High-speed gradient parallel liquid chromatography/tandem mass spectrometry with fully automated sample preparation for bioanalysis: 30 seconds per sample from plasma

In this work, a high-throughput and high-performance bioanalytical system is described that is capable of extracting and analyzing 1152 plasma samples within 10 hours. A Zymark track robot system interfaced with a Tecan Genesis liquid handler was used for simultaneous solid-phase extraction of four 96-well plates in a fully automated fashion. The extracted plasma samples were injected onto four parallel monolithic columns for separation via a four-injector autosampler. The use of monolithic columns allowed for fast and well-resolved separations at a considerably higher flow rate without generating significant column backpressure. This resulted in a total chromatographic run cycle time of 2 min on each 4.6 x 100 mm column using gradient elution. The effluent from the four columns was directed to a triple quadrupole mass spectrometer equipped with an indexed four-probe electrospray ionization source (Micromass MUX interface). Hence, sample extraction, separation, and detection were all performed in a four-channel parallel format that resulted in an overall throughput of about 30 s per sample from plasma. The performance of this system was evaluated by extracting and by analyzing twelve 96-well plates (1152) of human plasma samples spiked with oxazepam at different concentrations. The relative standard deviation (RSD) of analyte sensitivity (slope of calibration curve) across the four channels and across the 12 plates was 5.2 and 6.8%, respectively. An average extraction recovery of 77.6% with a RSD of 7.7% and an average matrix effect of 0.95 with a RSD of 5.2% were achieved using these generic extraction and separation conditions. The good separation efficiency provided by this system allowed for rapid method development of an assay quantifying the drug candidate and its close structural analog metabolite. The method was cross-validated with a conventional liquid chromatography/tandem mass spectrometry (LC/MS/MS) assay.     

A Hybrid Ring‐Opening Metathesis Polymerization Catalyst Based on an Engineered Variant of the β‐Barrel Protein FhuA

A β‐barrel protein hybrid catalyst was prepared by covalently anchoring a Grubbs–Hoveyda type olefin metathesis catalyst at a single accessible cysteine amino acid in the barrel interior of a variant of β‐barrel transmembrane protein ferric hydroxamate uptake protein component A (FhuA). Activity of this hybrid catalyst type was demonstrated by ring‐opening metathesis polymerization of a 7‐oxanorbornene derivative in aqueous solution.     

Apparent hydrodynamic thickness of densely grafted polymer layers in a theta solvent

We study the drainage of a near-theta solvent through densely grafted polymer layers and compare to recent notions that these layers display little permeability to solvent flow at surface separations less than a “hydrodynamic thickness.” The solvent is trans-decalin (a near-theta solvent at the experimental temperature of 24°C). The polymer is polystyrene (PS) end-attached to two opposed mica surfaces via the selective adsorption of the polyvinylpyridine (PVP) block of a PS-PVP diblock copolymer. The experimental probe was a surface forces apparatus modified to apply small-amplitude oscillatory displacements in the normal direction. Out-of-phase responses reflected viscous flow of solvent alone—the PS chains did not appear to contribute to dissipation over the oscillation frequencies studied. The value of the hydrodynamic thickness (R_H) was less than the coil thickness (L_o) measured independently from the onset of surface–surface interactions in the force-distance profile, implying significant penetration of the velocity field into the polymer layer. As the surface–surface separation was reduced from 3L_o to 0.3L_o, the apparent hydrodynamic thickness (R) decreased monotonically to values R ≪ R_H. Physically, this indicates that the “slip plane” moved progressively closer to the solid surfaces with decreasing surface–surface separation. This was accompanied by augmentation of the effective viscosity by a factor of up to approximately 5, indicating somewhat diminished permeability of solvent through the overlapping polymer layers. Similar results hold for the flow through surface-anchored polymers in a good solvent. It is interesting to note the strong stretching of densely end-grafted polymers in a theta solvent. © 1997 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 35: 2961–2968, 1997     

The tautomerism of Omeprazole in solution: a 1H and 13C NMR study

The tautomerism of 5(6)-methoxy-2-([(4-methoxy-3,5-dimethyl-2-pyridinyl)methyl] sulfinyl)-1H-benzimidazole (omeprazole) was determined in solution, K(T) = 0.59 in THF at 195 K, in favor of the 6-methoxy tautomer. The assignment of the signals was made by comparison with its two N-methyl derivatives in acetone-d6 and through theoretical calculations of the absolute shieldings (GIAO/DFT/6-311++G**).     

UHV STM I(V) and XPS studies of aryl diazonium molecules assembled on Si(111)

Molecular layers formed from 4-trifluoromethylbenzenediazonium tetrafluoroborate and 4-Methylbenzenediazonium tetrafluoroborate have been assembled on H-passivated Si(111) and studied by UHV STM and XPS. STM imaging shows well-developed Si(111) step edges and terraces both on Si(111):H and Si(111) substrates covered with a molecular layer. STM I(V) data acquired at different tip-substrate separations reveals a factor of approximately 10 enhancement in current for positive bias voltage when current flows through the 4-trifluoromethyl molecule when compared to the 4-methyl variant. The observed current enhancement in I(V) can be understood by comparing the projected density of states of the two molecule-Si systems calculated using a density functional theory local density approximation after geometry optimization was performed via the conjugate gradient method. XPS data independently confirm that H-passivated Si(111) remains oxygen free for short exposures to ambient conditions and provide evidence that the molecules chemically react with the silicon surface.     

Characterization of ethyl chloroformate derivative of <Emphasis Type="Italic">β</Emphasis>-methylamino-<Emphasis Type="SmallCaps">l</Emphasis>-alanine

Beta-methylamino-L-alanine (BMAA) is a neurotoxic amino acid that can be produced by cyanobacteria in aqueous environments. To analyze this compound by gas chromatography/mass spectrometry (GC/MS), BMAA must be derivatized to a nonpolar, volatile compound. This can be accomplished by reacting BMAA with ethyl chloroformate. While carrying out electron ionization (EI) mass spectrometric analysis on the (13)C-labeled derivative, it was discovered that the formation of an ion with a peak at m/z 245.12 is the result of [CH(3)CH(2)O.] loss from the amino groups resulting from alpha-cleavage. This differs from previous reports that attributed this peak to alpha-cleavage of the carboxylic ester portion of the BMAA derivative. This finding is important for understanding BMAA derivative mass spectrometric fragmentation patterns and ultimately to properly identifying and quantifying BMAA. Fragmentation pathways for the formation of other major peaks observed in the EI mass spectra are also proposed.     

Noncovalent Bonds through Sigma and Pi-Hole Located on the Same Molecule. Guiding Principles and Comparisons

Over the last years, scientific interest in noncovalent interactions based on the presence of electron-depleted regions called σ-holes or π-holes has markedly accelerated. Their high directionality and strength, comparable to hydrogen bonds, has been documented in many fields of modern chemistry. The current review gathers and digests recent results concerning these bonds, with a focus on those systems where both σ and π-holes are present on the same molecule. The underlying principles guiding the bonding in both sorts of interactions are discussed, and the trends that emerge from recent work offer a guide as to how one might design systems that allow multiple noncovalent bonds to occur simultaneously, or that prefer one bond type over another.     

Chromatographic separation simulation of metal‐chelating peptides from surface plasmon resonance binding parameters

Some metal‐chelating peptides have antioxidant properties, with potential nutrition, health, and cosmetics applications. This study aimed to simulate their separation on immobilized metal ion affinity chromatography from their affinity constant for immobilized metal ion determined in surface plasmon resonance, both technics are based on peptide‐metal ion interactions. In our approach, first, the affinity constant of synthetic peptides was determined by surface plasmon resonance and used as input data to numerically simulate the chromatographic separation with a transport‐dispersive model based on Langmuir adsorption isotherm. Then, chromatographic separation was applied on the same peptides to determine their retention time and compare this experimental t_R with the simulated t_R obtained from simulation from surface plasmon resonance data. For the investigated peptides, the relative values of t_R were comparable. Hence, our study demonstrated the pertinence of such numerical simulation correlating immobilized metal ion affinity chromatography and surface plasmon resonance.     

Factors influencing proton positions in biomolecules

Results of quantum mechanical calculations are presented that suggest a number of mechanisms whereby protons may be shifted from one group to another along an H bond. The first factor to be considered is a stretching of the bond that drastically raises the energy barrier to transfer. It is possible to predict barriers for an arbitrary system based only on results for a simple system and knowledge of the relevant bond length in the isolated subsystems. Factors that increase the intrinsic basicity of the B group in A-H-B lead not only to a lowering of the energy of the A-HB state relative to AH-B but also to a reduction in the barrier to transfer of the proton from A to B. Ions in the vicinity of the H bond exert a powerful influence and can shift the proton to the less basic group across a gradient of several pK units. Rather than shielding the proton from the external ion, the H bond acts instead to amplify the effects of the electric field. Reorientation of the A and B groups relative to one another, i.e., bends of the H bond, also produce surprisingly large changes in the relative energies of the AH-B and A-HB states. Such bends are capable of pushing the proton across to the normally less basic group, providing a mechanism of coupling conformational changes to proton ‘pumping’ activity. It is found that the high and low pH states of a given H bond can have dramatically differnt relative populations of the AH-B and A-HB configurations. These observations are explained in terms of fundamental concepts involving electrostatic interaction energies.     

Determination of dissolved organic nitrogen in natural waters using high-temperature catalytic oxidation

Studies on nitrogen in natural waters have generally focussed on dissolved inorganic nitrogen (DIN), primarily because of relative ease of analysis and the important influence of DIN on water quality. Advances in analytical techniques now permit the systematic study of dissolved organic nitrogen (DON), and this work has shown that DON is quantitatively significant in many waters. This article describes the sampling and analytical protocols required for rapid, precise and reliable determinations of DON, involving high-temperature catalytic oxidation (HTCO), coupled to chemiluminescence detection. This approach simultaneously determines dissolved organic carbon (DOC) and total dissolved nitrogen (TDN), and DON is derived by subtraction of DIN measured by colorimetry. The DON determination is simple to perform, exhibits excellent precision (<1% for C and 1.5% for N) and is applicable to a wide range of natural waters.