Chemical degradation of crosslinked ethylene-propylene-diene rubber in an acidic environment. Part II. Effect of peroxide crosslinking in the presence of a coagent

An investigation on the time-dependent chemical degradation of ethylene-propylene diene rubber containing 5-ethylidene-2-norbornene as diene cured by peroxide crosslinking in the presence of a coagent in an acidic environment (20% Cr/H₂SO₄) has been made. Two types of rubber, with comparable monomer composition, but having significant differences in molar mass and levels of long chain branching were tested. Dicumyl peroxide and triallylcyanurate under similar conditions were used for curing the rubbers. The molecular mechanisms of chemical degradation at the surface were studied using X-ray photoelectron spectroscopy and attenuated total reflectance Fourier transform infrared spectroscopy, which demonstrate that several oxygenated species evolve during exposure. The primary process of degradation is hydrolytic attack on the crosslink sites, which is manifested by a decrease in crosslink density. The surface degradation is found to be strong enough to alter the bulk mechanical properties as observed by the change in retention in tensile strength, elongation at break, modulus at 50% elongation and, the change in micro-hardness. Retention in modulus at 50% elongation is found to follow a negative linear correlation with decrease in crosslink density. With higher molar mass and level of long chain branching more crosslinking occurs and thus comparatively more hydrolytic attack ensues. Scanning electron microscopy shows that the surface topography is significantly altered upon exposure and supports the notion of the dependence of degradation on the crosslinking density of the samples. Importantly, the coagent used in this study is shown to enhance the chemical degradation through formation of weaker sites for hydrolysis. The results also show that upon prolonged exposure the resulting oxygenated species tend to combine with each other.     

Effect of the composition of lecithin/n-propanol/isopropyl myristate/water microemulsions on barrier properties of mice skin for transdermal permeation of tetracaine hydrochloride: in vitro

Effect of composition of lecithin water-in-oil and oil-in-water microemulsion on in vitro transdermal permeation of tetracaine hydrochloride was studied on mice model. The results were compared with an aqueous solution of tetracaine hydrochloride (2.7 mg/ml). In vitro skin flux and permeability coefficients were obtained using the Franz diffusion cell. Differential scanning calorimetry (DSC), transmission electron microscopy (TEM) and confocal laser scanning microscopy (CLSM) were used to study the mechanism of action of the microemulsion. Micrographs of TEM and CLSM studies were analyzed by using Image Pro Plus image software. Skin flux of tetracaine hydrochloride was found to be dependent on the composition of lecithin/n-propanol/isopropyl myristate/water microemulsions. At lower Km ratio (i.e. 0.5:1 and 0.8:1) of microemulsion, the rate of permeation of tetracaine hydrochloride was higher when compared to the microemulsion of higher Km ratio (1:1 and 1.5:1). Image analysis of TEM micrograph, 6h after application of lecithin microemulsion, showed 3.5+/-0.75-fold (p<0.001) increase in the intercellular space in the epidermis and 3.8+/-0.4-fold (p<0.001) enhancement in upper dermis. CLMS results show that sweat gland and hair follicles also provided path for permeation of the drug through the skin.     

Theoretical study of the electronic nonadiabatic transitions in the photoelectron spectroscopy of F2O

The photoelectron spectrum of F2O pertaining to ionizations to the ground (X2B1) and low-lying excited electronic states (A2B2, B2A1, and C2A2) of F2O+ is investigated theoretically. The near equilibrium potential energy surfaces of the ground electronic state (X2B1) of F2O and the mentioned ground and excited electronic states of F2O+ reported by Wang et al. ( J. Chem. Phys. 2001, 114, 10682) for the C2v configuration are extended for the Cs geometry assuming a harmonic vibration along the asymmetric stretching mode. The vibronic interactions between the A2B2 and B2A1 electronic states of F2O+ are treated within a linear coupling approach, and the strength of the vibronic coupling parameter is calculated by an ab initio method. The nuclear dynamics is simulated by both time-independent quantum mechanical and time-dependent wave packet approaches. Although the first photoelectron band exhibits resolved vibrational progression along the symmetric stretching mode, the second one is highly overlapping. The latter is attributed to the nonadiabatic interactions among the energetically close A2B2, B2A1, and C2A2 electronic states of F2O+. The theoretical findings are in good accord with the available experimental results.     

Separation of samarium and neodymium: a prerequisite for getting signals from nuclear synthesis

(146)Sm (T(1/2) = 10(8) y) is a long-lived radionuclide which has been produced in significant amounts during burning in a supernova (SN). Detection of this SN produced long-lived radionuclide on Earth may be helpful for getting information on nuclear synthesis at the time of our solar system's formation. Only accelerator mass spectrometry (AMS) can determine such minute traces of (146)Sm still expected in the Earth's crust. However, the villain of (146)Sm measurement through AMS is its naturally occurring stable isobar (146)Nd which is a million times more abundant than the trace amount of (146)Sm. Therefore an efficient method for the separation of samarium and neodymium is required to measure (146)Sm through AMS. A simple liquid-liquid extraction (LLX) based method for separation of samarium and neodymium has been developed using radiometric simulation. Di-(2-ethylhexyl)phosphoric acid (HDEHP) has been used as the organic reagent. A very high separation factor ( approximately 10(6)) can be achieved when a solution containing samarium and neodymium is reduced by hydroxylamine hydrochloride followed by extraction with 0.1% HDEHP diluted in cyclohexane from 0.025 M HCl solution.     

Photochemistry of pyrrole: time-dependent quantum wave-packet description of the dynamics at the 1pi sigma*-S0 conical intersections

The photoinduced hydrogen-elimination reaction in pyrrole via the conical intersections of the two (1)pi sigma(*) excited states with the electronic ground states [(1)B(1)(pi sigma(*))-S(0) and (1)A(2)(pi sigma(*))-S(0)] have been investigated by time-dependent quantum wave-packet calculations. Model potential-energy surfaces of reduced dimensionality have been constructed on the basis of accurate multireference ab initio electronic-structure calculations. For the (1)B(1)-S(0) conical intersection, the model includes the NH stretching coordinate as the tuning mode and the hydrogen out-of-plane bending coordinate as the coupling mode. For the (1)A(2)-S(0) conical intersection, the NH stretching coordinate and the screwing coordinate of the ring hydrogens are taken into account. The latter is the dominant coupling mode of this conical intersection. The electronic population-transfer processes at the conical intersections, the branching ratio between the dissociation channels, and their dependence on the initial preparation of the system have been investigated for pyrrole and deuterated pyrrole. It is shown that the excitation of the NH stretching mode strongly enhances the reaction rate, while the excitation of the coupling mode influences the branching ratio of different dissociation channels. The results suggest that laser control of the photodissociation of pyrrole via mode-specific vibrational excitation should be possible. The calculations provide insight into the microscopic details of ultrafast internal-conversion processes in pyrrole via hydrogen-detachment processes, which are aborted at the (1)pi sigma(*)-S(0) conical intersections. These mechanisms are of relevance for the photostability of the building blocks of life (e.g., the DNA bases).     

Synthesis and properties of fluorinated polyimides. 1. Derived from novel 4,4″‐bis(aminophenoxy)‐3,3″‐trifluoromethyl terphenyl

A new diamine monomer, 4,4″‐bis(aminophenoxy)‐3,3″‐trifluoromethyl terphenyl (ATFT) was synthesized that led to a number of novel fluorinated polyimides by solution as well as thermal imidization routes when reacted with different commercially available dianhydrides like pyromellatic dianhydride (PMDA), benzophenone tetracarboxylic acid dianhydride (BTDA), or 2,2‐bis(3,4‐dicarboxyphenyl) hexafluoropropane (6FDA). The polyimides ATFT/BTDA and ATFT/6FDA derived from both routes were soluble in several organic solvents such as N,N‐dimethylformamide, N,N‐dimethylacetamide, and dimethyl sulfoxide. The polyimide ATFT/PMDA was only soluble in N‐methylpyrollidone. The polyimide films had low water absorption of 0.3–0.7%, low dielectric constants of 2.72–3.3 at 1 Hz, refractive indices of 1.594–1.647 at 589.3 nm, and optical transparency >85%. These polyimides showed very high thermal stability with decomposition temperatures (5% weight loss) up to 532 °C in air and good isothermal stability; only 7% weight loss occurred at 400 °C after 7 h, and less than 0.6% weight loss was observed at 315 °C for 5 h. Transparent thin films of these polyimides exhibited tensile strengths up to 112 MPa, a modulus of elasticity up to 3.05 GPa, and elongation at break up to 21% depending on the repeating unit structure. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 1016–1027, 2002     

A 1D Cu(II) coordination polymer exhibiting ferromagnetic interactions and a mononuclear Cu(II) complex of substituted pyrazole carboxylic acids: Synthesis, characterization and crystal structure

Reaction of 2 equiv. amount of copper(II) nitrate hexahydrate with 1 equiv. of 5-methyl-1-pyridin-2-yl-1H-pyrazole-3-carboxylic acid (PyPzCA) in presence of triethyl amine base afforded a 1D coordination polymeric compound [Cu₂(PyPzCA)₂(H₂O)₃(NO₃)]NO₃·H₂O (1). Whereas, the same reaction when repeated with 1-(4,6-dimethyl-pyrimidin-2-yl)-5-methyl-1H-pyrazole-3-carboxylic acid (PymPzCA) instead of PyPzCA, a mononuclear compound [Cu(PymPzCA)]·2H₂O·NEt₃ (2) is formed. Both the complexes are crystallographically characterized. In 1, both the copper atoms (Cu1 and Cu2) have distorted square pyramidal geometry with N₂O₃ chromophore while, in 2, the central copper atom has a distorted trigonal bipyramidal geometry with N₄O chromophore. Complex 1, is a 1D coordination polymer where the metal centers being far apart and are involved in a weak ferromagnetic interaction which is quite unexpected.     

A novel method for monitoring chemical degradation of crosslinked rubber by stress relaxation under tension

This paper describes a novel test method for monitoring chemical degradation of a crosslinked rubber by stress relaxation under tension. An accelerated sulphur cured ethylene propylene diene rubber (EPDM) was subjected to stress relaxation under tension while exposing to 50% aqueous solution of nitric acid (HNO₃). An experimental set up was designed and built in-house for this purpose. The tensile test specimen was stretched to a constant elongation. The stress decay was monitored upon exposure to the harsh chemical. Stress decay was found much faster in the exposure media than in air. Decrosslinking was the main reason for quicker stress decay as observed by decrease in crosslink density. To compare, experiments were conducted by exposing similar specimens in the same exposure media under unstressed conditions. It was found that monitoring chemical degradation under given stressed condition yielded relatively quicker yet reliable and reproducible results.     

Liquid-liquid extraction of 99Mo and 187W with trioctylamine

Molybdenum and tungsten can be separated from each other by extraction with trioctylamine in hydrochloric acid medium.