Improvement of performance of tetraphenylporphyrin-based red organic light emitting diodes using WO3 and C60 buffer layers

One of the porphyrin derivatives, meso-tetraphenylporphyrin (TPP), has been synthesized and examined as an emitter material (EM) for efficient fluorescent red organic light-emitting diodes (OLEDs). By inserting a tungsten oxide (WO₃) layer into the interface of anode (ITO) and hole transport layer N,N′-Di-[(1-napthyl)-N,N′-diphenyl]-(1,1′-biphenyl)-4,4′-diamine (NPB) and by using fullerene (C₆₀) in contact with a LiF/Al cathode, the performance of devices was markedly improved. The current density–voltage–luminance (J–V–L) characterizations of the samples show that red OLEDs with both WO₃ and C₆₀ as buffer layers have a lower driving voltage and higher luminance compared with the devices without buffer layers. The red OLED with the configuration ITO/WO₃ (3 nm)/NPB (50 nm)/TPP (60 nm)/BPhen (30 nm)/C₆₀ (5 nm)/LiF (0.8 nm)/Al (100 nm) achieved the high luminance of 6359 cd/m² at the low driving voltage of 8 V. At a current density of 20 mA/cm², a pure red emission with CIE coordinates of (0.65; 0.35) is observed for this device. Moreover, a power efficiency of 2.07 lm/W and a current efficiency of 5.17 cd/A at 20 mA/cm² were obtained for the fabricated devices. The study of the energy level diagram of the devices revealed that the improvement in performance of the devices with buffer layers could be attributed to lowering of carrier-injecting barrier and more balanced charge injection and transport properties.     

On necessary and sufficient conditions for near-optimal singular stochastic controls

In this paper we discuss the necessary and sufficient conditions for near-optimal singular stochastic controls for the systems driven by a nonlinear stochastic differential equations (SDEs in short). The proof of our result is based on Ekeland’s variational principle and some delicate estimates of the state and adjoint processes. It is well known that optimal singular controls may fail to exist even in simple cases. This justifies the use of near-optimal singular controls, which exist under minimal conditions and are sufficient in most practical cases. Moreover, since there are many near-optimal singular controls, it is possible to choose suitable ones, that are convenient for implementation. This result is a generalization of Zhou’s stochastic maximum principle for near-optimality to singular control problem.     

New constraints on the pion EM form factor using $ \Pi^{{ \prime}}_{}$(- Q2)

We study the constraints arising on the expansion parameters c and d of the pion electromagnetic form factor from the inclusion of pure spacelike data and the phase of timelike data along with one spacelike datum, using as input the first derivative of the QCD polarization amplitude (- Q ²) . These constraints when combined with other analyses, provide a valuable check on a determination of c due to Guo et al. and on our previous work where pionic contribution to the (g - 2) of the muon was used as the input. This work further illustrates the power of analyticity techniques in form factor analysis.     

Iterative approximation of fixed points of Prešić operators on partial metric spaces

We study the convergence of the Pre?i? type k‐step iterative method for a class of operators satisfying Pre?i? type contractive conditions on the setting of partial metric spaces. Some examples are presented to illustrate our obtained results. As applications of the presented convergence theorems, we derive global attractivity results for a class of matrix difference equations. Numerical experiments are also presented to illustrate the theoretical findings.     

Finite element analysis of hydromagnetic flow and heat transfer of a heat generation fluid over a surface embedded in a non-Darcian porous medium in the presence of chemical reaction

An analysis is carried out to study the flow, chemical reaction and mass transfer of a steady laminar boundary layer of an electrically conducting and heat generating fluid driven by a continuously moving porous surface embedded in a non-Darcian porous medium in the presence of a transfer magnetic field. The governing partial differential equations are converted into ordinary differential equations by similarity transformation and are solved numerically by using the finite element method. The results obtained are presented graphically for velocity, temperature and concentration profiles, as well as the Sherwood number for various parameters entering into the problem.     

Response of thermal source in a transversely isotropic thermoelastic half-space with mass diffusion by finite element method

The two-dimensional problem of generalized thermoelastic diffusion material with thermal and diffusion relaxation times is investigated in the context of Lord-Shulman theory. As an application of the problem, a particular type of thermal source is considered and the problem is solved numerically by using a finite element method. The components of displacement, stress, temperature distribution, chemical potential, and mass concentration are obtained. The resulting quantities are depicted graphically for a special model. Appreciable effect of relaxation times is observed on various resulting quantities.     

Synthesis,characterization of Schiff base metal complexes and their biological investigation

A new Schiff base ligand named (E)‐2‐(((3‐aminophenyl)imino)methyl)phenol (HL) was prepared through condensation reaction of m‐phenylenediamine and 2‐hydroxybenzaldehyde in 1:1 molar ratio. The new ligand was characterized by elemental analysis and spectral techniques. The coordination behavior of a series of transition metal ions named Cr (III), Mn (II), Fe (III), Co (II), Ni (II), Cu (II), Zn (II) and Cd (II) with the newly prepared Schiff base ligand (HL) is reported. The nature of bonding and the stereochemistry of the complexes have been deduced from elemental analyses, IR, UV–Vis, ¹H NMR, mass, electronic spectra, magnetic susceptibility and conductivity measurements and further their thermal stability was confirmed by thermogravimetric analysis (TG). From IR spectra, it was observed that the ligand is a neutral tridentate ligand coordinates to the metal ions through protonated phenolic oxygen, azomethine nitrogen and nitrogen atom of NH₂ group. The existence, the number and the position of the water molecules was studied by thermal analysis. The molecular structures of the Schiff base ligand (HL) and its metal complexes were optimized theoretically and the quantum chemical parameters were calculated. The synthesized ligand and its complexes were screened for antimicrobial activities against bacterial species (Staphylococcus aureus and Bacillis subtilis, (gram positive bacteria)), (Salmonella SP., Escherichia coli and Pseudomonas aeruginosa, (gram negative bacteria)) and fungi (Aspergillus fumigatus and Candida albicans). The complexes were found to possess high biological activities against different organisms. Molecular docking was used to predict the efficiency of binding between Schiff base ligand (HL) and both receptors of Escherichia coli (3 T88) and Staphylococcus aureus (3Q8U). The receptor of Escherichia coli (3 T88) showed best interaction with Schiff base ligand (HL) compared to receptor of Staphylococcus aureu (3Q8U).     

Chloro-Modified Magnetic Fe3O4@MCM-41 Core–Shell Nanoparticles for L-Asparaginase Immobilization with Improved Catalytic Activity,Reusability, and Storage Stability

This paper describes a new support that permits to efficient immobilization of L-asparaginase (L-ASNase). For this purpose, Fe₃O₄ magnetic nanoparticles were synthesized and coated by MCM-41. 3-chloropropyltrimethoxysilane (CPTMS) was used as a surface modifying agent for covalent immobilization of L-ASNase on the magnetic nanoparticles. The chemical structure; thermal, morphological, and magnetic properties; chemical composition; and zeta potential value of Fe₃O₄@MCM-41-Cl were characterized by Fourier transform infrared spectroscopy (FTIR), thermogravimetric analysis (TGA), differential thermal analysis (DTA), differential scanning calorimetry (DSC), vibrating sample magnetometer (VSM), scanning electron microscope (SEM), energy dispersive X-ray (EDX), X-ray diffraction patterns (XRD), and zeta-potential measurement. The immobilization efficiency onto Fe₃O₄@MCM-41-Cl was detected as 63%. The reusability, storage, pH, and thermal stabilities of the immobilized L-ASNase were investigated and compared to that of soluble one. The immobilized enzyme maintained 42.2% of its original activity after 18 cycles of reuse. Furthermore, it was more stable towards pH and temperature compared with soluble enzyme. The Michaelis–Menten kinetic properties of immobilized L-ASNase showed a lower V_max and a similar K_m compared to soluble L-ASNase. Immobilized enzyme had around 47 and 32.5% residual activity upon storage a period of 28 days at 4 and 25 °C, respectively. In conclusion, the Fe₃O₄@MCM-41-Cl@L-ASNase core–shell nanoparticles could successfully be used in industrial and medical applications.

     

Construction of Modified Carbon Paste Electrode for Highly Sensitive Simultaneous Electrochemical Determination of Trace Amounts of Copper (II) and Cadmium (II)

A chemically modified electrode was constructed for rapid, simple, accurate, selective and highly sensitive simultaneous determination of Cu(II) and Cd(II) using square wave anodic stripping voltammetry. The electrode was prepared by incorporation of SiO₂ nanoparticles, coated with a newly synthesized Schiff base, in carbon paste electrode. The limit of detection was found to be 0.28 ng mL^?1 and 0.54 ng mL^?1 for Cu(II) and Cd(II), respectively. The proposed chemically modified electrode was used for the determination of copper and cadmium in several foodstuffs and water samples.     

Synthesis and Cytotoxic Evaluation of Novel 1,2,3‐Triazole‐4‐Linked (2E,6E)‐2‐Benzylidene‐6‐(4‐nitrobenzylidene)cyclohexanones

This work describes the synthesis of novel 1,2,3‐triazole‐4‐linked (2E,6E)‐2‐benzylidene‐6‐(4‐nitrobenzylidene)cyclo‐hexanones starting from cyclohexanone. 1‐(Cyclohex‐1‐en‐1‐yl)piperidine, the enamine from cyclohexanone and piperidine, reacted with 4‐nitrobenzaldehyde to obtain 2‐(4‐nitrobenzylidene)cyclohexanone. Condensation of the latter compound with (prop‐2‐yn‐1‐yloxy)benzaldehyde derivatives under acidic conditions gave (4‐nitrobenzylidene)‐[(prop‐2‐yn‐1‐yloxy)‐benzylidene]cyclohexanones. Finally, ‘click reaction’ of these derivatives and various organic azides led to the title compounds. All compounds were examined by MTT assay for cytotoxic activity in one human breast cancer cell line, MDA‐MB‐231.