Recoil energy distributions for dissociation of the van der Waals molecule p-difluorobenzene-Ar with 450-3000 cm(-1) excess energy

Velocity map imaging has been used to measure the distributions of translational energy released in the dissociation of p-difluorobenzene-Ar van der Waals complexes from the 5(1), 3(1), 5(2), 3(1)5(1), 5(3), 3(2), and 3(2)5(1) states. These states span 818-3317 cm(-1) of vibrational energy and correspond to a range of energies above dissociation of 451-2950 cm(-1). The translational energy release (recoil energy) distributions are remarkably similar, peaking at very low energy (10-20 cm(-1)) and decaying in an exponential fashion to approach zero near 300 cm(-1). The average translational energy released is small, shows no dependence on the initial vibrational energy, and spans the range 58-72 cm(-1) for the vibrational levels probed. The average value for the seven levels studied is 63 cm(-1). The low fraction of transfer to translation is qualitatively in accord with Ewing's momentum gap model [G. E. Ewing, Faraday Discuss. 73, 325 (1982)]. No evidence is found in the distributions for a high energy tail, although it is likely that the experiment is not sufficiently sensitive to detect a low fraction of transfer at high translational energies. The average translational energy released is lower than has been seen in comparable systems dissociating from triplet and cation states.     

Tracelessness Unmasked: A General Linker Nomenclature

Nowadays it is rare to find an issue of a major chemistry journal without at least one article on solid-phase synthesis. This is hardly surprising: the technique promises an end to arduous work-up procedures and the ability to facilitate the creation of vast libraries of compounds using combinatorial techniques. No longer is the technique only of interest to those involved in peptide synthesis: an enormous variety of product classes have now been prepared on and isolated from the solid phase. It is the "linker" which is the focus of this article. The linker's ultimate function is to release a product from the support into solution: it does this, without exception, with a chemical change to the product at the former linkage site. Some linkers, apparently, are "traceless". But what, in fact, is "tracelessness"? Twenty years ago, in a climate where cleavage of a linker resulted in formation of a polar carboxylic acid as the vestige of the support, the concept was attractive. Today the chemist is faced with a myriad of novel linkers which have the ability to release products bearing most major functionalities at the former linkage site and we will argue here that the term "traceless", although currently in widespread use, is meaningless. Instead, we propose a new categorization of linkers based on the functionality they release upon cleavage, and suggest a nomenclature to underpin this categorization. We anticipate that the article will also serve to highlight areas of linker technology in need of further research.     

A note on the numerical evaluation of finite integrals of oscillatory functions

A method is described for the numerical evaluation of integrals of the form ∫ _?1 ¹ f(x)K(m,x)dx, wheref(x) is smooth in [?1,1], whileK(m,x) is highly oscillatory for large values ofm.     

Wind-generated ambient noise in a topographically isolated basin: a pre-industrial era proxy

During the mid-1980s, calibrated measurements of ambient noise and wind speed were made in the Tongue of the Ocean in the Bahamas to quantify the spectra and statistics of wind-generated noise. This deep basin is topographically isolated from the Atlantic Ocean and, therefore, largely acoustically decoupled from the Atlantic Ocean deep sound channel. The quantitative effects of contaminating (non-surface wind-generated) noise sources within the basin were eliminated by careful measurement and robust statistical analysis methodologies. Above 500 Hz, the spectral slopes are approximately -5 dB per octave and independent of wind speed. Below 500 Hz, the ambient noise is no longer a linear function of wind speed. Below 100 Hz and for wind speeds greater than 18.5 knots (kt), the ambient noise is independent of frequency. The minimum observed ambient noise level falls 13 dB below Urick's "light shipping" level at 30 Hz and 2-5 dB below Wenz's sea state zero level through the wind-dominated portion of the spectrum. The basin's geographical isolation and the rigorous measurement and analysis methodologies employed make this two-decade-old data set a reasonable and justified proxy for pre-industrial era ocean noise levels in the 20 Hz to 20 kHz frequency band.     

Nitrilotriacetamide: Synthesis in Concentrated Sulfuric Acid and Stability in Water

Acid hydrolysis of N(CH₂CN)₃ leads either nitrilotriacetamide, 1, and/or 3,5-dioxopiperazineacetamide, 4, in quantitative yield. 1 slowly and cleanly converts to 3,5-dioxopiperazineacetic acid, 5, in water, although ammonium salts prevent this reaction.     

Hölder Continuity of Solutions to the Kinematic Dynamo Equations

We study the propagation of regularity of solutions to a three dimensional system of linear parabolic PDE known as the kinematic dynamo equations. The divergence free drift velocity is assumed to be at the critical regularity level with respect to the natural scaling of the equations.     

Copper activation of boronic acids: factors affecting reactivity

The generation of nucleophiles from the combination of aryl boronic acids and catalytic amounts of copper salt allows a reactivity distinct from other organometallic species, such as organolithiums or Grignard reagents. Here we examine how the electronic and steric properties of the boronic acid affect the formation of active nucleophiles and their subsequent reactivity with iminium‐type compounds, showing that electron‐rich substrates display reduced reactivity. Copyright © 2014 John Wiley & Sons, Ltd.