The Tolerance of All-Optical Switching Based on Cascaded Second-Order Nonlinearity in PPLN APE Waveguide

Based on solving the couple mode equation numerically, the characterization of the signal power on the gate power was analyzed. And the relationship of the tolerance of the grating period and the bulk temperature on the interaction length was analyzed.     

FI代数的滤子

研究FI代数的滤子理论，建立F滤子、P滤子、Q滤子、C滤子之间的联系．     

Interior point cutting plane method for optimal power flow

In this paper, an interior point cutting plane method (IPCPM)is applied to solve optimal power flow (OPF) problems. Comparedwith the simplex cutting plane method (SCPM), the IPCPM is simpler,and efficient because of its polynomial-time characteristic.Issues in implementing IPCPM for OPF problems are addressed,including (1) how to generate cutting planes without using thesimplex tableau, (2) how to identify the basis variables inIPCPM, and (3) how to generate mixed integer cutting planes.The calculation speed of the proposed algorithm is further enhancedby utilizing the sparsity features of the OPF formulation. Numericalsimulations on IEEE 14-300-bus test systems have shown thatthe proposed method is effective.     

p型导电掺In的SnO_2薄膜的制备及表征

采用溶胶 凝胶提拉法成功地制备了p型导电掺In的SnO2 薄膜 .x射线衍射测试结果表明 ,掺In的SnO2 薄膜保持SnO2 的金红石结构 .吸收谱测试结果表明 ,掺In的SnO2 禁带宽度为 3 8eV .霍尔测量结果表明 ,空穴浓度与热处理温度有很大的关系 ,5 2 5℃为最佳热处理的温度 .铟锡原子比在 0 0 5— 0 2 0范围内 ,空穴的浓度与In的含量有直接的关系 ,并随In含量的增加而增加     

Extremal Convex Planar Sets

Each convex planar set K has a perimeter C, a minimum width E, an area A, and a diameter D. The set of points (E,C, A^1/2, D) corresponding to all such sets is shown to occupy a cone in the non-negative orthant of R⁴with its vertex at the origin. Its three-dimensional cross section S in the plane D = 1 is investigated. S lies in a rectangular parallelepiped in R³. Results of Lebesgue, Kubota, Fukasawa, Sholander, and Hemmi are used to determine some of the boundary surfaces of S, and new results are given for the other boundary surfaces. From knowledge of S, all inequalities among E, C ,A, and D can be found.     

Rugged distal tips for CO2 laser medicine

Low-loss and rugged distal tips for CO₂ laser have been proposed and fabricated based on a commercially available stainless steel (St) pipe. A method of smoothening the inner surface of the St pipe with a rough inner surface is put forward. Fabrication parameters, transmission properties, and mechanical strength of the cyclic olefin polymer-coated silver hollow St distal tip are experimentally discussed.     

稀土配合物Eu(asprin)_3phen发光特性的研究

将稀土配合物Eu(asprin)_3phen掺杂到导电聚合物PVK中,制成结构分别为ITO/PVK:RE配合物/LiF/AI(1),ITO/PVK:RE配合物/PBD/LiF/AI(2)的电致发光(EL)器件。发现二者的电致发光谱存在着较大的差别:在器件(1)中,来自Eu~(3 )的位于594nm(~5D_0→~7F_1)和614nm(~5D_0→~7F_2)处的发光强度大致相当,而在器件(2)中,EL主要来自Eu~(3 )位于614nm的发光,594nm处的发光很弱,与薄膜状态下的光致发光谱(PL)一致。并针对此现象进行了初步讨论。     

利用模式的对称性研究光子晶体光纤的色散

由光子晶体光纤的对称性可以得到模式分布的对称性，根据模式的对称性选择适当的展开函数，可以使计算量大大减少。计算了六角结构光子晶体光纤的色散特性，得到了波长在1．55pm处色散为零时，光子晶体光纤的结构参量所满足的方程。     

Phase formation and control of morphology in sputtered Cu-In alloy layers

The dependence of structural properties and surface morphology of Cu-In alloy layers on the composition and sputtering deposition sequence were investigated by X-ray diffraction, scanning electron microscopy and energy-dispersive X-ray spectroscopy. The properties of the co-sputtered alloy layers changed abruptly around the composition boundary when the Cu/In ratio reached 1/2. This can be explained by the effective heat of formation (EHF) model, which has been used to predict the sequence of phase formation for metal diffusion couples. The use of a co-sputtered alloy layer with a high In concentration was not suitable for fabricating solar cells, because the film had a very rough morphology due to large In islands formed on the CuIn₂ phase. However, it was possible to minimize this phase by In sputtering followed by co-sputtering with a Cu/In ratio of 1 (Cu-In/In/Glass). This permitted the fabrication of a homogeneous Cu-In alloy layer, which was not possible through the simple co-sputtering.     

Dynamical Convergence Trajectory in Networks

It is well known that topology and dynamics are two major aspects to determine the function of a network. We study one of the dynamic properties of a network： trajectory convergence, i.e. how a system converges to its steady state. Using numerical and analytical methods, we show that in a logical-like dynamical model, the occurrence of convergent trajectory in a network depends mainly on the type of the fixed point and the ratio between activation and inhibition links. We analytically proof that this property is induced by the competition between two types of state transition structures in phase space： tree-like transition structure and star-like transition structure. We show that the biological networks, such as the cell cycle network in budding yeast, prefers the tree-like transition structures and suggest that this type of convergence trajectories may be universal.