Thermodynamics of complex formation in dimethyl sulfoxide with ligands coordinating via N,P, As,Sb, OR Bi : III. A comparison between aromatic and aliphatic amines and phosphines

The stabilities of the complexes formed by silver(I), cadmium(II) and zinc(II) with tri-n-butylamine and tri-n-butylphosphine have been determined in dimethyl sulfoxide (DMSO). For the two latter metal ions, it has also been found that complexes are not formed in appreciable amounts with the triphenyl compounds Ph₃X, X = N, P and, in the case of cadmium(II), also As.From these and earlier measurements referring to DMSO as well as aqueous solutions, it was found that the stepwise stability constants increase by roughly one power of ten for each aromatic ring replaced by an aliphatic group, evidently as a consequence of the improved donor properties of the coordinating atoms. Further, for ligands of the same type, the stabilities are always markedly lower in DMSO than in aqueous solution. This is certainly due to the fact that the solvent molecules compete more strongly for the coordination sites in DMSO than in water, as reflected by the larger heats of solvation found in the former solvent for the metal ions concerned.     

Electroosmosis through a Cation-Exchange Membrane: Effect of an ac Perturbation on the Electroosmotic Flow

Electroosmosis experiments through a cation-exchange membrane have been performed using NaCl solutions in different experimental situations. The influence of an alternating (ac) sinusoidal perturbation, of known angular frequency and small amplitude, superimposed to the usual applied continuous (dc) signal on the electroosmotic flow has been studied. The experimental results show that the presence of the ac perturbation affects the electroosmotic flow value, depending on the frequency of the ac signal and on the solution stirring conditions. In the frequency range studied, two regions have been observed where the electroosmotic flow reaches a maximum value: one at low frequencies (Hz); and another at frequencies of the order of kHz. These regions could be related to membrane relaxation phenomena.     

SCF and MC–SCF Study of CO2 with bond angle variation

Multiconfiguration (MC ) SCF calculations are reported for CO₂ for bond angles between 60° and 180°. The ground state configuration is found to be …?5a4b∣b∣a for small bending angles and …?6a3b∣b∣a for large bending angles, the change in ground state character occurring at a bond angle of about 100°. The force constant for bending obtained from the MC –SCF function is about 8.0% lower than the corresponding SCF value, and in considerably better agreement with experiment.     

Development of a CZE Method for the Determination of Olmesartan Medoxomil in Tablets

A CZE method was developed and validated for the analysis of Olmesartan medoxomil (OLMD) in tablets. The influences of pH, buffer concentration, applied voltage and capillary temperature on the migration time of OLMD were investigated. About 50 mM pH 6.5 phosphate buffer were used as background electrolyte. The optimum instrument parameters were found to be 30 °C temperature with 30 kV applied voltage and diode array detection was carried out at 210 nm. OLMD was hydrodynamically injected (P _inj  = 50 mbar, t _inj  = 3 s) and an internal standard, diflunisal (IS), was used to improve the precision and repeatability. Under these conditions, the migration time of OLMD was 2.32 min and the total analysis time was shorter than 5 min. Linearity range for the developed method was found to be 2.0–50.0 μg mL^?1 and the limit of detection was 0.5 μg mL^?1. The developed method was applied for the analysis of OLMD in pharmaceutical tablet formulations.     

Novel reaction systems for the synthesis of O-glucosides by enzymatic reverse hydrolysis

Our studies are presented to replace alcohols as solvents in reverse hydrolytic reactions catalyzed by immobilized β-glucosidase to synthesize O-substituted β-d-glucopyranosides in preparative-scale. We found that 1,2-diacetoxyethane is a suitable solvent and O-alkyl or aryl β-d-glucosides were synthesized in moderate yields (after isolation 12-19%). In these reactions proportion of glucose and glucosyl acceptor hydroxy compounds was 1:20. We suggest that 1,2-diacetoxyethane can be useful not only for alcohols but for other glucosyl donor compounds unsuitable for the role of solvent (e.g., phenols) in the synthesis of O-β-d-glucosides by reverse hydrolysis.     

Determination of Rosuvastatin in Pharmaceutical Formulations by Capillary Zone Electrophoresis

A capillary zone electrophoretic method with diode array detection was developed and validated for the determination of rosuvastatin calcium in pharmaceutical formulations. Using fused-silica capillary (i.d. 50.0 μm, total length 48.5 cm and effective length 40.0 cm), the influence of the buffer composition, buffer pH and buffer concentration, as well as organic modifier, applied voltage, capillary temperature and injection time were investigated to optimize the method. Optimum results were obtained with 50.0 mM borate buffer at pH 9.5, capillary temperature 30 °C and applied voltage 25 kV. The samples were injected hydrodynamically for 5 s at 50 mbar. Detection wavelength was set at 243 nm. Diflunisal was used as internal standard. The migration times of rosuvastatin calcium and diflunisal were 3.20 ± 0.01 and 4.20 ± 0.02. The total time of analysis was <6 min. The method was validated for rosuvastatin calcium determination in pharmaceutical formulations through following performance parameters: stability, linearity, sensitivity, precision, accuracy, recovery, selectivity, robustness and ruggedness. The linear calibration range was 3.00–200.00 μg mL^?1 and the limits of detection and quantification were 1.00 and 3.00 μg mL^?1 with RSD of 4.38 and 3.09%. The proposed method was applied for the determination of rosuvastatin calcium in its pharmaceutical formulation.     

Determination of uranium and thorium in Eskişehir-Beylikahir ore samples by delayed neutron counting technique

The Eskiehir-Beylikahir district has the largest and richest thorium and rare earth elements deposits in Turkey. The uranium and thorium concentrations of samples taken from four different parts of this area have been determined by the delayed neutron counting technique. The results are compared with those of previous analyses by other techniques and found to be in good agreement.     

Gas chromatographic method for the determination of N-acetyl-S-(N-methylcarbamoyl)cysteine, a metabolite of N,N-dimethylformamide and N-methylformamide, in human urine

A simple method has been developed for the determination of N-acetyl-S-(N-methylcarbamoyl)cysteine in human urine. Treatment of a urine sample (1 ml) with ethanol (2 ml) and potassium carbonate (1.5 g) produces ethyl N-methylcarbamate, which is extracted into ethanol and measured by packed column gas chromatography with nitrogen-sensitive detection. The limit of quantitation in human urine is 1 microgram/ml and the between-sample coefficient of variation is 5-11%. Simultaneously, N,N-dimethylformamide, N-methylformamide and formamide can also be determined.     

Sulfate Ions in Titania Polymorphs

Sol-gel titania was sulfated by using sulfuric acid as hydrolysis catalyst, or by impregnating with ammonium sulfate fresh samples prepared with nitric acid or ammonium hydroxide as hydrolysis catalyst. Samples were characterized with X-ray powder diffraction, infrared spectroscopy, thermogravimetry and atomic absorption spectroscopy. Sulfate ions were found anchored to brookite and anatase phases, because they have short O—O atomic bond lengths slightly larger than the largest O—O bond length of sulfate ion. Since the shortest O—O atomic bond in anatase is smaller than the one in brookite, the sulfate ions are then less deformed when they are anchored to anatase, and consequently more stable. Therefore when the sample temperature is raised, the brookite with sulfate ions was transformed mainly to anatase and not into rutile, which is the most probably transformation when these ions are not involved. Sulfate ions also hindered anatase and brookite crystallite growing and stabilized the crystalline structure of anatase. When the sulfate ions are lost the crystalline anatase phase is transformed into rutile, leaving a large number of vacancies that favored atom diffusion and consequently the growing of rutile crystallites. The crystalline evolution of the samples as a function of the annealing temperature is almost independent of the sulfating method.     

Calorimetric study of the glassy state XII. Plural glass-transition phenomena of ethanol

Ethanol was found to give a metastable crystalline phase (crystal-II) when the liquid was cooled at a moderate rate. Glassy states of liquid and of newly found crystal-II were obtained in the calorimeter cell by controlling the cooling rate of the liquid. The heat capacities of these phases as well as that of the stable crystal-I were measured by an adiabatic calorimeter in the temperature range between 14 and 300 K. The glass transition temperature T_g, the heat-capacity jump at T_g, and the residual entropy were found to be 97 K, 35.3 J K^?1 mol^?1, and 8.93 J K^?1 mol^?1 for the glassy liquid, and 97 K, 22.8 J K^?1 mol^?1, and 4.24 J K^?1 mol^?1 for the glassy crystal-II, respectively. The values for the residual entropy are referred to the third-law entropy for crystal-I.The heat capacities reported previously for the supercooled liquid by Gibson et al. and by Parks and Kelley agree well with those for the metastable crystal-II. Those of the supercooled liquid connect smoothly with those obtained for the liquid above the melting temperature. Thus, ethanol is found to be another example of a low-molecular-weight compound which shows multiple glass-transition phenomena.