Experimental investigation and theoretical modeling of liquid entrainment in a horizontal tee with a vertical-up branch

This article describes a comprehensive literature review of liquid entrainment in horizontal pipes with vertical-up branches. Deficiencies in the available data and correlations were identified. The Air–water Test Loop for Advanced Thermal–hydraulic Studies (ATLATS) was constructed and entrainment onset and steady-state data were collected for a wide range of flow conditions. Using new insights gained from experimental testing, the authors developed a model for predicting the onset of entrainment and steady-state entrainment rate. Previously published correlations, along with the new model, are compared against all available data. The new model shows very good agreement with the onset data, but is not very good at predicting branch quality at high liquid flow rates.     

Electron spin lifetimes in Hg0.78Cd0.22 Te and InSb

We have made direct pump–probe measurements of spin lifetimes in long wavelength narrow-gap semiconductors at wavelengths between 4 and 10 μm and from 4 to 300 K. In particular, we measure remarkably long spin lifetimes, τ_s300 ps, even at 300 K for epilayers of degenerate n-type InSb. In this material the mobility is approximately constant between 77 and 300 K, and we find that τ_s is approximately constant in this temperature range. In order to determine the dominant spin relaxation mechanism we have investigated the temperature dependence of τ_s in non-degenerate lightly n-type Hg_0.78Cd_0.22Te of approximately the same band gap as InSb, and find that τ_s varies from 356 ps at 150 K to 24 ps at 300 K. Our results, both in magnitude and temperature dependence of τ_s, imply that the Elliott–Yafet model dominates in these materials.     

Structural and vibrational properties of dilute GaNxAs1−x(P1−x)

We report a comprehensive analyzes of the Fourier transform infrared (FTIR) absorption and Raman scattering data on the structural and vibrational properties of dilute ternary GaAs_1−xN_x,[GaP_1−xN_x] (x<0.03) alloys grown on GaAs [GaP] by metal organic chemical vapor deposition (MOCVD) and solid source molecular beam epitaxy (MBE). By using realistic total energy and lattice dynamical calculations, the origin of experimentally observed N-induced vibrational features are characterized. Useful information is obtained about the structural stability, vibrational frequencies, lattice relaxations and compositional disorder in GaNAs (GaNP) alloys. At lower composition (x<0.015) most of the N atoms occupy the As [P] sublattice {N_As[N_P]}—they prefer moving out of their substitutional sites to more energetically favorable locations at higher x. Our results for the N-isotopic shifts of local mode frequencies compare favorably well with the existing FTIR data.     

Particle correlations in e + e − → W + W − events

Preliminary results are reported on the two-particle correlation function R(Q) in hadronic Z decays, fully hadronic WW decays, and mixed hadronic-leptonic WW decays using data collected by the DELPHI detector at LEP at energies between 189 and 206 GeV. Evidence for Bose-Einstein correlations was observed in all three cases. The event mixing technique was used to determine correlations between particles arisingfrom different W bosons in fully hadronic WW decays. An excess of like-sign particle pairs with low four-momentum difference in fully hadronic WW events is observed, consistent with the effect expected from correlations between identical particles from different W bosons.     

Stress relaxation and viscosity of a bulk Pd<Subscript>40</Subscript>Cu<Subscript>30</Subscript>Ni<Subscript>10</Subscript>P<Subscript>20</Subscript> metallic glass under isochronous heating conditions

Isochronous relaxation of tensile stresses is measured in a bulk Pd₄₀Cu₃₀Ni₁₀P₂₀ metallic glass in the initial state and after certain thermal treatments. The results of measurements are used to find the energy spectrum of irreversible structural relaxation, from which the temperature dependence of shear viscosity is then calculated. This dependence is also found independently from measurements of creep in the same glass. The calculated viscosity is shown to agree well with the experimental data.     

Use of ultrafine-dispersed nanodiamond for selective deposition of boron-doped diamond films

A suspension of ultrafine-dispersed nanodiamond was used for introducing (in particular, selectively) high-density centers of diamond nucleation on various substrates. High-quality doped diamond films to be used as electrochemistry electrodes were deposited from the gas phase in a microwave discharge on certain substrates treated using ultrafine-dispersed nanodiamond. A uniform distribution of nucleation centers with concentrations greater than 10¹⁰ cm^-2 on silicon substrates was obtained. Electrochemical current-potential curves were measured for continuous films. Diamond meshes of different transparency were grown using selective nucleation. Successful production of high-quality doped diamond meshes gives grounds to consider them the most promising electrodes for use in electrochemistry.     

Numerical simulation of the translational nonequilibrium zone behind a shock-wave front

The translational nonequilibrium zone in a shock wave is considered for a gas consisting of light particles and a small addition of heavy particles. The gas is taken to be two-dimensional, and long-range forces are assumed to be absent. In the framework of this approximation, a program for molecular dynamics simulation of the gas is developed. It is applied to calculate a particle distribution function in the shock wave, to analyze the time evolution of the distribution function, and to study its dependence on the gas composition.     

Effect of γ radiation from <Superscript>60</Superscript>Co on the formation of metal contacts to GaAs (Al<Subscript>x</Subscript>Ga<Subscript>1−<Emphasis Type="Italic">x</Emphasis></Subscript>As) structures

The properties of nonrectifying AuGe/GaAs (Al_0.4Ga_0.6As) contacts exposed to heat treatment, ⁶⁰Co γ radiation, and γ radiation combined with the application of an electrical bias are studied. A correlation between the type of interfacial interaction in the contacts and their resistance is found. Results obtained are explained in terms of a diffusion model with a movable boundary of the metal layer.     

Structure and properties of TiC-TiNi composites alloyed with iron

The structure, composition, and mechanical properties of iron-alloyed TiC-TiNi composite materials are studied. When the titanium carbide framework is sintered with iron and then impregnated with titanium nickelide, iron atoms are found to diffuse into the matrix and form the B2 structure that is inhomogeneous (gradient) in chemical composition and properties and exhibits various temperatures of martensitic transformation. The latter fact shows up in the broadening of the martensitic transformation hysteresis and its shift toward low temperatures with increasing iron content. At room temperature, the strength properties of gradient-matrix TiC-TiNi composites are shown to increase with iron concentration.