Effect of Electrical Pulse Forms on the CO2 Reforming of Methane Using Atmospheric Dielectric Barrier Discharge

Methane conversion using an electric discharge has been studied for many years. Recently, many research groups have developed high-frequency pulsed plasma reaction for methane conversion to higher hydrocarbons and synthesis gas. CO₂ reforming of methane to synthesis gas has also attracted considerable interest as a method of utilization of the greenhouse gases, CO₂ and CH₄, which occupy most of man-made greenhouse gases. In this study, the influence of pulse form of applied voltage on methane and carbon dioxide conversions and product selectivity has been investigated using a cylindrical type DBD reactor. For this purpose, two kinds of power supply were compared, that is, AC power supply which has a high-frequency sinusoidal wave form, and AC pulse power supply which has modified AC pulse wave form. The conversions of methane and carbon dioxide were enhanced using pulsed plasma. The lower pulse width was more profitable economically.     

Semiconducting organic polymer from polyacrylamide–Cu++ chelate and iodine

Semiconducting organic polymer was obtained by the modification of polyacrylamide (PAAm)–Cu⁺⁺ chelate with iodine in acetone. Favorable conditions for preparing the chelate effective for the conduction were investigated. Surface resistivities were affected by the amounts of cupric salts and iodine, satisfactory results being given by about 25 wt % of the salts based on PAAm and more than 1 wt % of iodine on the chelate. The conductivity was also varied with the degree of neutralization of the chelate in solution, and optimal values were obtained by addition of about an equimolar amount of potassium hydroxide to cupric salts. Effective structures of the polymer chelate in solution were assumed on the basis of the visible and the NMR spectra and potentiometric titration.     

DNA intercalating studies of [Ru(bpy)<Subscript>2</Subscript>HPIP]<Superscript>2+</Superscript> with intramolecular hydrogen bond ligand based on introduction of copper ion

The effects of copper ion on the interaction of [Ru(bpy)₂HPIP]²⁺(bpy = 2,2′-bipyridine, HPIP = 2-(2-hydroxyphenyl) imidazo [4,5-f] [1, 10] phenanthroline) with DNA have been investigated by electronic absorption spectroscopy and fluorescence spectroscopy. HPIP ligand of the complex with an intramolecular hydrogen bond can bind Cu²⁺ in the absence of DNA, as revealed by the absorbance and fluorescence decrease for [Ru(bpy)₂HPIP]²⁺. The resultant heterometallic complex binds to DNA via intercalation of HPIP into the DNA base pairs and its DNA-binding ability is stronger than [Ru(bpy)₂HPIP]²⁺ itself. The DNA bound [Ru(bpy)₂HPIP]²⁺ cannot bind Cu²⁺ at low Cu²⁺ concentration and the intramolecular hydrogen bond in HPIP is located inside the DNA helix. While the Cu²⁺ concentration is relative high, Cu²⁺ can quench the fluorescence of DNA bound [Ru(bpy)₂HPIP]²⁺. The quenching reason is proposed.     

聚电解质溶液中2.6-ANS探针的荧光谱研究

本文合成了2.6—ANS荧光探针分子,并在含有不同外加盐的NaPSS溶液中测定了探针的荧光发射光谱。结果表明:探针的荧光强度随Cs增大而增大,而探针光谱的最大发射波长和半波宽度随Cs增大而减小。当Cs达到一定值时,荧光谱参数与Cs关系曲线出现转折点,此时聚离了链以“类胶束”状态存在。     

基于企业微信平台和在线教育综合平台的线上教学实践

In order to achieve "postponement of school without suspension of learning" during the prevention and control of new coronavirus pneumonia, the online teaching strategy was constructed based on Enterprise WeChat and Integrated Online Education Platform for the online teaching of Separation Science and Technology. The student-centered teaching methods were applied in online teaching process.     

拓扑指数法研究显色剂结构与反应性能关系

本文讨论了２９个不对称色酸双偶氮膦酸型显色剂的分子联接性指数，并将其与结构选择性因子相结合，用于偶氮类剂结构与铈显色反应灵敏度的相关性研究，讨论了显色剂结构对显色反应灵敏度的影响。     

高碲酸合铜（Ⅱ,Ⅲ）配合物的合成和性质

在Ｈ６ＴｅＯ６／ＫＯＨ水溶液中以臭氧为氧化剂，将二价铜化合物氧化成三价铜化合物，并获得一个新的三价铜化合物Ｂａ４Ｋ［Ｃｕ（Ｈ２ＴｅＯ６）２］（ＯＨ）４．６Ｈ２Ｏ；描述了碱性溶液中“Ｃｕ（Ⅲ）／Ｃｕ（Ⅲ）”循环伏安图。对铜（Ⅲ）化合物，Ｎａ４Ｈ［Ｈ２ＴｅＯ６）２］．１７Ｈ２Ｏ以及相应的铜（Ⅱ）配合物的电子光谱和Ｃｕ２ｐＸＰＳ进行了研究，给出了其配位场场强参数和Ｃｕ２ＰＸＰＸ的电子结合能。由于价态升高     

Comparison of the thermal behavior of three cellulose fibers mercerized or submitted to solar degradation

Comparison of Lyocell, modal and viscose fibers was performed by means of differential scanning calorimetry, thermogravimetry and scanning electron microscopy. Thermal analysis was performed in air atmosphere. Samples were mercerized (21.3 g 100 mL-1) or submitted to solar radiation (seven months). Solar degraded samples presents a higher thermal stability and are initially less degraded. Furthermore, Lyocell fiber is the most stable under thermal degradation conditions. Heating produces a reduction of the fiber diameter (about 50%). This revised version was published online in July 2006 with corrections to the Cover Date.