Formation of Integral Asymmetric Membranes of AB Diblock and ABC Triblock Copolymers by Phase Inversion

The formation of integral asymmetric membranes from ABC triblock terpolymers by non‐solvent‐induced phase separation is shown. They are compared with the AB diblock copolymer precursors. Triblock terpolymers of polystyrene‐block‐poly(2‐vinylpyridine)‐block‐poly(ethylene oxide) (PS‐b‐P2VP‐b‐PEO) with two compositions are investigated. The third block supports the formation of a membrane in a case, where the corresponding diblock copolymer does not form a good membrane. In addition, the hydrophilicity is increased by the third block and due to the hydroxyl group the possibility of post‐functionalization is given. The morphologies are imaged by scanning electron microscopy. The influence of the PEO on the membrane properties is analyzed by water flux, retention, and dynamic contact angle measurements.

     

Determination of phenylglyoxylic acid in urine using a multi-pumping flow system

In this work a simple, fast and fully automated analytical methodology for the spectrophotometric determination of phenylglyoxylic acid is proposed. Phenylglyoxylic acid is a metabolite of styrene that is excreted in urine, being used as an indicator of styrene occupational exposure. The developed procedure was based on the phenylglyoxylic acid ability to inhibit the formation of the peroxovanadium cation produced by the reaction between vanadate and H₂O₂. The analytical process was implemented in a multi-pumping flow system that employs multiple solenoid actuated micro-pumps as the only active components. This enabled the reproducible insertion and efficient mixing of low volumes of sample and reagents as well as the transportation of the sample zone towards detection. Thus an easily controlled, low cost, compact and reliable analytical system was implemented. A linear working range for phenylglyoxylic acid concentrations up to 700?mg?L^?1 (r ^2?=?0.995, n?=?7), was obtained, with a detection limit of 37?mg?L^?1. The system handles about 43 determinations per hour yielding precise results (relative standard deviation?<?5%, n?=?10). The developed methodology was applied to the determination of phenylglyoxylic acid in urine samples and the obtained results were in agreement with those furnished by the comparison method with relative percentage deviations lower than 6.6%.     

Liquid chromatographic-tandem mass spectrometric assay for the simultaneous quantification of Camptosar and its metabolite SN-38 in mouse plasma and tissues

A simple, rapid and sensitive LC-MS/MS bioanalytical method has been developed to simultaneously quantify Camptosar (CPT-11) and its active metabolite, SN-38, in mouse plasma and tissues. A single step protein precipitation with acetonitrile in 96-well plates was used for sample preparation. Camptothecin (CPT) was used as the internal standard. Fast separation of SN-38, CPT-11 and CPT was carried out isocratically on a C18, 2 mm x 50 mm, 5 microm HPLC column with a mobile phase containing acetonitrile and 20 mM ammonium acetate (pH 3.5) and a 2.5 min chromatographic run time. The API 4000 MS/MS system was operated in positive ionization multiple reaction monitoring mode, and the transitions for SN-38, CPT-11 and CPT were 393.4 --> 349.3, 587.6 --> 167.2 and 349.3 --> 305.3, respectively. The SN-38 and CPT-11 concentrations in samples were calculated from a standard curve of peak area ratios of the analyte to that of the internal standard using a 1/chi2 weighted linear regression. The quantitation limit of 0.5 ng/mL was achieved by using a low sample volume (100 microL) of plasma or tissue homogenates. The assay was linear over the concentration range of 0.5-500 ng/mL with acceptable precision and accuracy. The method was used for the quantification of CPT-11 and SN-38 in plasma and tissues to support a preclinical pharmacokinetics and tissue distribution study of CPT-11 in mice.     

Thermophysical behaviour of monofunctional acrylate and liquid crystal systems

The phase behavior of monofunctional acrylate and low molecular weight nematic liquid crystals (LC) is considered. Systems involving the monomeric 2-ethylhexylacrylate (2-EHA), the eutectic LC mixture known as E7 and the 4-cyano-4^′-n-pentyl-biphenyl (5CB) are investigated. A similar investigation is performed on mixtures involving a polymer poly-2-EHA with molecular weight M_w=48,000 g/mol and both LCs. The experimental phase diagrams are established using polarized optical microscopy and analyzed using a theoretical formalism which combines the Flory-Huggins theory of isotropic mixing and the Maier-Saupe theory of nematic order. The results lead to characterization of the miscibility of E7 and 5CB with monomeric and analogous polymeric 2-EHA systems.     

Production of crosslinked,hollow nanoparticles by surface‐initiated living free‐radical polymerization

Surface‐initiated living free‐radical polymerization is employed in a multistep procedure to prepare hollow polymeric nanocapsules. Initially, trichlorosilyl‐substituted alkoxyamine initiating groups are attached to the surface silanol groups of silica nanoparticles. This surface layer of initiating groups is then used to grow functionalized linear chains leading to a core–shell morphology. The choice of functional groups is governed by their ability to undergo facile crosslinking reactions, with both active ester and benzocyclobutene groups being examined. Under either chemical or thermal conditions, the reaction of these functionalities gives a crosslinked polymeric shell that is covalently attached to, and surrounds, the central silica core. Removal of the silica core with HF then gives the hollow polymeric nanocapsules, which are stable under solvent dissolution and thermal treatment because of their crosslinked structure. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 1309–1320, 2002     

Influence of pH and Salt on the Photocrosslinking in Polyelectrolyte Thymine‐Containing Films

Photocrosslinking of thymine‐based water‐soluble polymer films was investigated at varying preparation conditions. Adding salt or decreasing the pH of the solution from which the films were cast resulted in the decreased efficiency of photoimmobilization, while increasing the pH was found to increase the photoimmobilization efficiency. A mechanistic rationale for the observed effects is proposed.     

Development of ferroelectric liquid crystals with low birefringence

We propose an approach for development of ferroelectric liquid crystals (FLC) with low birefringence Δn. Two basic principles have been used to get lowering of Δn: selection of molecules with short chains of conjugation as components for achiral matrix and averaging of local refractive indices by FLC helical structure. FLC mixtures with low birefringence (0.07 < Δn < 0.10 at wavelength 589.3 nm of sodium line) were elaborated and investigated. They consist of an achiral matrix including both nematic and smectic liquid crystal components and of phenylpyrimidine derivatives as chiral dopants. The materials developed can be used for all basic electro-optical FLC modes such as surface stabilised FLC (SSFLC), deformed helix ferroelectrics (DHF) and electrically suppressed helix (ESH). The mixtures developed allow to reduce the FLC cells chromatic retardance variation due to the weaker birefringence dispersion as compared with the known FLC materials to date.     

Isotopic Traceability (13C and 18O) of Greek Olive Oil

In recent years, isotopic analysis has been proven a valuable tool for the determination of the origin of various materials. In this article, we studied the ¹⁸O and ¹³C isotopic values of 210 olive oil samples that were originated from different regions in Greece in order to verify how these values are affected by the climate regime. We observed that the δ¹⁸O isotopic values range from 19.2 ‰ to 25.2 ‰ and the δ¹³C values range from −32.7 ‰ to −28.3 ‰. These differences between the olive oils’ isotopic values depended on the regional temperature, the meteoric water, and the distance from the sea. Furthermore, we studied the ¹³C isotopic values of biophenolic extracts, and we observed that they have same capability to differentiate the geographic origin. Finally, we compared the isotopic values of Greek olive oils with samples from Italy, and we concluded that there is a great dependence of oxygen isotopes on the climatic characteristics of the different geographical areas.     

Study of the complexation of fisetin with cyclodextrins

In this work, the interaction between fisetin (3,3',4',7-tetrahydroxyflavone) (Fis) and cyclodextrins (CDs) (alpha and beta) was studied through UV-vis absorption, steady-state fluorescence, induced circular dichroism, and (1)H NMR experiments with dependence on temperature and pH. Some experimental data were compared with quantum-mechanics studies based on the SAM1 (AMPAC) semiempirical model, as well as with the B3LYP and MPW1PW91 functional models from density functional theory using the 6-311G and 3-21G basis sets. The spectroscopic measurements show that Fis does not form stable complexes with alpha-CD. On the other hand, at pH 4.0 and 6.5, the complex Fis-beta-CD is formed in a Fis:beta-CD 1:1 stoichiometry and an equilibrium constant (K) of 900 +/- 100 M(-1). In basic medium (pH 11.5), K decreases to 240 +/- 90 M(-1) because Fis deprotonation leads to its better solubilization in water. Molecular modeling points out that Fis is not totally inserted into the inner cavity of beta-CD. The formation of the inclusion complex renders an environment that enhances intramolecular excited state proton transfer. The inclusion complex is formed preferentially via entry of the Fis phenyl group into beta-CD.