钕对番茄叶挥发性物质诱导效应的研究

以Nd3+诱导番茄叶,测定其对番茄叶挥发性物质组成和含量的影响。结果表明,番茄叶经60 mg.L-1Nd3+诱导120 h后,挥发性物质的总含量较对照组的增加57%;氧合脂类、萜类化合物、芳香族化合物的含量分别较对照组的提高73%,38%和32%。含量最高组分(E)-2-己烯醛较对照组的提高74%。含量显著性提高的组分还包括萜类化合物的β-水芹烯和α-石竹烯,芳香族化合物的丁子香酚,分别较对照组的提高129%,65%和309%。不同浓度的Nd3+均可促进挥发性物质的释放,且随诱导时间呈不同的变化趋势。一定浓度的Nd3+还可诱导番茄叶活性氧的释放以及几丁质酶和-β1,3-葡聚糖酶活力的提高。说明Nd3+可能通过提高番茄叶挥发性物质的含量,以增强其抗病能力。     

稀土添加剂对烃类水蒸汽重整镍催化剂性能的影响——水蒸汽吸附的TPD研究

用程序升温脱附技术,研究了添加稀土的烃类水蒸汽重整催化剂(Ni/α-Al_2O_3)对水蒸汽的吸附性能,同未加稀土的镍催化剂作了对比。结果表明,加有稀土的镍催化剂对水蒸汽的吸附能力主要是稀土的贡献。还原态催化剂对水蒸汽的吸附量比相应的氧化态多1.4倍。发现催化剂对水蒸汽的吸附能力不仅取决于浸渍方式,而且同稀土含量有关。当稀土含量较多时,催化剂表面上呈现出三个能量不同的吸附位。稀土含量少于1.3%时。对提高催化剂吸附水蒸汽的能力已作用不大。含稀土的镍催化剂吸附水蒸汽的能力大,正是其抗结炭性能耐硫性能好的原因。     

载波钝化和钼酸盐后处理对不锈钢钝化膜性能的影响

一般认为交流电对金属的腐蚀过程具有加速作用,但我们发现,在直流电位基础上叠加适当波形、幅值和频率的交流电对不锈钢进行载波钝化,尔后再进行适当后处理可使钝化膜的稳定性提高,我们曾就不经后处理的载波钝化过程进行过探讨,本文着重探讨钼酸盐后处理对载波钝化膜表面状态和化学稳定性改善的作用机理。     

稀土-香兰素缩赖氨酸希夫碱配合物的合成、表征及其与DNA作用的研究

合成了香兰素缩赖氨酸希夫碱配体(HL)和15种香兰素缩赖氨酸希夫碱的稀土配合物REL(NO3)2.3H2O(RE=Y,La,Ce,Pr,Nd,Sm,Eu,Gd,Tb,Dy,Ho,Er,Tm,Yb,Lu),并通过元素分析、摩尔电导、热重分析、红外光谱、紫外光谱、核磁共振方法对配合物的组成和结构进行了表征。采用紫外光谱和荧光光谱方法初步研究了Nd,Tb,Yb,Lu这4种希夫碱配合物与DNA的相互作用,实验结果显示,随着DNA的加入,配合物在280 nm处的紫外吸收峰不断增强,同时配合物在418 nm左右的荧光发射峰随DNA浓度的增大均逐渐减小,说明配合物和DNA是以静电模式结合。     

The Electrochemical Investigation of MEH-PPV in Ionic Liquid

Ionic liquids are a new kind of room-temperature molten organic salts. It can be used as solvents in the organic/polymeric syntheses, and some of them are called "green" solvents because of its recyclability1. Ionic liquids possess the superior properties, such as thermal stability up to 200(C, involatility and re-designability(for both cation and anion). The ionic liquid employed in this work is [bmim] [PF6]- ( butylmethylimidazolium hexafluorophosphate ) which is immiscible with water and h…     

Studies on the self-assembly behavior of the amphiphilic block copolymer of PSt-b-PAA in apolar solvents with polar fluorescent probe

The block copolymer of polystyrene-b-poly(butyl acrylate) (PSt-b-PBA) with a well-defined structure was synthesized by atom transfer radical polymerization (ATRP); its structure was characterized, and the living polymerization was also validated by gel permeation chromatography, Fourier transform infrared, and ¹H NMR measurements. Then, the amphiphilic block copolymer of polystyrene-b-poly(acrylic acid) (PSt-b-PAA) has been prepared by hydrolysis of PSt-b-PBA, and copolymers of PSt-b-PAA with longer PSt blocks and shorter PAA blocks were obtained by controlling the conditions of ATRP polymerization. The reversed micelle solution of PSt-b-PAA in toluene was prepared by using the single-solvent dissolving method, and the reverse micellization behavior of PSt-b-PAA in toluene was mainly investigated in this paper. The fluorescent probe technique was used by using polar fluorescence compound N-(1-Naphthyl)ethylenediamine dihydrochloride (NEAH) as a polar fluorescent probe to study the reverse micellization behavior of PSt-b-PAA. It was found that the reverse micellization behaviors of PSt-b-PAA in toluene can be clearly revealed by using NEAH as a polar fluorescence probe, and the critical micelle concentrations (cmcs) can be well displayed. The experimental results showed that the self-assembling behavior of PSt-b-PAA in toluene depends apparently on the microstructure of the macromolecules and is also influenced by the temperature. For the copolymers of PSt-b-PAA with the same length of hydrophobic PSt blocks, the copolymer with a longer hydrophilic block PAA has lower cmc, and at higher temperature, the copolymer has lower cmc.     

SYNTHESIS AND CHARACTERIZATION OF ORGANOMONTMORILLONITE AND POLYAMIDE 66/MONTMORILLONITE NANOCOMPOSITES

The montmorillonites (MMTs), layered, smectite-type silicates, were premodified by two different methods priorto the polymer melt intercalation. In one case MMTs were modified with cetyltrimethylammonium bromide (CTAB), andtermed as organomontmorillonites (OMMTs); in the other case MMTs were modified by nylon, and the products were calledmodified montmorillonites (MMMTs). The effects of CTAB and nylon on the MMTs were investigated by using TG andWAXD. The results show that interlayer spacings of CTAN and nylon modified MMTs are larger than that of sodium MMTs.Then, polyamide 66 (PA 66)/MMT nanocomposites were obtained through the method of melt intercalation of polymers. Thenanocomposites were characterized by WAXD, TEM and Molau experiments. The results indicate that the MMTs dispersehomogeneously in the PA 66 matrix. The mechanical properties of nanocomposites, such as tensile properties and flexuralproperties, were also measured and show a tendency to increase with increase of MMT content and reach the maximumvalues at 5phr MMT content. The heat distortion temperature (HDT) of the nanocomposites (7 phr) is about 32 K higher thanthat of pure PA 66.     

傅里叶变换技术在紫外可见光谱区的应用

本文评述了傅里叶变换在紫外可见光谱区的应用，探讨了傅里叶变换在紫外可见光谱学以及信号处理两方面的内容。详细介绍了傅里叶变换在紫外可见区遇到的问题、主要优点和发展前景。