Critical evaluation of the use of total reflection X-ray fluorescence spectrometry for the analysis of whole blood samples: application to patients with thyroid gland diseases

Analytical and Bioanalytical Chemistry - Multielemental analysis of whole blood can provide significant information for the evaluation of nutritional status and diagnosis of certain diseases as...     

Applying Multivariate Methods in the Estimation of Bioactivity Properties of Acetamide Derivatives

JPC – Journal of Planar Chromatography – Modern TLC - It has been established that the selected acetamide derivatives fulfill Veber’s and Pardridge’s rule of good...     

Performance of anaerobic sequencing batch biofilm reactor submitted to different influent volume feeds and cycle time periods maintaining organic loading

The stability and efficiency of an anaerobic reactor containing biomass immobilized on polyurethane foam were assessed. The reactor with mechanical stirring of 500 rpm and maintained at 30+/-1 degrees C treated synthetic wastewater with a concentration of approx 500 mg of chemical oxygen demand/L and was fed with different influent volumes and cycle times maintaining organic load. Operation was in batch mode with renewal of only part of the volume of wastewater to be treated; that is reactor discharge was not complete, but partial. The main operational characteristic investigated was the ratio of the volume of wastewater fed per cycle (VA) to the volume of wastewater in the reactor (VA) maintaining the same volumetric organic load. This way, operating flexibility could be verified in relation to the volume of treated wastewater at each cycle and the cycle time for the same organic load. The results indicated that the reactor was able to operate with different VA/Vu ratios with no significant loss in performance, thus allowing increased operational flexibility. For conditions in which VA was >or=50% of VA, removal efficiencies of filtered and nonfiltered organic matter were about 84 and 79%, respectively, whereas at conditions of higher initial influent dilution, these efficiencies were slightly lower, about 80 and 74%, respectively. At higher initial influent dilutions, it became difficult to maintain a constant reactor medium volume, owing to a high formation rate of viscous polymer-like material, likely of microbiologic origin.     

The influence of the nanofiller on thermal properties of thermoplastic polyurethane elastomers

Pure Fe₃O₄ and Mn-doped Fe₃O₄ nanoparticles were synthesized by simple wet chemical reduction technique using nontoxic precursors. Manganese doping of two concentrations, 10 and 15%, were employed. All the three synthesized nanoparticles were characterized by stoichiometry, crystal structure, and surface morphology. Thermal studies on as-synthesized nanoparticles of pure ferrite (Fe₃O₄) and manganese (Mn) doped ferrites were carried out. The thermal analysis of the three as-synthesized nanoparticles was done by thermogravimetric (TG), differential thermogravimetric, and differential thermal analysis techniques. All the thermal analyses were done in nitrogen atmosphere in the temperature range of 308–1233 K. All the thermocurves were recorded for three heating rates of 10, 15, and 20 K min^?1. The TG curves showed three steps thermal decomposition for Fe₃O₄ and two steps thermal decompositions for Mn-doped Fe₃O₄ nanoparticles. The kinetic parameters of the three as-synthesized nanoparticles were evaluated from the thermocurves employing Kissinger–Akahira–Sunose (KAS) method. The thermocurves and evaluated kinetic parameters are discussed in this paper.     

Anodic deposition of lead dioxide at Nafion® covered gold electrode

Anodic electrodeposition of lead dioxide at the bare and Nafion® covered gold electrode was studied by cyclic voltammetry and chronoamperometry. The results showed that Nafion® layer has a favourable effect on the efficiency of the deposition process which was caused by both thermodynamic and kinetic reasons. Electrodeposition process at Nafion® covered gold electrode goes via Pb(III) intermediate species which are stabilized within Nafion® membrane. The final PbO₂ deposit crystallizes in tetragonal β-PbO₂ form.     

Chemical composition and antimicrobial activities of the essential oils from Ocimum selloi and Hesperozygis myrtoides

Ocimum selloi, a traditional medicinal plant from Brazil, is sold in open-air markets at Rio de Janeiro State. Hesperozygis myrtoides is a very aromatic small bush found in the State of Minas Gerais, Brazil, growing at an altitude of 1800m. The chemical composition of both essential oils was analyzed as well as their antimicrobial activity against fungi and bacteria. For all specimens of Ocimum selloi obtained at open-air markets, methylchavicol was major compound found (93.6% to 97.6%) in their essential oils. The major compounds identified in the oil of H. myrtoides were pulegone (44.4%), isomenthone (32.7%), and limonene (3.5%). Both oils displayed antimicrobial activity against all tested microorganisms but Candida albicans was the most susceptible one. Combinations of the two oils in different proportions were tested to verify their antimicrobial effect against C. albicans, which, however, was not modified in any of the concentrations tested. The minimum inhibitory concentration (MIC) was determined to confirm the antimicrobial activity against C. albicans as well as other clinical isolates (C. glabrata, C. krusei, C. parapsilosis and C. tropicalis).     

Antioxidant capacities and total phenolic contents increase with gamma irradiation in two types of Malaysian honey

Two types of monofloral Malaysian honey (Gelam and Nenas) were analyzed to determine their antioxidant activities and total phenolic and flavonoid contents, with and without gamma irradiation. Our results showed that both types of honey can scavenge free radicals and exhibit high antioxidant-reducing power; however, Gelam honey exhibited higher antioxidant activity (p < 0.05) than Nenas honey, which is in good correlation (r = 0.9899) with its phenolic contents. Interestingly, we also noted that both irradiated honeys have higher antioxidant activities and total phenolic and flavonoid contents compared to nonirradiated honeys by Folin-Ciocalteu and UV-spectrophotometry methods, respectively. However, HPLC analysis for phenolic compounds showed insignificant increase between irradiated and nonirradiated honeys. The phenolic compounds such as: caffeic acid, chlorogenic acid, ellagic acid, p- coumaric acid, quercetin and hesperetin as indicated by HPLC method were found to be higher in Gelam honey versus Nenas honey. In conclusion, irradiation of honey causes enhanced antioxidant activities and flavonoid compounds.     

Modification of proton conductive polymer membranes with phosphonated polysilsesquioxanes

New hybrid membranes for fuel cell applications based on sulfonated poly(ether ether ketone) (SPEEK) and phosphonated polysilsesquioxanes were synthesized. The impedance spectroscopy measurements show an increase of the proton conductivity for all studied composites, in comparison to plain SPEEK. For hybrid membranes containing 20 wt% of polysilsesquioxane with 80 mol% of phosphonated units the conductivities can reach values that are similar to Nafion 117^® at 100% RH. The best results of proton conductivity (142 mS/cm) were obtained for composites with 40 wt% of the same polysilsesquioxane at 120 °C also at 100% RH.