Phase Behavior of Bicontinuous and Water/Diesel Fuel Microemulsions Using Nonionic Surfactants Combined with Hydrophilic Alcohol Ethoxylates

Bicontinuous and water-in-diesel microemulsions were formulated using single nonionic alkyl poly glycol ethers combined with hydrophilic alcohol ethoxylates. The phase behavior at temperatures ranging from 0°C to 50°C was investigated. Visual inspection as well as cross-polarizers were used to detect anisotropy. The fish phase diagrams were determined. The presence of the hydrophilic alcohol ethoxylates was necessary to initiate both types of microemulsions. Increasing the hydrophobic chain length of the surfactant led to a wider range of temperature stability at lower surfactant concentration. Meanwhile, increasing the ethylene oxide units in the headgroup by two units led to a phase diagram that is dominated by lyotropic liquid crystal. The formulated water in diesel microemulsions were tested experimentally in a 4-cylinder diesel engine. From this it is observed that the emissions of NO_x, soot, and CO₂ were reduced substantially compared to neat diesel, while for the CO the reduction occurs just at low load.      

FORMATION OF MICROEMULSION AND LIQUID CRYSTAL IN BIOCOMPATIBLE SUCROSE ALKANOATE SYSTEMS

Sucrose monoalkanoates (SE) form microemulsions by mixing with lipophilic cosurfactants such as the middle-chain alcohols, or sucrose polyalkanoates. In the case that sucrose monododecanoate is combined with hexanol, a middle-phase microemulsion is produced and coexists with excess water and oil phases at optimum mixing fraction of SE and hexanol. The bicontinuous structure of the microemulsion was confirmed by means of self-diffusion coefficient on NMR measurement.

A larger solubilization capability of oil is attained to a mixed mono- and poly-dodecanoate system than that of the middle-chain alcohol. It is probably due to the location of most of surfactant molecules at the micro-interface inside the microemulsion. In this system, instead of forming a three-phase region, a lamellar liquid crystal intrudes into multi-phase region since the surfactant layer is rather rigid as which was supported by the results of SAXS and ESR measurements. Further addition of a short-chain alcohol such as propanol to the mixed system leads to the flexible interface, as a consequence three-phase microemulsion with large solubilization is formed.     

Synthesis Of Isomaltose Analogues

ABSTRACT

Preparation of the α-glucosides 11, 12, 13 and 14 were accomplished through glycosylation of racemic trans-1-hydroxy-2-(hydroxymethyl)cyclohexane using 2-thiopyridyl tetra-O-benzyl-glucoside as the glycosyl donor in acceptable overall yield for α-selectivity, but with poor regioselectivity. Glycosylation under thermodynamic control using tetrabenzyl glucopyranose acetate and trimethylsilyl triflate as the promotor gave similar results. The unprotected glucosides 12 and 13 were separated and characterized by NMR spectroscopy. Similarly methyl 4-deoxy-α-isomaltoside (5a) was prepared through halide catalyzed glycosylation of methyl 2,3-di-O-benzoyl-4-deoxy-α-D-glucopyranoside (15) in acceptable yield and the unprotected compound characterized by NMR spectroscopy. Compounds 5a, 12a, 13a and the mixture 11a and 14a were all tested as substrates for the enzyme glucoamylase from Aspergillus niger and proved to be very poor substrates for the enzymic hydrolysis.     

Aggregation Effects in Visible‐Light Flavin Photocatalysts: Synthesis,Structure, and Catalytic Activity of 10‐Arylflavins

A series of 10‐arylflavins (10‐phenyl‐, 10‐(2′,6′‐dimethylphenyl)‐, 10‐(2′,6′‐diethylphenyl)‐, 10‐(2′,6′‐diisopropylphenyl)‐, 10‐(2′‐tert‐butylphenyl)‐, and 10‐(2′,6′‐dimethylphenyl)‐3‐methylisoalloxazine ( 2 a – f )) was prepared as potentially nonaggregating flavin photocatalysts. The investigation of their structures in the crystalline phase combined with ¹H‐DOSY NMR spectroscopic experiments in CD₃CN, CD₃CN/D₂O (1:1), and D₂O confirm the decreased ability of 10‐arylflavins 2 to form aggregates relative to tetra‐O‐acetyl riboflavin ( 1 ). 10‐Arylflavins 2 a – d do not interact by π–π interactions, which are restricted by the 10‐phenyl ring oriented perpendicularly to the isoalloxazine skeleton. On the other hand, N3? H???O hydrogen bonds were detected in their crystal structures. In the structure of 10‐aryl‐3‐methylflavin ( 2 f ) with a substituted N3 position, weak C? H???O bonds and weak π–π interactions were found. 10‐Arylflavins 2 were tested as photoredox catalysts for the aerial oxidation of 4‐methoxybenzyl alcohol to the corresponding aldehyde (model reaction), thus showing higher efficiency relative to 1 . The quantum yields of 4‐methoxybenzyl alcohol oxidation reactions mediated by arylflavins 2 were higher by almost one order of magnitude relative to values in the presence of 1 .     

Detection of potentially skin sensitizing hydroperoxides of linalool in fragranced products

On prolonged exposure to air, linalool can form sensitizing hydroperoxides. Positive hydroperoxide patch tests in dermatitis patients have frequently been reported, but their relevance has not been established. Owing to a lack of analytical methods and data, it is unclear from which sources the public might be exposed to sufficient quantities of hydroperoxides for induction of sensitization to occur. To address this knowledge gap, we developed analytical methods and performed stability studies for fine fragrances and deodorants/antiperspirants. In parallel, products recalled from consumers were analysed to investigate exposure to products used in everyday life. Liquid chromatography–mass spectrometry with high mass resolution was found to be optimal for the selective and sensitive detection of the organic hydroperoxide in the complex product matrix. Linalool hydroperoxide was detected in natural linalool, but the amount was not elevated by storage in a perfume formulation exposed to air. No indication of hydroperoxide formation in fine fragrances was found in stability studies. Aged fine fragrances recalled from consumers contained a geometric mean linalool concentration of 1,888 μg/g and, corrected for matrix effects, linalool hydroperoxide at a concentration of around 14 μg/g. In antiperspirants, we detected no oxidation products. In conclusion, very low levels of linalool hydroperoxide in fragranced products may originate from raw materials, but we found no evidence for oxidation during storage of products. The levels detected are orders of magnitude below the levels inducing sensitization in experimental animals, and these results therefore do not substantiate a causal link between potential hydroperoxide formation in cosmetics and positive results of patch tests. Graphical Abstract

Formation of hydroperoxides from linalool and detection by LC-MS with high resolution     

Adamantyl Side Chains as Anti-Aggregating Moieties in Dyes for Dye-Sensitized Solar Cells

Designing and evaluating novel dye concepts is crucial for the development of the field of dye-sensitized solar cells (DSSCs). In our recent report, the novel concept of tethering the anti-aggregation additive chenodeoxycholic acid (CDCA) to dyes for DSSC was introduced. Based on the performance improvements seen for this modification, the aim of this study is to see if a simplified anti-aggregation unit could achieve similar results. The following study reports the synthesis and photovoltaic characterization of two novel dyes decorated with the steric ethyladamantyl moiety on the π-spacer, and on the triarylamine donor. This modification is demonstrated to be successful in increasing the photovoltages in devices employing copper-based electrolytes compared to the non-modified reference dye. The best photovoltaic performance is achieved by a device prepared with the adamantyl decorated donor dye and CDCA, this device achieves a power conversion efficiency of 6.1 % (Short-circuit current=8.3 mA cm⁻², Open-circuit voltage=1054 mV, Fill factor=0.69). The improved photovoltaic performance seen for the adamantyl decorated donor demonstrate the potential of ethyladamantyl side chains as a tool to ensure surface protection of TiO₂.     

Spatial and temporal resolution effects on dynamic contrast-enhanced magnetic resonance mammography

We tested the hypothesis that partial volume effects due to poor in-plane resolution and/or low temporal resolution used in clinical dynamic contrast-enhanced magnetic resonance imaging results in erroneous diagnostic information based on inaccurate estimates of tumor contrast agent extravasation and tested whether reduced encoding techniques can correct for dynamic data volume averaging. Image spatial resolution was reduced from 469 x 469 microm2 to those reported below by selecting a subset of k-space data. We then compared the top five K(trans)/V(T) "hot spots" obtained from the original data set, 469 x 469-microm in-plane spatial resolution and an 18-s temporal resolution processed by fast Fourier transform (FFT), with values obtained from data sets having in-plane spatial resolutions of 938 x 938, 1875 x 1875 and 2500 x 2500 microm2 and a temporal resolution of 18 s, or data sets with temporal resolutions of 36, 54 and 72 and a spatial resolution of 469 x 469 microm2, and found them to statistically differ from the parent data sets. We then tested four different post processing methods for improving the spatial resolution without sacrificing temporal resolution: zero-filled FFT, keyhole, reduced-encoding imaging by generalized-series reconstruction (RIGR) and two-reference RIGR (TRIGR). The top five values of K(trans)/V(T) obtained from data sets, the in-plane spatial resolutions of which were improved to 469 x 469 microm2 by zero-filling FFT, Keyhole and RIGR, statistically differed from those obtained from the original 469 x 469 microm2 FFT parent image data set. Only the 938 x 938 and 1875 x 1875 microm2 data sets reconstructed to 469 x 469 microm2 with TRIGR reconstruction method yielded values of the top five K(trans)/V(T) hot spots statistically the same as the original parent data set, 469 x 469 microm2 in-plane spatial and 18-s temporal-resolution FFT. That is, partial volume effects from data sets of different in-plane spatial resolution resulted in statistically different values of the top five K(trans)/V(T) hot spots relative to a high spatial and temporal resolution data set, and TRIGR reconstruction of these low resolution data sets to high resolution images provided statistically similar values with a savings in temporal resolution of 2 to 4 times.