用二维复式晶格有限集团模型计算聚乙炔的电子结构

以二维复式晶格作为有限系统的集团模型,在紧束缚近似下,计算了π电子在最近邻及次近邻跳跃集团的态密度.讨论了不同结构参数对态密度及带宽的影响.     

Poly[[diaqua(N,N‐dimethylformamide‐κO)manganese(II)]‐μ3‐sulfato]

In the title complex, [Mn(SO₄)(C₃H₇NO)(H₂O)₂]_n, each Mn^II ion has a distorted octahedral geometry formed by three O atoms of three different sulfate groups, one O atom of a dimethylformamide ligand and two water molecules. The sulfate groups act as tridentate bridging ligands connecting the Mn^II ions into a two‐dimensional layer structure which can be regraded as a 4.8² network.     

Studies on the chemical constituents of the South China Sea sponge Phacellia fusca

Three pyrrololactam alkaloids have been isolated from the marine sponge Phacellia fusca Schmidt collected from the South China Sea, and their structures were determined as 1–3 , on the grounds of spectral data. This is the first report of these compounds from this sponge. The structure of 1 was confirmed by X-ray analysis.     

Controllable synthesis of ZnS/PMMA nanocomposite hybrids generated from functionalized ZnS quantum dots nanocrystals

We reported controllable synthesis of ZnS nanocrystal-polymer transparent hybrids by using polymethylmethacrylate (PMMA) as a polymer matrix. In a typical run, the appropriate amounts of zinc chloride (ZnCl₂) and sodium sulfide (Na₂S) in the presence of 2-mercaptoethanol (ME) as the organic ligand were well dispersed in H₂O/dimethylformamide solution without any aggregation. In addition, the Mn-doped ZnS nanocrystals (NCs) were synthesized with similar method. Then, ZnS-PMMA hybrids were obtained via free radical polymerization in situ by using ZnS NCs functionalized with methacryloxypropyltrimethoxysilane (MPS). FT-IR characterization indicates the formation of robust bonding between ZnS NCs and the organic ligand. The TEM images show that ZnS NCs are well dispersed in PMMA matrix, and particle size of as-prepared ZnS NCs is about 2.6 nm, in agreement with the computing results of Brus’s model and Debye–Scherrer formula. The photoluminescence measurements present that ZnS NCs, Mn-doped ZnS NCs, and ZnS/PMMA hybrid show good optical properties.     

纯锆上离子注入钇和镧后的表面分析

用金属蒸汽真空弧源，以40kV加速电压对纯锆样品分别进行了10¹⁶—10¹⁷/cm²的钇、镧离子注入，注入温度约为130℃.然后对注入样品进行表面分析.x射线光电子能谱分析表明，注入的钇以Y₂O₃形式存在，镧以La₂O₃形式存在.俄歇电子能谱表明，纯锆基体表面的氧化膜厚度随着离子注入剂量的增加而增加，当离子注入剂量达到10¹⁷/cm²时，氧化膜的厚度达到了最大值.卢瑟福背散射显示镧层的厚度约为30nm，同时直接观察到当离子注入剂量为(La+Y)10¹⁷/cm²时，纯锆样品表面发生了严重的溅射. 关键词： 纯锆 钇和镧离子共注入 卢瑟福背散射 x射线光电子能谱     

中立型时滞差分方程的振性与正解存在性

本文研究了一类中立型时滞差分方程的振动性和正解存在性，获得了该方程所有解振动的“Sharp”条件及存在正解的一个充分条件．     

D→Klv～l衰变过程的研究

用光锥QCD求和规则研究D→Klv～_l衰变过程，首先计算D→K跃迁形状因子，通过构造新的关联函数，消除了twist-3波函数的不确定性给计算结果所带来的影响，从而使计算结果更加精确. 计算得到的分支比与最近的实验数据相一致. 关键词： QCD光锥求和规则 D介子半轻衰变 分支比 形状因子     

具有突变结构开放腔的矩阵分析

利用模式展开与场匹配原理，建立了突变波导的散射矩阵(S参数矩阵)，在此基础上分析研究了具有突变结构的波导开放式谐振腔，并由矩阵级联建立了开放腔总的S参数矩阵.通过Matlab编制计算程序对具有多级突变结构的开放式输出腔进行了数值计算和分析，并通过与实验数据和软件模拟的结果比较对该方法得到的数据结果进行了验证. 关键词： 回旋管 开放式谐振腔 突变结构 S参数矩阵     

Highly soluble and optically transparent poly (ether imide)s based on 2,6‐ or 2,7‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride and aromatic bis(ether amine)s bearing trifluoromethyl groups

Two series of novel fluorinated poly(ether imide)s (coded IIIA and IIIB ) were prepared from 2,6‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride and 2,7‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride, respectively, with various trifluoromethyl‐substituted aromatic bis(ether amine)s by a standard two‐step process with thermal or chemical imidization of the poly(amic acid) precursors. These fluorinated poly(ether imide)s showed good solubility in many organic solvents and could be solution‐cast into transparent, flexible, and tough films. These films were nearly colorless, with an ultraviolet–visible absorption edge of 364–386 nm. They also showed good thermal stability with glass‐transition temperatures of 221–298 °C, 10% weight loss temperatures in excess of 489 °C, and char yields at 800 °C in nitrogen greater than 50%. The 2,7‐substituted IIIB series also showed better solubility and higher transparency than the isomeric 2,6‐substituted IIIA series. In comparison with nonfluorinated poly (ether imide)s, the fluorinated IIIA and IIIB series showed better solubility, higher transparency, and lower dielectric constants and water absorption. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 5909–5922, 2006