Electrophoresis of a sphere at an arbitrary position in a spherical cavity filled with Carreau fluid

Boundary effects on the electrophoretic behavior of a charged entity are of both fundamental and practical significance. Here, they are examined by considering the case where a sphere is at an arbitrary position in a spherical cavity under conditions of low surface potential and weak applied electrical field. Previous analyses are extended to the case of a non-Newtonian fluid, and a Carreau model is adopted for this purpose. The effects of key parameters such as the thickness of a double layer, the relative sizes of particle and cavity, the position of a particle, and the nature of a fluid on the electrophoretic mobility of a particle are discussed. Several interesting phenomena are observed. For example, if the applied electric field points toward north, the mobility of a particle has a local maximum when it is at the center of a cavity. However, if a particle is sufficiently close to the north pole of a cavity, its mobility exhibits a local minimum as its position varies. This does not occur when the particle is close to the south pole of the cavity; instead, it may move in the direction opposite to that of the applied electric field. For a Newtonian fluid, if a particle is close to the north pole of a cavity, its upward movement yields a clockwise (counterclockwise) vortex near the north pole of the cavity and a counterclockwise (clockwise) vortex near the south pole of the cavity on its right (left)-hand side. The latter is not observed for a Carreau fluid.     

Simultaneous screening and determination eight phthalates in plastic products for food use by sonication-assisted extraction/GC-MS methods

Studies on determination of eight kinds of phthalates, e.g. di-ethyl phthalate (DEP), di-propyl phthalate (DPP), di-isobutyl phthalate (DIBP), di-butyl phthalate (DBP), benzyl butyl phthalate (BBP), di-cyclohexyl phthalate (DCHP), di-(2-ethylhexyl) phthalate (DEHP), di-octyl phthalate (DOP), in 25 kinds of plastic products for food use, including packaging bags, packaging film, containers, boxes for microwave oven use, sucking tubes, spoons, cups, plates, etc. by gas chromatography in combination with mass spectrometry detector (GC-MS) in electronic ionisation mode (EI) with selected-ion monitoring (SIM) acquisition method (GC-MS (EI-SIM)) have been carried out. Methods have been developed for both qualitative and quantitative analysis of phthalates. Extraction, clean-up and analysis procedure have been optimized. Determination of samples were performed after frozen in liquid nitrogen and sonication-assisted extraction with hexane, clean-up with LC-C18 SPE and analyzed by GC-MS methods. The base peak (m/z = 149) of all the phthalates was selected for the screening studies. The characteristic ions, 121, 177, 222 for DEP; 191, 209 for DPP; 57, 223 for DIBP; 104 for DBP; 91, 132, 206 for BBP; 55, 167 for DCHP; 113, 167, 279 for DEHP; 279 for DOP were chosen for quantitative studies. These techniques are possible to detect phthalates at the level of 10.0 μg/kg. Overall recoveries were 82-106% with R.S.D. values at 3.8-10.2%. Only one of the 25 examined samples was free from phthalates. The rest 24 samples were found to contain at least three or more of these phthalates. The predominant phthalate detected in the studied samples was DEHP.     

Simultaneous determination of polycarboxylic acids by capillary electrophoresis with a copper electrode

The simultaneous determination of polycarboxylic acids including oxalic acid, citric acid, malonic acid, malic acid, tartaric acid, aspartic acid and glutamic acid was achieved by capillary electrophoresis with a copper disk electrode (d = 200 microm). In the system. 0.2 mmol/l cetylpridinium bromide (CPB) was used as an electroosmotic flow (EOF) modifier to reverse the direction of EOF. The effects of the solution pH and CPB concentration on separation were evaluated to achieve the optimum separation conditions. At the working potential of +0.14 V (vs. saturated calomel electrode), the calibration curves for all polycarboxylic acids studied were linear with 2 approximately 3-orders of magnitude and all the detection limits (S/N = 3) were below 15 fmol except malonic acid. Furthermore, the oxalic and citric acids in urine were successfully separated and determined with high sensitivity.     

Solid-contact potentiometric sensor for ascorbic acid based on cobalt phthalocyanine nanoparticles as ionophore

A novel solid-contact potentiometric sensor for ascorbic acid based on cobalt phthalocyanine nanoparticles (NanoCoPc) as ionophore was fabricated without any need of auxiliary materials (such as membrane matrix, plasticizer, and other additives). The electrode was prepared by simple drop-coating NanoCoPc colloid on the surface of a glassy carbon electrode. A smooth, bright and blue thin film was strongly attached on the surface of the glassy carbon electrode. The electrode showed high selectivity for ascorbic acid, as compared with many common anions. The influences of the amount of NanoCoPc at the electrode surface and pH on the response characteristics of the electrode were investigated. To overcome the instability of the formal potential of the coated wire electrode, a novel electrochemical pretreatment method was proposed for the potentiometric sensor based on redox mechanism. This resulting sensor demonstrates potentiometric response over a wide linear range of ascorbic acid concentration (5.5 × 10⁻⁷ to 5.5 × 10⁻² M) with a fast response (<15 s), lower detection limit (ca. 1.0 × 10⁻⁷ M), and a long-term stability. Furthermore, microsensors based on different conductors (carbon fiber and Cu wire) were also successfully fabricated for the determination of practical samples.     

Voltammetric determination of mifepristone at a DNA-modified carbon paste electrode

A new strategy for the preparation of a DNA-modified carbon paste electrode is developed. It is found that the anodic response of mifepristone is greatly enhanced at the dsDNA-modified carbon paste electrode comparing with that obtained at the bare electrode, while the response at a ssDNA-modified electrode is similar to bare electrode. So the dsDNA-modified electrode is employed as a sensitive biosensor for the detection of mifepristone. A linear dependence of the peak currents on the concentration is observed in the range 2.0 x 10(-7) approximately 2.0 x 10(6) mol/L, with a detection limit of 1.0 x 10(-7) mol/L. The relative standard deviation is 4.3% for six successive determinations of 1.0 x 10(6) mol/L mifepristone. The determination of mifepristone tablets is carried out and satisfactory results are obtained.     

A new fabrication process for a microchip electrophoresis device integrated with a three-electrode electrochemical detector

We report here a novel and simple process for the fabrication of a poly(methyl methacrylate) (PMMA)-based microchip electrophoresis device, integrated with a screen-printed three-electrode electrochemical detector that does not require a replicate mold. In this approach, a photoresist layer constitutes both an adhesion layer and side walls of 50 mum wide and 50 mum tall microfluidic channels on a screen-printed three-electrode PMMA substrate. Openings were drilled for buffer reservoirs on an additional piece of PMMA, then the final device was bonded in a PMMA/photoresist/PMMA sandwich configuration. This process is inexpensive, less time-consuming, and simpler compared with traditional fabrication methods. The combination of this PMMA-based microchip fabrication together with screen-printed electrode technology holds great promise for the mass production of a single-use micrototal analytical system. Successful determination of uric acid and L-ascorbic acid with the presented system validates its utility. In combination with a suitable electrochemical detector, this device holds much promise for the determination of other analytes in various biological samples for medical and clinical diagnosis.     

Self-assembled metallocycles with two interactive binding domains

Five metallocycles 1 a-e have been self-assembled from S-shaped bispyridyl ligands 2 a-e and a palladium complex, [Pd(dppp)(OTf)(2)] (dppp=1,3-bis(diphenylphosphanyl)propane), and have been characterized by elemental analysis and various spectroscopic methods including (1)H NMR spectroscopy and electrospray ionization (ESI) mass spectrometry. These metallocycles all are monocyclic compounds, but can fold to generate two binding domains bearing hydrogen-bonding sites based on pyridine-2,6-dicarboxamide units. The binding properties of the metallocycles with N,N,N',N'-tetramethylterephthalamide (G) have been probed by means of ESI mass spectrometry and (1)H NMR spectroscopy. The results both in the gas phase and in solution are consistent with the fact that the metallocycles accommodate two molecules of the guest G. Thus, the ESI mass spectra clearly show fragments corresponding to the 1:2 complexes in all cases. (1)H NMR studies on 1 a and G support the formation of a 1:2 complex in solution; the titration curves are nicely fitted to a 1:2 binding isotherm, but not to a 1:1 binding isotherm. In addition, a Job plot also suggests a 1:2 binding mode between 1 a and G, showing maximum complexation at approximately 0.33 mol fraction of the metallocycle 1 a in CDCl(3). The binding constants K(1) and K(2) are calculated to be 1600 and 1400 M(-1) (+/-10 %), respectively, at 25 degrees C in CDCl(3), indicative of positively cooperative binding. This positive cooperativity was confirmed by the Hill equation, affording a Hill coefficient of n = 1.6. Owing to insufficient solubility in CDCl(3), for comparison purposes the binding properties of the metallocycles 1 b-e were investigated in a more polar medium, 3 % CD(3)CN/CDCl(3). (1)H NMR titrations revealed that the metallocycles all bind two molecules of the guest G with Hill coefficients ranging from 1.4 to 1.8. This positive cooperativity may be attributed to a structural reorganization of the second binding cavity when the first guest binds to either one of the subcavities present in the metallocycles.     

Novel syntheses of enantiopure hexahydroimidazo[1,5-b]isoquinolines and tetrahydroimidazo[1,5-b]isoquinolin-1(5H)-ones via iminium cation cyclizations

Condensations of chiral diamines 11a-c with benzotriazole and formaldehyde gave benzotriazolyl intermediates 12a-c; similar condensations of alpha-amino-amides 10a-c with benzotriazole and paraformaldehyde gave 14a-c. Subsequent treatment of 12a-c and 14a-c with AlCl(3) led to enantiopure tricyclic 1,2,3,5,10,10a-hexahydroimidazo[1,5-b]isoquinolines 1a-c and 2,3,10,10a-tetrahydroimidazo[1,5-b]isoquinolin-1(5H)-ones 15a-c, respectively, via Lewis acid promoted iminium cation cyclizations.     

Porous nanocomposites of zirconium dioxide and silicate

Highly porous nanocomposites of zirconium dioxide and silicate are synthesised in an aqueous system from an inorganic salt of zirconium; the nanacomposites, with tailorable pore structures, exhibit superior performance as catalyst supports.