A family of maximal surfaces in Lorentz-Minkowski three-space

We prove the existence of an infinite family of complete spacelike maximal surfaces with singularities in Lorentz-Minkowski three-space and study their properties. These surfaces are distinguished by their number of handles and have two elliptic catenoidal ends.

     

Surface free energy of CrNx films deposited using closed field unbalanced magnetron sputtering

CrN_x thin films have attracted much attention for semiconductor IC packaging molding dies and forming tools due to their excellent hardness, thermal stability and non-sticking properties (low surface free energy). However, few data has been published on the surface free energy (SFE) of CrN_x films at temperatures in the range 20-170 °C. In this study CrN_x thin films with CrN, Cr(N), Cr₂N (and mixture of these phases) were prepared using closed field unbalanced magnetron sputtering at a wide range of Cr⁺² emission intensity. The contact angles of water, di-iodomethane and ethylene glycol on the coated surfaces were measured at temperatures in the range 20-170 °C using a Dataphysics OCA-20 contact angle analyzer. The surface free energy of the CrN_x films and their components (e.g., dispersion, polar) were calculated using the Owens-Wendt geometric mean approach. The influences of CrN_x film surface roughness and microstructure on the surface free energy were investigated by atomic force microscopy (AFM) and X-ray diffraction (XRD), respectively. The experimental results showed that the lowest total SFE was obtained corresponding to CrN at temperature in 20 °C. This is lower than that of Cr(N), Cr₂N (and mixture of these phases). The total SFE, dispersive SFE and polar SFE of CrN_x films decreased with increasing surface temperature. The film roughness has an obvious effect on the SFE and there is tendency for the SFE to increase with increasing film surface roughness.     

Stowage planning in maritime container transportation

We consider a stowage-planning problem of arranging containers on a container ship in the maritime transportation system. Since containers are accessible only from the top of the stack, temporary unloading and reloading of containers, called shifting, is unavoidable if a container required to be unloaded at the current port is stacked under containers to be unloaded at later ports on the route of the ship. The objective of the stowage planning problem is to minimize the time required for shifting and crane movements on a tour of a container ship while maintaining the stability of the ship. For the problem, we develop a heuristic solution method in which the problem is divided into two subproblems, one for assigning container groups into the holds and one for determining a loading pattern of containers assigned to each hold. The former subproblem is solved by a greedy heuristic based on the transportation simplex method, while the latter is solved by a tree search method. These two subproblems are solved iteratively using information obtained from solutions of each other. To see the performance of the suggested algorithm, computational tests are performed on problem instances generated based on information obtained from an ocean container liner. Results show that the suggested algorithm works better than existing algorithms.     

偶氮苯衍生物三阶非线性的四波混频研究

用皮秒Ｎｄ：ＹＡＧ激光器的倍频光（５３２ｎｍ）对具有离域π－共轭电子云结构的偶氮苯类样品材料作简并四波混频补给，测得三阶非线性电极化率ｘ＾（３）和它们的时间响应分别为１０＾－９ｅｓｕ和２０ｐｓ，并对影响ｘ＾（３）的瞬时光栅作用和ｘ＾（３）的响应时间人了讨论。     

On CCE graphs of doubly partial orders

Let D be a digraph. The competition-common enemy graph (CCE graph) of D has the same set of vertices as D and an edge between vertices u and v if and only if there are vertices w and x in D such that (w,u), (w,v), (u,x), and (v,x) are arcs of D. We call a graph a CCE graph if it is the CCE graph of some digraph. In this paper, we show that if the CCE graph of a doubly partial order does not contain C₄ as an induced subgraph, it is an interval graph. We also show that any interval graph together with enough isolated vertices is the CCE graph of some doubly partial order.     

Polynomial decay rate for the dissipative wave equation

Using Fourier integral operators with special amplitude functions, we analyze the stabilization of the wave equation in a three-dimensional bounded domain on which exists a trapped ray bouncing up and down infinitely between two parallel parts of the boundary.     

Influence of Cr interlayer on the structure and optical properties of Ag films on glass substrate by magnetron sputtering

Optical properties and microstructure of Ag film on glass substrate with Cr intermediate layer were studied by using spectrophotometer and XRD. The spectra results showed that introducing Cr intermediate layer reduced the surface roughness and promoted the reflectivity of Ag film. The XRD analysis showed that the crystalline grains increased and the stress decreased. The adhesion was also improved by using the tape test method.     

Preparing polymer brushes on polytetrafluoroethylene films by free radical polymerization

Films of polytetrafluoroethylene (PTFE) were exposed to sodium naphthalenide (Na/naphtha) etchant so as to defluorinate the surface for obtaining hydroxyl functionality. Surface-initiators were immobilized on the PTFE films by esterification of 4,4′-azobis(4-cyanopentanoic acid) (ACP) and the hydroxyl groups covalently linked to the surface. Grafting of polymer brushes on the PTFE films was carried out by the surface-initiated free radical polymerization. Homopolymers brushes of methyl methacrylate (MMA) were prepared by free radical polymerization from the azo-functionalized PTFE surface. The chemical composition and topography of the graft-functionalized PTFE surfaces were characterized by X-ray photoelectron spectroscopy (XPS), attenuated total reflectance (ATR) FT-IR spectroscopy and atomic force microscopy (AFM). Water contact angles on PTFE films were reduced by surface grafting of MMA.     

The magnetic properties of Be-codoped GaMnN grown via molecular beam epitaxy

GaMnN and Be-codoped GaMnN were grown via molecular beam epitaxy using a single GaN precursor and their structural and magnetic properties were examined. X-ray diffraction and superconducting quantum interference device (SQUID) measurements revealed that the grown layers are homogeneous without precipitates. The saturation magnetization of GaMnN has increased from ∼4 to ∼16 emu/cm³ via codoping of Be. The d–d exchange interaction between Mn atoms was discussed for the ferromagnetism of GaMnN.     

Oil Migration in Chocolate

Oil migration in filled chocolates limits shelf life due to texture changes and loss of visual appeal. Spatial and temporal oil concentration changes of a two-layer chocolate and peanut butter filling system, which models a filled chocolate, were monitored by magnetic resonance imaging. Formulations of chocolate varied with respect to particle size, milk fat content and emulsifier level. Sorption-time experimental data was used to establish the best fit diffusion coefficient for a Fickian diffusion model. On the basis of the comparison of spatial experimental data to the model, Fickian diffusion alone does not account for oil migration. Authors' address: Michael J. McCarthy, Department of Food Science and Technology, University of California, One Shields Avenue, Davis, CA 95616, USA