Graphene sheet-encased silica/sulfur composite cathode for improved cyclability of lithium-sulfur batteries

Journal of Solid State Electrochemistry - The “shuttle effect” of polysulfides is a serious issue, resulting in a decrease in the life-cycle of lithium-sulfur (Li-S) batteries. To...     

Montmorillonite KSF-Catalyzed Synthesis of 2,2′-(Arylmethylene)bis(3-hydroxy-5,5-dimethylcyclohex-2-en-1-ones) for the Functionalization of MCM-41 Silica Nanoparticles

Russian Journal of Organic Chemistry - A green protocol has been developed for the preparation of 2,2′-(arylmethylene)bis(3-hydroxy-5,5-dimethylcyclohex-2-en-1-ones) following the...     

Mechanistic Aspects of a Highly Active Dinuclear Zinc Catalyst for the Co‐polymerization of Epoxides and CO2

The dinuclear zinc complex reported by us is to date the most active zinc catalyst for the co‐polymerization of cyclohexene oxide (CHO) and carbon dioxide. However, co‐polymerization experiments with propylene oxide (PO) and CO₂ revealed surprisingly low conversions. Within this work, we focused on clarification of this behavior through experimental results and quantum chemical studies. The combination of both results indicated the formation of an energetically highly stable intermediate in the presence of propylene oxide and carbon dioxide. A similar species in the case of cyclohexene oxide/CO₂ co‐polymerization was not stable enough to deactivate the catalyst due to steric repulsion.     

Anisotropic Elastic-Viscoplastic Properties at Finite Strains of Injection-Moulded Low-Density Polyethylene

Injection-moulding is one of the most common manufacturing processes used for polymers. In many applications, the mechanical properties of the product is of great importance. Injection-moulding of thin-walled polymer products tends to leave the polymer structure in a state where the mechanical properties are anisotropic, due to alignment of polymer chains along the melt flow direction. The anisotropic elastic-viscoplastic properties of low-density polyethylene, that has undergone an injection-moulding process, are therefore examined in the present work. Test specimens were punched out from injection-moulded plates and tested in uniaxial tension. Three in-plane material directions were investigated. Because of the small thickness of the plates, only the in-plane properties could be determined. Tensile tests with both monotonic and cyclic loading were performed, and the local strains on the surface of the test specimens were measured using image analysis. True stress vs. true strain diagrams were constructed, and the material response was evaluated using an elastic-viscoplasticity law. The components of the anisotropic compliance matrix were determined together with the direction-specific plastic hardening parameters.