Numerical study of simultaneous natural convection heat transfer from both surfaces of a uniformly heated thin plate with arbitrary inclination

 Numerical studies were conducted to investigate the natural convection heat transfer around a uniformly heated thin plate with arbitrary inclination in an infinite space. The numerical approach was based on the finite volume technique with a nonstaggered grid arrangement. For handling the pressure–velocity coupling the SIMPLE-algorithm was used. QUICK scheme and first order upwind scheme were employed for discretization of the momentum and energy convective terms respectively. Plate width and heating rate were used to vary the modified Rayleigh number over the range of 4.8×10⁶ to 1.87×10⁸. Local and average heat transfer characteristics were compared with regarding to the inclination angle. The empirical expressions for local and average Nusselt number were correlated. It has been found that for inclination angle less than 10^∘, the flow and heat transfer characteristics are complicated and the average Nusselt number can not be correlated by one equation while for inclination angle larger than 10^∘, the average Nusselt number can be correlated into an elegant correlation. Received on 18 April 2001 / Published online: 29 November 2001     

A rapid and sensitive extractive spectrophotometric determination of copper(II) in pharmaceutical and environmental samples using benzildithiosemicarbazone.

Benzildithiosemicarbazone (BDTSC) is proposed as a sensitive and selective analytical reagent for the extractive spectrophotometric determination of copper(II). BDTSC reacts with copper(II) in the pH range 1.0-7.0 to form a yellowish complex. Beer's law is obeyed in the concentration range 0.5-0.4 microg cm(-3). The yellowish Cu(II)-BDTSC complex in chloroform shows a maximum absorbance at 380 nm, with molar absorptivity and Sandell's sensitivity values of 1.63 x 10(4) dm3 mol(-1) cm(-1) and 0.00389 microg cm(-2), respectively. A repetition of the method is checked by finding the relative standard deviation (RSD) (n = 10), which is 0.6%. The composition of the Cu(II)-BDTSC complex is established as 1:1 by slope analysis, molar ratio and Asmus' methods. An excellent linearity with a correlation coefficient value of 0.98 is obtained for the Cu(II)-BDTSC complex. The instability constant of the complex calculated from Edmond and Birnbaum's method is 7.70 x 10(-4) and that of Asmus' method is 7.66 x 10(-4), at room temperature. The method is successfully employed for the determination copper(II) in pharmaceutical and environmental samples. The reliability of the method is assured by analyzing the standard alloys (BCS 5g, 10g, 19e, 78, 32a, 207 and 179) and by inter-comparison of experimental values, using an atomic absorption spectrometer.     

Effective thermal conductivity of water-saturated sintered powder-metal plates

An experimental apparatus and related procedures for the determination of the effective thermal conductivity of sintered powder-metal plates saturated with distilled water at temperatures in the range 20–150°C are discussed. The apparatus and procedures are applied to two samples of sintered powder-metal plates, one made of nickel 200 and the other of stainless steel 316, with porosities of 28.10 and 46.45%, respectively, and each of nominal dimensions 127 mm × 127 mm × 6.35 mm. The experimental results are compared with corresponding predictions yielded by several correlations available in the literature. The correlations based on experimental data for packed beds of spherical particles and also porous plates made of cold-pressed (but not sintered) particles of angular shapes do not apply well to sintered powder-metal plates. A new correlation, which is based on extensions of ideas contained in earlier works and provides improved predictions, is proposed.     

Interpretation of the polyelectrolyte and antipolyelectrolyte effects of poly(N‐vinylimidazole‐co‐sodium styrenesulfonate) hydrogels

Hydrogels of N‐vinylimidazole (VI) and sodium styrenesulfonate (SSS) were synthesized in aqueous solution by radical crosslinking copolymerization with N,N′‐methylene‐bis(acrylamide) as crosslinker. Swelling in several saline solutions was measured for hydrogel samples synthesized with different comonomer concentrations (C_T = 10, 25, or 40%) and with SSS mole fractions covering a broad range (f_SSS = 0–0.7), while the crosslinker ratio was 2 wt % in all cases. The degree of swelling in aqueous solution with a specific ionic strength (μ), plotted versus the SSS composition of the feed, shows a minimum for any set of samples synthesized with a fixed C_T. The dependence of swelling on μ shows both polyelectrolyte (f_SSS beyond the minimum) and antipolyelectrolyte behaviors (in the low f_SSS limit). It was found that the nonGaussian factor of the crosslinking density and the polymer‐solvent interaction parameter increase with f_SSS for any C_T. Moreover, in the low f_SSS limit, the osmotic swelling pressure is governed not only by the ionic contribution, but also by the polymer‐solvent mixing and, the concentration of mobile counterions inside the gel is not proportional to the net fixed charge but to the addition of cationic and anionic side groups, what discards the formation of ionic pairs. The antipolyelectrolyte effect is interpreted as due to the increasing protonation of VI as μ goes up. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1683–1693, 2007     

Vortex ring generation due to the coalescence of a water drop at a free surface

 Results are presented of an experimental investigation of vortex ring formation by a fluid drop contacting a free surface with negligible velocity. The pool fluid is mixed with fluorescein dye, and a laser sheet is used to illuminate a plane of the flow. A series of representative images is recorded by a CCD camera and speculation is made regarding specific sources of vorticity flux through the free surface. Two scaling analyses previously presented by other investigators are demonstrated to be equivalent under the assumptions of this experiment, and they provide the motivation for a series of test runs in which the duration of the coalescence process, τ_*, is related to variations in drop diameter L and fluid surface tension σ. Experimental results are in agreement with the analyses, showing τ_*∼σ^-1/2 and τ_*∼L ^3/2. Received: 22 December 1995 / Accepted: 15 October 1996     

On the dispersion of a solute in oscillating flow of a non-Newtonian fluid in a channel

The paper presents an exact analysis of the dispersion of an immiscible solute in a non-Newtonian fluid (known as an incompressible second-order fluid which shows viscoelastic behaviour) flowing slowly in a parallel plate channel in the presence of a periodic pressure gradient. Using a generalized dispersion model which is valid for all times after the solute injection, the diffusion coefficients K _i (τ)(i=1,2,3,…) are obtained as functions of time τ in the case when the initial solute distribution is in the form of a slug of finite extent. The analysis leads to the novel result that K ₂(τ) (which is a measure of the longitudinal dispersion coefficient of the solute) has a steady part S in addition to a fluctuating part D ₂(τ) due to the pulsatility of the flow. It is found that S decreases with increase in the viscoelastic parameter M for given values of the amplitude λ and frequency ω of the pressure pulsation. On the other hand, it is found that at a fixed instant τ, the amplitude of D ₂(τ) increases with increase in M for given values of λ and ω. Further it is shown that at a given instant τ, the amplitude of D ₂(τ) decreases with increase in ω for given λ and M and the profile for D ₂(τ) becomes progressively flatter with increase in ω. Finally the axial distribution of the average concentration θ _m of the solute over the channel cross-section is determined at different instants after the solute injection for several values of M, λ and ω. The present study is likely to have important bearing on the problem of dispersion of tracers in blood flow through arteries.     

On the embedding problem with noncommutative kernel of order p4. VI

In the case of number fields the embedding problem of a p-extension with non-Abelian kernel of order p⁴ is studied. The two kernels of order 3⁴ with generators α, γ and relations α⁹ = 1, [α,α]³=1,[α,αγγ]==1,[αγγ]=α³,γ³=1 or γ³=α³ and the kernel of order 2⁴ with generators α, β, γ and relations α⁴=1 β²,[αγ]=1, [α,γ]=1,[βγ]=α² are considered. For kernels of odd order the embedding problem is always solvable. For the kernel of order 16 the solvability conditions are reduced to those for the associated problems at the Archimedean points, and to the compatibility condition. Bibliography: 9 titles. Translated fromZapiski Nauchnykh Seminarov POMI, Vol. 227, 1995, pp. 74–82.     

A note on dephasing and pair-breaking

It is shown that the dephasing which suppresses the weak localization correction to the conductivity has the same physical origin than pair-breaking in superconductors and thus-following de Gennes-may be expressed in terms of the correlation function of the operator for time reversal.     

Unoccupied electronic states of epitaxial iron layers on Cu(100)

Inverse photoemission spectra were taken for thin epitaxial iron films on Cu(100). For a film thickness of eight monolayers the observed electronic states are characteristic for a fcc(100) surface. Thed-bands of iron show a ferromagnetic exchange splitting of 1.1 eV, considerably smaller than the bulk value of 1.8 eV, which we observe for film thicknesses above 18 monolayers.