C). A possible mechanism for such lamellar thickening in PAN far below the Tm is discussed on the basis of the enhanced chain mobility in the crystalline phase above the crystal/crystal reversible transition at 165–170 °C detected by differential scanning calorimetry and wide‐angle X‐ray diffraction. The structural changes associated with annealing are also discussed. © 2000 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 38: 2571–2579, 2000      20. Computation of the reduction free energy of coenzyme in aqueous solution by the QM/MM-ER method      Hideaki Takahashi  Hajime Ohno  Ryohei Kishi  Masayoshi Nakano  Nobuyuki Matubayasi 《Chemical physics letters》2008,456(4-6):176-180 In a recent development we proposed a quantum chemical approach to compute free energy change for chemical reactions in condensed phases by combining the QM/MM method with the theory of energy representation (QM/MM-ER). We extend in this Letter the novel approach to compute reduction free energy of isoalloxazine ring of FAD (flavin adenine dinucleotide) immersed in water within the framework of the QM/MM-ER method. The characteristic feature of our approach is that the excess electron to be attached on the FAD is identified as a solute. The reduction free energy has been obtained as −80.1 kcal/mol in the aqueous solution.      [首页] « 上一页 [1] 2 [3] [4] [5] [6] [7] [8] [9] [10] [11] 下一页 » 末  页»

Time-series analysis of foreign exchange rates using time-dependent pattern entropy

Time-dependent pattern entropy is a method that reduces variations to binary symbolic dynamics and considers the pattern of symbols in a sliding temporal window. We use this method to analyze the instability of daily variations in foreign exchange rates, in particular, the dollar–yen rate. The time-dependent pattern entropy of the dollar–yen rate was found to be high in the following periods: before and after the turning points of the yen from strong to weak or from weak to strong, and the period after the Lehman shock.     

Laser terahertz-emission microscope for inspecting electrical faults in integrated circuits

A laser terahertz-emission microscope (LTEM) system is proposed and developed for inspecting electrical faults in integrated circuits (IC). We test a commercial operational amplifier while the system is operating. Two-dimensional terahertz-emission images of the IC chip are clearly observed while the chip is scanned with a femtosecond laser. When one of the interconnection lines is cut, the damaged chip has a LTEM image different from that of normal chips. The results indicate that the LTEM system is a potential tool for IC inspection.     

Lamellar thickening in nascent poly(acrylonitrile) upon annealing

No systematic study has been reported on the lamellar thickening in atactic poly(acrylonitrile) (PAN) upon annealing because PAN, in the form of solution‐cast films or their drawn products, generally shows no small‐angle X‐ray scattering (SAXS) maximum corresponding to the lamellar thickness. In this work, PAN crystals were precipitated during the thermal polymerization of acrylonitrile in solution. The nascent PAN film, obtained by the filtration of the crystal suspension, exhibited a clear SAXS maximum revealing the lamellar structure. The lamellar thickening upon annealing of the nascent PAN films was studied in the temperature range 100–180 °C, where the degradation was minimal, as confirmed by the absence of an IR absorption band at 1605 cm⁻¹ ascribed to the cyclized nitrile groups. Above 190 °C, the degradation of the samples was significant, and the SAXS became too broad to determine the scattering maximum. The long period was significantly affected by the annealing time (t_a) and the temperature (T_a). Depending on t_a, three stages were observed for the lamellar thickening behavior. The lamellar thickness stayed constant in stage I (t_a = 0.5–3 min, depending on T_a), rapidly increased in stage II (t_a = 0.5–8 min), and stayed at a constant value characteristic for each T_a at yet longer t_a's in stage III. The lamellar thickness characteristic for T_a increased rapidly with increasing T_a at 165 °C (or higher), which was 152 °C lower than the estimated melting temperature of PAN (T_m = 317 °C). A possible mechanism for such lamellar thickening in PAN far below the T_m is discussed on the basis of the enhanced chain mobility in the crystalline phase above the crystal/crystal reversible transition at 165–170 °C detected by differential scanning calorimetry and wide‐angle X‐ray diffraction. The structural changes associated with annealing are also discussed. © 2000 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 38: 2571–2579, 2000     

Computation of the reduction free energy of coenzyme in aqueous solution by the QM/MM-ER method

In a recent development we proposed a quantum chemical approach to compute free energy change for chemical reactions in condensed phases by combining the QM/MM method with the theory of energy representation (QM/MM-ER). We extend in this Letter the novel approach to compute reduction free energy of isoalloxazine ring of FAD (flavin adenine dinucleotide) immersed in water within the framework of the QM/MM-ER method. The characteristic feature of our approach is that the excess electron to be attached on the FAD is identified as a solute. The reduction free energy has been obtained as −80.1 kcal/mol in the aqueous solution.