Ce-MCM-48立方介孔分子筛结构的光谱表征

在碱性条件下,以混合模板剂pH调节水热合成了掺入铈的介孔分子筛Ce-MCM-48,并采用XRD,DRUV-Vis(紫外-可见漫反射),FTIR,XRF结合BET等测试手段对样品进行表征。实验结果表明,采用本方法所合成的掺铈介孔材料仍保持立方介孔的有序结构,同时适量的铈的掺入和pH调节使分子筛的有序性及吸附性能得到改善,晶胞参数增大,孔径更均一,孔壁增厚。从而可推出Ce-MCM-48的热稳定性、水热稳定性、催化活性及择形选择性可得到提高。掺入的铈以四配位状态高度分散在介孔的有序结构当中。红外光谱表明不同量的铈的掺入对骨架硅的各种振动扰动程度不同。     

激光熔覆硬质合金强化化纤切断刀的研究

在机械压制法预置硬质合金WC/Co粉末的条形55Si2Mn弹簧钢上,用激光熔覆方法制备了化纤切断刀.调整熔覆层粉末配方中Al、TiC的加入量,结果表明加适量的Al粉能有效地抑制气孔,加TiC粉末能提高熔覆硬度.通过优化激光熔覆工艺参数,得到了无气孔缺陷、组织性能良好、硬度达到HV0.21250的激光熔覆层,达到了化纤切断刀的性能要求.     

光寻址电位传感器的正交相位检波检测方法

光寻址电位传感器的幅度检测方法易受噪声干扰,灵敏度差,信噪比和精度低,且受调制光源的影响较大,影响检测结果的准确性.为此提出了一种基于正交相位检波的光寻址电位传感器检测方法.该方法是将光寻址电位传感器的输出光电流信号分别与两路正交信号相乘,通过低通滤波提取直流分量并相除,即可得到光寻址电位传感器的输出信号相位信息.与已有的光寻址电位传感器相位检测方法相比,该方法具有算法复杂度低、实时性高的优点.实验研究了调制光源光强对光寻址电位传感器幅度检测和相位检测的影响,对比分析了光寻址电位传感器的传统幅度检测方法与正交相位检波检测方法对pH检测的灵敏度、线性度及信噪比.结果表明,相比于幅度检测方法,调制光源光强对光寻址电位传感器的相位检测影响更小,在频率为10 kHz,pH的范围为1.68~10.01的情况下,相位检测方法比幅度检测方法测得的灵敏度增加了7 mV/pH,精度提高了14.9 mpH,非线性误差减小了0.003%,均方差减少了0.1051×10^-5,信噪比增加了8.2827 dB.该方法特别适用于弱光下的光寻址电位传感器检测.     

二茂铁咪唑盐的合成及其在Suzuki-Miyaura反应中的应用

合成了硫醚官能化、膦官能化及未官能化的二茂铁咪唑盐,并研究了以其作为N-杂环卡宾配体前体对Pd催化的Suzuki-Miyaura偶联反应的影响,发现在4-甲基溴苯与苯硼酸偶联反应中以膦官能化的配体对催化性能提高有利,而硫醚官能化不利于催化性能提高。     

Synthesis,Structure and Photoluminescence of Co-crystal of Bis[2-(benz(oxa/imida)zol-2-yl)phenolato-κ2N,O]zinc(Ⅱ) Being Site Occupancy Disorder with a Heteroatom Ratio of NH to O (0.408/0.592)

The zinc(Ⅱ) complex with Hpbx (Hpbx = 2-(benzoxazol-2-yl)phenol) and Hpbm (Hpbm=2-(benzimidazol-2-yl)phenol),namely[Zn(pbm)2]1.633[Zn(bpx)2]2.367·DMF·2H2O1,has been synthesized and characterized by X-ray crystallography,FTIR and elemental analysis.The coordination structures are statistically disordered and can be regarded as a co-crystal of [Zn(pbm)2]and [Zn(pbx)2] with the ratio of ca.0.408/0.592.Solvate water and DMF molecules are also present in the lattice.Crystal data for 1:monoclinic,space group P21/c,Mr= 2049.02,Z = 2,α = 9,7571(6),b = 25.6415(16),c = 19.8675(10)(A),β = 111.342(2)°,V = 4629.7(5) (A)3,Dc = 1.470 g/cm3,μ =1.100 mm-1,F(000) = 2104,R = 0.0575 and wR = 0.1282 for 5528 observed reflections (I＞ 2σ(I)).The photoluminescent spectra for this compound have also been studied.     

Synthesis, Structure and Geometrical Calculation of a Novel Co-crystal of {[4-Bromo-2-(benzimidazol-2-yl)phenolato][2- (1-butylbenzimidazol-2-yl)phenolato]zinc(Ⅱ)] and Bis[μ-2- (1- butylbenzimidazol-2-yl)phenolato]- 1κN3: 2κO; 1κO:2κN3-bis{[2-(1-butylbenzimidazol-2-yl)phenolato-κ2N3,O]zinc(Ⅱ)}

The title compound has been synthesized and characterized crystallographically. It is a co-crystal consisting of two different neutral zinc(Ⅱ) complexes with Hbpbm (Hbpbm = 4-bromo-2-(benzimidazol-2-yl)phenol) and Hnpbm (Hnpbm = 2-(1-butylbenzimidazol-2-yl)phenol).One is a monomeric mixed-ligand complex of [Zn(bpbm)(npbm)] 1 and the other a dimer of[Zn2(npbm)4] 2 with their ratio of 2:1. Thus the overall formula for the title compound is 21·2.Adjacent 1 and 2 are connected to each other by intermolecular hydrogen bonding interactions in the lattice. The crystal data: monoclinic, space group P21/c, a= 15.0141(12), b = 20.9941(17), c =18.4686(15) (A), β = 97.445(2)°, V= 5772.4(8) (A)3, Mr= 2429.68, Z = 2, Dc = 1.398 g/cm3,μ = 1.579mm-1, F(000) = 2504, R = 0.0637 and wR = 0.1771 for 6464 observed reflections (I＞ 2σ(Ⅰ)). The geometrical structure for 1 has also been theoretically optimized and compared with the experimental one.     

Synthesis, Structure and Optical Properties of Cerium(Ⅲ) Triphosphate CeP3O9

The single crystal and crystallized powder of triphosphate CeP3O9 have been synthesized, and the space group of CeP3O9 has been determined to be C2221 with the cell parameters ofa = 8.6059, b = 11.2437, c = 7.3518 (A), V= 711.4(3) (A)3, Z= 4, Dc = 3.520 g/cm3, F(000) = 700,R = 0.0377 and wR = 0.0930. The absorption and emission spectra have been measured, for which the strongest absorption and emission peaks are located at 280 and 320 nm, respectively. The density of state (DOS) and dielectric function have been calculated by the DFT method. The crystal is transparent provided the wavelength is larger than 341 nm, and the observed ultraviolet cut-off edge is at about 350 nm for a polycrystalline power sample. It is possible that the triphosphate CeP3O9 will become an ultraviolet emission material.     

QSAR Study of Thieno [2,3-d] Pyrimidine as a Promising Scaffold Using HQSAR,CoMFA and CoMSIA

In this study, Co MFA, Co MSIA and HQSAR techniques were used to study the important characteristic activities of thieno [2,3-d] pyrimidine derivatives for effective antitumor activity. The q~2 value of cross validation of CoMFA model was 0.621, and r~2 value of non-cross validation was 0.959. The best cross validation q~2 value of CoMSIA model was 0.522, while the r~2 value of non-cross validation was 0.961. The most effective HQSAR model was obtained by taking atoms and bonds as fragments: the q~2 value of cross validation is 0.535, the r~2 value of non-cross validation is 0.871, the standard error of prediction is 0.488, and the optimal hologram length is 199. The statistical parameters from the model show that the data fit well and have high prediction ability. In addition, molecular docking is used to study the binding requirements between ligands and receptor proteins, including several hydrogen bonds between thieno [2,3-d] pyrimidine and active site residues. The results obtained from these QSAR modeling studies can be used to design promising anticancer drugs.     

介孔铁铝/蒙脱土复合材料：解离柱撑制备、结构及催化羟基化性能

利用极稀悬浮液中蒙脱土的解离作用并结合柱化技术过程，制备了介孔结构的铝铁/蒙脱土复合材料(Fe-Al/mmt)；并采用粉末X射线衍射、氮等温吸脱附、傅立叶红外光谱、紫外可见光漫反射光谱及苯酚催化羟基化反应表征了其结构和性能。结果显示，铁铝聚合前驱液中铁/铝比影响复合材料中蒙脱土的解离程度，且仅当低铁/铝比时(即Fe/(Fe+Al)物质的量的比介于0.05～0.3)，嵌入解离的蒙脱土片层间的混合铁铝物种呈现能耐温350 ℃的热稳定性；氮等温吸脱附分析反映出这种解离的蒙脱土堆积结构呈现介孔特征，孔径分布窄，介于2.0～2.3 nm；红外分析表明材料表面具有L酸和B酸位，并且L酸位量与嵌入解离的蒙脱土结构中的混合铁铝物种相关；由于结构中混合铁铝物种的存在及相应的Si-O → Fe、Al-O → Fe间的电子跃迁，Fe-Al/mmt材料在紫外区呈现宽泛的能量吸收特征。这些结果说明，由于混合铁铝物种嵌入于解离的蒙脱土片层堆积结构中，形成了“卡片屋”式介孔结构。实验条件下，Fe/(Fe+Al)物质的量的比为0.3的Fe-Al/mmt呈现较佳的催化羟基化性能，苯酚转化率为36.7%，二酚产物选择性32.3%；并且初步表明铝掺杂后，通过铁铝比和表面酸性的调整，材料的部分选择氧化性能可以得到改善。     

锰/钴-二氰胺-4-(1-咪唑基)苯胺三元配合物的合成与结构表征

以二氰胺钠[Na(dca)]和4-(1-咪唑基)苯胺(L)为共配体分别与锰盐和钴盐反应合成了2种新的配合物：零维[Mn(L)₂(dca)₂(H₂O)₂] (1)和二维[Co(L)₂(dca)](dca)_0.5(ClO₄)_0.5·1.5H₂O·MeOH (2)。通过元素分析、红外光谱和X射线单晶衍射对其进行了表征。配合物1属于三斜晶系，P1空间群。配合物2晶体属于正交晶系，Cmcm空间群。配合物1是1个中心对称的单核结构，锰(Ⅱ)离子与分别来自2个dca和2个L配体的4个氮原子以及2个水分子配位，形成八面体配位几何，L和dca均为单齿配位；配合物2是由混合桥dca和L组装成的二维配位聚合物网状结构，相邻的二维网以面对面方式堆积，沿c轴方向形成一维孔道，里面填充着未配位的反离子和溶剂分子。