Photopolymerization of 1,6‐hexanedioldiacrylate initiated by three‐component systems based on N‐arylphthalimides

Three‐component photoinitiators comprised of an N‐arylphthalimide, a diarylketone, and a tertiary amine were investigated for their initiation efficiency of acrylate polymerization. The use of an electron‐deficient N‐arylphthalimide resulted in a greater acrylate polymerization rate than an electron‐rich N‐arylphthalimide. Triplet energies of each N‐arylphthalimide, determined from their phosphorescence spectra, and the respective rate constants for triplet quenching by the N‐arylphthalimide derivatives (acquired via laser flash photolysis) indicated that an electron–proton transfer from an intermediate radical species to the N‐arylphthalimide (not energy transfer from triplet sensitization) is responsible for generating the initiating radicals under the conditions and species concentrations used for polymerization. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 4009–4015, 2004     

Strain hardening of polycarbonate in the glassy state: Influence of temperature and molecular weight

This study is concerned with the temperature and molecular weight dependence of the strain-hardening behavior of polycarbonate. It is shown that the strain-hardening modulus reduces with increasing temperature and decreasing molecular weight. This result is interpreted in terms of temperature accelerated relaxation of the entanglement network. Moreover, it is shown that frozen-in orientations, induced by homogeneous deformations above the glass transition temperature, lead to anisotropic yield behavior that can be fully rationalized (and modelled) in terms of a superimposed stress contribution of the prestrained network. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2041–2049, 2004     

Amine‐cured epoxy/clay nanocomposites. II. The effect of the nanoclay aspect ratio

The thermophysical and mechanical properties of a nanocomposite material composed of amine‐cured diglycidyl ether of bisphenol A (DGEBA) reinforced with organomontmorillonite clay are reported. The storage modulus at 100 °C, which was above the glass‐transition temperature (T_g), increased approximately 350% with the addition of 10 wt % (6.0 vol %) of clay. Below the T_g, the storage modulus at 30 °C increased 50% relative to the value of unfilled epoxy. It was determined that the T_g linearly increased as a function of clay volume percent. The tensile modulus of epoxy at room temperature increased approximately 50% with the addition of 10 wt % of clay. The reinforcing effect of the organoclay nanoplatelets is discussed with respect to the Tandon–Weng and Halpin–Tsai models. A pseudoinclusion model is proposed to describe the behavior of randomly oriented, uniformly dispersed platelets in nanocomposite materials. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4391–4400, 2004     

Oxidation of isoniazid by quinolinium dichromate in an aqueous acid medium and kinetic determination of isoniazid in pure and pharmaceutical formulations.

The kinetics of oxidation of isoniazid in acidic medium was studied spectrophotometrically. The reaction between QDC and isoniazid in acid medium exhibits (4:1) stoichiometry (QDC:isoniazid). The reaction showed first order kinetics in quinolinium dichromate (QDC) concentration and an order of less than unity in isoniazid (INH) and acid concentrations. The oxidation reaction proceeds via a protonated QDC species, which forms a complex with isoniazid. The latter decomposes in a slow step to give a free radical derived from isoniazid and an intermediate chromium(V), which is followed, by subsequent fast steps to give the products. The reaction constants involved in the mechanism are evaluated. Isoniazid was analyzed by kinetic methods in pure and pharmaceutical formulations.     

Ultrahigh‐molecular‐weight‐polyethylene‐fiber surface treatment by electron‐beam‐irradiation‐induced graft polymerization and its effect on adhesion in a styrene–butadiene rubber matrix

Aiming to develop a high‐performance fiber‐reinforced rubber from styrene–butadiene rubber (SBR), we applied a special technique using electron‐beam (EB)‐irradiation‐induced graft polymerization to ultrahigh‐molecular‐weight‐polyethylene (UHMWPE) fibers. The molecular interaction between the grafted UHMWPE fibers and an SBR matrix was studied through the evaluation of the adhesive behavior of the fibers in the SBR matrix. Although UHMWPE was chemically inert, two monomers, styrene and N‐vinyl formamide (NVF), were examined for graft polymerization onto the UHMWPE fiber surface. Styrene was not effective, but NVF was graft‐polymerized onto the UHMWPE fibers with this special method. A methanol/water mixture and dioxane were used as solvents for NVF, and the effects of the solvents on the grafting percentage of NVF were also examined. The methanol/water mixture was more effective. A grafting percentage of 16.4% was the highest obtained. This improved the adhesive force threefold with respect to that of untreated UHMWPE fibers. These results demonstrated that EB irradiation enabled graft polymerization to occur even on the inert surface of UHMWPE fibers. However, the mechanical properties of the fibers could be compromised according to the dose of EB irradiation. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2595–2603, 2004     

On division rings with algebraic commutators of bounded degree

We shall answer several questions concerning additive or multiplicative commutators in a division ring which are algebraic of bounded degree over its center.     

Seizure warning algorithm based on optimization and nonlinear dynamics

There is growing evidence that temporal lobe seizures are preceded by a preictal transition, characterized by a gradual dynamical change from asymptomatic interictal state to seizure. We herein report the first prospective analysis of the online automated algorithm for detecting the preictal transition in ongoing EEG signals. Such, the algorithm constitutes a seizure warning system. The algorithm estimates STL_max, a measure of the order or disorder of the signal, of EEG signals recorded from individual electrode sites. The optimization techniques were employed to select critical brain electrode sites that exhibit the preictal transition for the warning of epileptic seizures. Specifically, a quadratically constrained quadratic 0-1 programming problem is formulated to identify critical electrode sites. The automated seizure warning algorithm was tested in continuous, long-term EEG recordings obtained from 5 patients with temporal lobe epilepsy. For individual patient, we use the first half of seizures to train the parameter settings, which is evaluated by ROC (Receiver Operating Characteristic) curve analysis. With the best parameter setting, the algorithm applied to all cases predicted an average of 91.7% of seizures with an average false prediction rate of 0.196 per hour. These results indicate that it may be possible to develop automated seizure warning devices for diagnostic and therapeutic purposes.Mathematics Subject Classification (1991):20E28, 20G40, 20C20     

On Einstein four-manifolds with <Emphasis Type="Italic">S</Emphasis><Superscript>1</Superscript>-actions

We study closed Einstein 4-manifolds which admit S¹ actions of a certain type, i.e., warped products. In particular, we classify them up to isometry when the fixed point of the S¹ action satisfies certain natural geometric conditions. The proof uses the Bochner-Weitzenböck formula for 1-forms and the theory of minimal surfaces in 3-manifolds.in final form: 22 January 2003     

Kinetic Models for Chemotaxis and their Drift-Diffusion Limits

Kinetic models for chemotaxis, nonlinearly coupled to a Poisson equation for the chemo-attractant density, are considered. Under suitable assumptions on the turning kernel (including models introduced by Othmer, Dunbar and Alt), convergence in the macroscopic limit to a drift-diffusion model is proven. The drift-diffusion models derived in this way include the classical Keller-Segel model. Furthermore, sufficient conditions for kinetic models are given such that finite-time-blow-up does not occur. Examples are given satisfying these conditions, whereas the macroscopic limit problem is known to exhibit finite-time-blow-up. The main analytical tools are entropy techniques for the macroscopic limit as well as results from potential theory for the control of the chemo-attractant density.Present address: Centro de Matemática e Aplicações Fundamentais, Universidade de Lisboa, Av. Prof. Gama Pinto 2, 1649-003, Lisboa, Portugal